Window FIAT DOBLO 2008 1.G User Guide

65GETTING TO KNOW YOUR VEHICLE
POSITIONS fig. 84
0- windscreen wiper off;
1- flick wipe; in some versions, four
selections are possible (from slow to
fast fig. 85);
2- slow flick;
3- fast continuous wipe
4- Temporary position: when re-
leased the stalk returns to 0and au-
tomatically switches off the wind-
screen wiper.SMART WASH for rear
window wiper fig. 86
Pull the stalk towards the steering
wheel to send a jet of fluid to the
windscreen and operate the wiper
with a simple gesture. The windscreen
wiper will be operated automatically
by holding the washer stalk for longer
than half a second.
The windscreen wiper will flick three
times after the lever is released.
Operate the control repeatedly and
rapidly (for less than half a second) to
spray the windscreen several times
without operating the windscreen
wiper.
fig. 85
F0A0188b
fig. 86
F0A0055b
Rear window washer/wiper
(with glazed rear
doors/tailgate) fig. 87-88
The device will only work when the
ignition key is at MAR.
To operate the rear window wipe:
turn the ring from åto '.
To wash the window push the stalk
towards the dashboard.
SMART WASH for windscreen
wiper fig. 88
Pull the stalk towards the steering
wheel to send a jet of fluid to the rear
window and operate the wiper with
a simple gesture. The rear window
wiper will be operated automatically
by holding the washer stalk for longer
than half a second.
fig. 87
F0A0054b
001-105 Doblo GB 16-12-2008 14:22 Pagina 65

66GETTING TO KNOW YOUR VEHICLE
The rear window wiper will flick
three times after the lever is released.
“FOLLOW ME HOME”
function
This function allows the illumination
of the space in front of the vehicle.
Turning the function on
With the ignition key at STOP or
removed, pull the left-hand stalk to-
wards the steering wheel and operate
it within 2 minutes from when the en-
gine is turned off.
At each single movement of the stalk,
the staying on of the lights is extend-
ed by 30 seconds up to a maximumCEILING LIGHT
WITH MAP READING
LIGHTS
Press switch A-fig. 90to switch the
lights on and off.
Switch Boperates the map-reading
light.
According to the position, you can
have the following conditions:
– switch Apressed at the centre,
ceiling lights Cand Dwill come on re-
gardless of the position of the doors;
– switch Apressed to the left, ceil-
ing lights Cand Dwill stay off re-
gardless of the position of the doors;
',
fig. 88
F0A0189b
C
B
D
A
fig. 90
F0A0056b
6y1∆
fig. 89
F0A0208b
of 210 seconds; then the lights are
switched off automatically.
Each time the lever is operated, the
warning light 3on the instrument
cluster will come on and the display
will show the time of activation.
The warning light comes on the first
time the lever is operated and will stay
on up to automatic function deactiva-
tion. Each operation of the lever will
extend lights switching on time.
Turning the function off
Keep the stalk pulled towards the
steering wheel for more than 2 sec-
onds.
001-105 Doblo GB 16-12-2008 14:22 Pagina 66

68GETTING TO KNOW YOUR VEHICLE
CONTROLS
HAZARD LIGHTS fig. 92
They turn on by pressing switch A,
regardless of the position of the igni-
tion key.
When the lights are on, the switch
and the instrument panel warning light
FDor Rand Ewill flash.
Press the switch again to turn the
lights off.CONTROL BUTTONS fig. 93
The buttons are located between
the central air vents.
The controls can only be operated
when the ignition key is at MAR.
A- Front foglight button.
B- Rear foglight button.
C- Heated rear window on/off but-
ton. IMPORTANTThe dipped beam
headlights will automatically be
switched off when the main beam
headlights are switched on if the front
fog lights are on.
The dipped beam headlights and/or
the front foglights (if fitted) must be on
to switch rear foglights on.
The rear fog lights are switched off
either by pressing C or switching on
the main beam headlights or turning
the ignition key to STOP. You will
need to switch the rear foglights back
on, if required, when the dipped beam
headlights and/or front foglights are
switched on or when the engine is
started again.
A
fig. 92
F0A0057b
The use of hazard lights
is governed by the High-
way Code of the country
you are in. Keep to the rules.
BA
fig. 93
F0A0509b
001-105 Doblo GB 16-12-2008 14:22 Pagina 68

72GETTING TO KNOW YOUR VEHICLE
REAR SIDE WINDOWS
The windows open outwards.
1)Move the lever as shown in fig.
103.
2)Push the lever outwards to open
the window completely.
3)Push the lever back until it clicks.
To close the windows, pull the lever
the opposite direction until it clicks.WING WINDOW
IMPORTANTOpen and close the
wing window only when the vehicle
is stationary.
The Fiat Doblò may fit a handy wing
window on the roof on the back of the
load compartment to carry long ob-
jects.
Opening the wing window
To open the wing window, pull lever
A-fig. 104downwards in the direc-
tion of the arrow.
Put your hand in handle B-fig. 105
and lead the wing window while it
opens.
fig. 103
F0A0067b
A
fig. 104
F0A0069b
fig. 102
F0A0408b
SIDE SLIDING WINDOW
(longitudinal sliding)
The windows slide open.
1)Keep pressed button A-fig. 102
to release the sliding window.
2)Push the window in the direction
of the arrow (1), to open as required.
3)To close, pull the sliding window
in the direction of the arrow (2) until
you hear it click.
001-105 Doblo GB 16-12-2008 14:22 Pagina 72

73GETTING TO KNOW YOUR VEHICLE
Closing the wing window
Take the mobile crossmember C-
fig. 106back to its original position;
fit the crossmember pin Cin the orig-
inal housing until it clicks.
Pull the wing window in the direction
shown in fig. 105, fitting your hand
in handle B. The wing window is
closed once it clicks.
DC
fig. 106
F0A0071b
Moving the vehicle when
the crossmember is not
fastened in its housing can
cause severe damage to the load
compartment structure. Fur-
thermore, only the bottom of the
rear doors would be locked and
this could damage the hinges.
IMPORTANTArrange the load
evenly along the crossmember and fas-
ten it with ropes or similar.
IMPORTANTNever leave the
crossmember unfastened while the ve-
hicle is moving.
B
fig. 105
F0A0070b
Do not exceed 110 km/h
speed with wing window
open. Risk of (violent)
wing window closing.
The mobile crossmember C-fig. 106
can be tipped down to facilitate load-
ing and unloading long objects.
To tip, hold the crossmember with
your left-hand and move the lever D
with your right-hand in the direction of
the arrow until it clicks.
Lower the crossmember carefully
until it reaches its position. Unload the
vehicle and take the crossmember
back to its original position.
001-105 Doblo GB 16-12-2008 14:22 Pagina 73

74GETTING TO KNOW YOUR VEHICLE
These operations are allowed for
two minutes after turning the ignition
key from MARto STOPor removed
only if the doors are closed.
AB
fig. 109
F0A0074b
fig. 109a
F0A0510b
Closing by hand from the inside
Front doors: close the door and
press the lever as shown in fig. 108
(LOCK).
ELECTRIC WINDOWS
According to versions, power win-
dow controls can be set on the dash-
board (in central position) fig. 109, or
on driver and passenger door panels
fig. 109a. They only work with igni-
tion key at MAR.
A- to open/close the front left-hand
window;
B- to open/close the front right-
hand window.
fig. 108
F0A0514b
DOORS
FRONT DOORS
Opening by hand from
the outside
Front doors: turn the key to 2-fig.
107and pull the handle.
Locking by hand from
the outside
Front doors: close the door and turn
the key to 1-fig. 107.
Opening by hand from
the inside
Front doors: pull the lever.
2
1
fig. 107
F0A0072b
001-105 Doblo GB 16-12-2008 14:22 Pagina 74

75GETTING TO KNOW YOUR VEHICLE
Check that it is safe to
open a door before doing
so.
Make sure that the left-
hand sliding side door is
completely closed before
refuelling (see “At the filling sta-
tion” in this chapter). You could
damage the door and the sliding
lock system which comes into
play when the fuel flap is open.
You cannot open the
left-hand sliding side door
while refuelling when the
flap is open (see “At the filling
station” in this chapter).
SIDE DOORSIn Doblò Cargo versions, the side
sliding door is fitted with a catch which
stops it when it is fully open: to release
the catch, simply push the door against
the catch and pull it forwards force-
fully.
In any case, always make sure that
the door is correctly fastened in the
door open catch.
Do not leave the vehicle
parked on a steep slope
with the sliding door
open. An involuntary knock could
release the door and make it
slide.
When leaving the vehi-
cle parked with the sliding
doors open, always check
that the door hooks are properly
fastened into the retaining device
to ensure it remains fully open.
Improper use of the
electric windows can be
dangerous. Before and
during their operation ensure
that any passengers are not at
risk from the moving glass either
by personal objects getting
caught in the mechanism or by
being injured by it directly. Al-
ways remove the ignition key
when you get out of the vehicle
to prevent the electric windows
being operated accidentally and
constituting a danger to the peo-
ple left in the vehicle.
On driver’s side there is a button A-
fig. 109for automatic operation.
Press the button for longer than one
second: the window will stop when it
reaches the end of its travel (or until
the button is pressed again).
001-105 Doblo GB 16-12-2008 14:22 Pagina 75

81GETTING TO KNOW YOUR VEHICLE
fig. 121
F0A0256b
fig. 122
F0A0255b
A
fig. 123
F0A0093b
Tipping part of the left seat
To tip the left-hand side of the seat
back:
– remove the head restraint (if pro-
vided);
– lift knob A-fig. 121then tip the en-
tire seat fig. 122.
Refit head restraints back into the
seats A-fig. 123.To remove the rear window
shelf
The shelf is split into to parts
fig. 124. Proceed as follows to re-
move the entire shelf:
1)Open the rear doors or the tail-
gate.
fig. 124
F0A0430b
C
A
fig. 125
F0A0087b
2)Lift part A-fig. 124of the shelf
and place it on part B.
3)Fasten the two parts by means of
rubber fasteners C-fig. 125.
001-105 Doblo GB 16-12-2008 14:22 Pagina 81

82GETTING TO KNOW YOUR VEHICLE
fig. 127
F0A0433b
7-seat versions
To extend the boot, proceed as fol-
lows:
– remove head restraints;
– release the right locking lever B-
fig. 127moving it to 1(“released
lever”); do the same on the left side
then lower the seat back and tip the
seat forward. This operation is made
friendly by two springs. Make sure the
seat is completely tipped.
– refit head restraints back into the
seats C-fig. 128.
B
fig. 126
F0A0088b
4)Lift part B-fig. 126making the
shelf slide along the available space be-
hind the seat so that the upper part is
fastened to the rear window shelf and
the lower central part to the seat.
If the seat is down, proceed as fol-
lows:
5)Remove the shelf and arrange it
crosswise between the front seat
backs and the tipped seat on the rear
seat.
To refit the shelf, refit central catch-
es D-fig. 124and tip first part Band
then part A, make sure shelves are
properly secured.IMPORTANTCheck and adjust
the height of the dipped headlight
beam when travelling at night with a
rather heavy load in the boot (see
“Headlights” in this section).
To take the seat back to normal po-
sition:
1)Check that the seat belt webbing
is correctly fitted in its bracket.
2)Take the cushion to its horizontal
position and check that it is correctly
fastened.
3)Tip the seat back backwards and
check that it is correctly fastened.
001-105 Doblo GB 16-12-2008 14:22 Pagina 82

98GETTING TO KNOW YOUR VEHICLE
43 21
10987 65
fig. 146
F0A0099b
fig. 145
F0A0096B
CELLULAR PHONE
SET-UP
The system set-up consists of:
– a dual-purpose aerial (sound sys-
tem + cellular phone), on the vehicle
roof;
– a dual-purpose aerial connection
wires and ten-pin connector wiring
fig. 146.
– a double coil speaker (sound sys-
tem + cellular telephone), located on
the passenger side dashboard. HEAVY PRESETTING
The system consists of the following:
– sound system power wires;
– wires for front speakers on the
dashboard;
– 2 speakers on the dashboard;
– wires for door speakers (where
provided);
– 2 door speakers;
– 2 rear speakers (for passengers
transport versions);
– wires for rear speakers;
– sound system compartment;
– aerial wire and aerial.Speakers
– two mid-range speakers on dash-
board, diameter 100 mm, power 30W
max each.
– two woofer speakers on front
doors, diameter 165 mm, power 40W
max each (Panorama versions only).
– two full-range elliptic speakers on
rear window shelf, 95 x 154 mm, pow-
er 20W max each (Panorama versions
only).
Sound system installation
To fit the sound system, remove the
oddment compartment shown in fig.
145. To remove the compartment,
press it upwards and then pull it out
towards the inside of the vehicle.
fig. 144
F0A0162B
001-105 Doblo GB 16-12-2008 14:22 Pagina 98