remove seats FIAT DUCATO 244 2005 3.G Owners Manual

20GETTING TO KNOW YOUR VEHICLE
fig. 18
F0D0003m
The webbing must not be
twisted. The upper section
must pass across the shoulder and
chest diagonally. The lower section
must fit closely across the passen-
ger’s hips and not the abdomen (fig.
18). Do not use clips, fasteners, etc.
to prevent the belt adhering to the
passenger’s body.
WARNING
Under no circumstances
should the components of
seat belts and pretensioners be
tampered with or removed. Any in-
terventions should be carried out by
qualified and authorised personnel.
Always contact a Fiat Dealership.
WARNINGGENERAL INSTRUCTIONS
FOR THE USE OF THE SEAT
BELTS
The driver is responsible for re-
specting and enforcing the local rules
and laws regarding the use of seat
belts.
Always fasten the seat belts before
starting.
For maximum safety, keep
the back of your seat up-
right, lean back into it and make
sure the seat belt fits closely across
your chest and hips. Always fasten
seat belts, in front and rear seats!
Travelling without seat belts in-
creases the risk of severe and fatal
injury in the event of a crash.
WARNING

140IN AN EMERGENCY
The moving parts of the jack (screw
and joints) may also cause injury if
touched. Clean off any grease.
6)Unscrew the five bolts complete-
ly using wrench E-fig. 6and remove
the wheel.7) Fit the spare wheel making sure
that the pegs Hfit into holes G-fig. 7.
When fitting the spare wheel, make
sure the hub is clean so that the fix-
ing bolts will not loosen.
8)Tighten the five wheel bolts.
9) Lower the vehicle with the ratch-
et wrench and pull the jack out.
10)Fasten bolts completely, work-
ing in a criss-cross fashion as shown in
fig. 7.
fig. 6
F0D0090m
fig. 7
F0D0089m
When you have finished:
– place the wheel you have changed
in the spare wheel support;
– hook the spare wheel support, us-
ing wrench E;
– screw the two fastening bolts and
position the two plastic caps;
– put the jack and the tools back in
the bag under one of the two seats in
the cab.

184VEHICLE MAINTENANCE
INTERIORS
From time to time check that water
has not collected under the mats
(from dripping shoes, umbrellas, etc.)
which could cause the steel to rust.
CLEANING SEATS
AND FABRICS
Remove dust with a soft brush and
vacuum cleaner. For velvet seats use
a damp brush.
Brush the seats with a damp sponge
with water and neutral soap.PLASTIC PARTS INSIDE
THE VEHICLE
Clean plastic parts with damp cloth
with water and non-abrasive neutral
soap. To remove grease or hard
stains, use special solvent-free prod-
ucts designed not to alter the appear-
ance and colour of components.
IMPORTANTDo not use alcohol
or petrol to clean the instrument
panel.
Never use flammable prod-
ucts (petroleum ether or
petrol) to clean the inside of the ve-
hicle. Electrostatic charges gener-
ated by rubbing while cleaning
could cause fires.
WARNING
Do not keep aerosol cans in
the vehicle. There is the risk
they might explode. Aerosol cans
must never be exposed to a tem-
perature above 50°C; when the
weather starts to get hot the tem-
perature inside the vehicle might go
well beyond that figure.
WARNING