sensor FIAT DOBLO 2009 2.G User Guide
[x] Cancel search | Manufacturer: FIAT, Model Year: 2009, Model line: DOBLO, Model: FIAT DOBLO 2009 2.GPages: 274, PDF Size: 6.6 MB
Page 189 of 274

188
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXRECHARGING THE BATTERY
IMPORTANT The battery recharging procedure is pro-
vided for information purposes only. You are recom-
mended to go to a Fiat Dealership to have this operation
performed.
We recommend recharging the battery slowly for ap-
proximately 24 hours at low amperage. A prolonged
recharge might damage the battery.
Charge the battery as follows:
WITHOUT START&STOP SYSTEM
❒disconnect battery negative terminal;
❒connect the charger cables to the battery terminals,
observing the polarity;
❒turn on the charger;
❒when you have finished, turn the charger off before
disconnecting it from the battery;
❒reconnect negative battery terminal.
Battery fluid is poisonous and corrosive:
avoid contact with your skin and eyes. The
battery recharging operation must be performed
in a ventilated place, away from naked flames or
possible sources of sparks to avoid the risk of ex-
plosion and fire.
WARNING
F0V0209mfig. 177b
WITH START&STOP SYSTEM
(fig. 177b)
❒disconnect the quick release negative terminal A from
the dummy negative terminal B; this is because a bat-
tery status monitoring sensor D is fitted on the nega-
tive battery terminal C and should never be disconnected
except for when the battery is actually replaced;
❒connect the positive cable of the charger to the posi-
tive pole of the battery and the negative cable to the
dummy negative terminal B;
❒turn on the charger;
❒when you have recharged, turn the charger off before
disconnecting it from the battery;
❒after disconnecting the charger, reconnect the quick
release negative A to the dummy terminal B.
Page 268 of 274

267
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Keys ............................................ 5
– key with remote
control ................................. 6
– key without remote
control ....................................6
– remote locking/
unlocking........................... 5-6
– replacing remote
control battery.................... 7
– requesting additional
remote control keys ......... 8
Know your vehicle ................. 3
Ladder bulkhead behind
driver...................................... 36
Lifting the vehicle
– with the jack ................... 158
– with the lift arms ........... 189
– with the workshop
lift ...................................... 189
Lights (controls
to switch on) ....................... 59Liquids
(specifications)...........247-248
Load limiters ........................ 118
Lubricants
(specifications)...........247-248
Main beam headlights
– bulb replacement ........... 174
– flashing ............................... 59
– switching on ...................... 59
Manual climate control ........ 47
Mirrors
– exterior ............................. 40
– rear-view mirror ............. 40
MSR (system) ...................... 100
Multifunction display............. 19
– control buttons................. 19
– setup menu ........................ 20
– standard screen................. 19Nozzles
– windscreen/rear window/
headlamp washer ........... 213
Number plate lights
– bulb replacement ........... 177
Odometer.........................14-19
On-board computer
(trip)....................................... 28
On-board instruments
(panel) ................................... 12
Paintwork (maintenance) ... 214
– bodywork colour
plate ................................. 220
ParafluUP
– checking levels and
topping up ....................... 202
– specifications .................. 248
Parking sensors ................... 103
Particulate filter (DPF)........ 114
Partitions.................................. 36