USB FIAT GRANDE PUNTO 2007 199 / 1.G Blue And Me Owner's Guide

9696
Problem Probable Cause Possible Solution
The same USB memory device
previously connected takes
more than 10 seconds to restart
playback on Blue&Me™ Nav
To reset the USB memory device using
Microsoft®Windows®XP, click on My
Computer in the Startmenu, click
rightwards on the USB memory device,
select Properties, select Tools, click
on key
“Check Now...” in field
“Error-checking”,select “Automatically fix
file system errors” and then click Start.
To avoid future problems, remove the
USB device using the option “Secure
hardware removal”. You removed the USB memory device
from the PC before it was ready
603_83_390 Punto C3 GB 19-06-2007 11:21 Pagina 96

97
❒No USB device is connected
❒The USB device connected does not
contain map data
❒The USB device is faulty or connected
incorrectly
❒GPS signal reception could be hin-
dered if the car is located beneath
trees, among tall buildings, in covered
car parks or in tunnels.
❒The battery has been disconnected
(e.g. during servicing).
❒A system fault may have occurred or
the GPS aerial may have been discon-
nected.
❒Insert the USB connecting the
Blue&Me™ Navmaps in the USB
port.
❒Check that the USB device in use the
same one received in the
Blue&Me™ Navnavigation set or
check that the maps for
Blue&Me™ Navare loaded on the
USB device.
❒Check the USB device is properly
connected.
❒Check that the USB device used is
the same one included in the
Blue&Me™ Navnavigation set.
❒Try to load the map data onto a new
USB device using the Blue&Me™
Nav Map Assistantsoftware on
the map CD-ROM (see the
Blue&Me™ NavMap Assistant
quick guide in the Blue&Me™ Nav
navigation set).
❒Move the car to an open area where
the GPS signal reception is good, or
wait until the obstacle has passed if
the vehicle is moving.
❒Wait at least 15 minutes to allow the
system to calculate the correct GPS
position again.
❒Consult a Fiat dealer. NAVIGATION SYSTEM
Problem Probable Cause Possible Solution
The display indicates:
INSERT USB MEMORY
WITH MAPS
The display indicates:
WAIT… NO GPS SIGNAL
603_83_390 Punto C3 GB 19-06-2007 11:21 Pagina 97

98
The car is located in a country or region
whose maps are not present on the USB
device and the destination entered is not
therefore available.
❒The mobile phone registered is off.
❒Your Bluetooth®mobile phone is not
registered
❒The registered mobile phone is not
within the system’s radius of action (it
must be located within 10 metres of
the system).
❒The Bluetooth®connection between
the system and mobile phone has been
disabled on your mobile phone
(“Blue&Me” identifier).
❒The telephone number of the selected
point of interest is not available on the
map.
Incorrect selection of the deletion
functionEnsure that the preloaded map software
contains all the countries or regions required
to define the required route (from the car’s
current position to the destination).
❒Turn on the mobile phone.
❒Register the mobile phone.
SETTING FUNCTIONS – REGISTER
MOBILE PHONE.
❒Ensure the mobile phone you have
registered on the car’s handsfree
system is within the system’s radius of
action.
❒Ensure that the Bluetooth®connec-
tion to the car’s handsfree system
(“Blue&Me” identifier) is activated on
your mobile phone.
❒–
You can delete the entire list of recent des-
tinations by selecting the DELETE ALL
option or by speaking the command
“delete all” with voice interaction.
NAVIGATION FUNCTIONS –
RECENT DESTINATIONS
Problem Probable Cause Possible Solution
The display indicates:
ROUTE CALCULATION
NOT POSSIBLE
It is not possible to call the telephone
number for a point of interest
(e.g. Restaurant)
It is not possible to delete the list
of RECENT DESTINATIONS
603_83_390 Punto C3 GB 19-06-2007 11:21 Pagina 98