belt FIAT MULTIPLA 2006 1.G Owners Manual

82
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Re-positioning the rear seats
Make sure that the anchorage points shown in the figure are clean:
❒insert the front hooks in the special holes on the car floor;
❒turn the seat until it is 10 cm from the floor then let it drop.
The weight of the seat will position it and latch it to the back hooks.
When repositioning the seats, make sure you do not invert them. The
correct position of the seats is shown on the labels (see the figure) fixed
to the back of the seats:
aleft-hand seat
bcentre seat
cright-hand seat
After refitting, the black section of the belts on the side seats should face
the outside of the car.
F0E0026m
F0G0016m

111
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
S S
A A
F F
E E
T T
Y Y
D D
E E
V V
I I
C C
E E
S S
SEAT BELTS .......................................................................... 112
PRETENSIONERS ................................................................. 117
CARRYING CHILDREN SAFELY ..................................... 120
PRESETTING FOR MOUNTING THE
“ISOFIX TYPE” CHILD RESTRAINT SYSTEM .............. 126
FRONT AIR BAGS .............................................................. 129
SIDE AIR BAGS
(Side bag - Window bag) ..................................................... 132

112
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
SEAT BELTS
Fiat Multipla has a three-point seat belt on the centre seats too (front
and rear).
A special belt retainer (A), set on front passenger’s door post, allows to
lock the seat belt when the passenger is not wearing it.
Fit the belt into the retainer through its proper open side (B).
Fit the seat belt into the retainer when there are no passengers to
prevent maddening noises when driving.
F0E0092m
WARNINGAlways release the seat belt from the retainer before wearing it.

113
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
HOW TO USE THE SEAT BELTS
(for front seats)
The belt should be worn keeping the chest straight and rested against the
seat back.
To fasten the three belts, take the latching tongue (A) and clip it into the
buckle (B), until you hear it click.
At removal, if it jams, let it rewind for a short stretch, then pull it out
again without jerking.
To unfasten the seat belts, press button (C). Guide the seat belt with
your hand while it is rewinding, to prevent it from twisting.
Through the reel, the belt automatically adapts to the body of the
passenger wearing it, allowing freedom of movement. When the car is
parked on a steep slope the reel mechanism may block; this is normal.
The reel mechanism prevents the webbing coming out when it is jerked
or if the car brakes sharply, in a collision or when cornering at high
speeds.
F0E0022m
WARNINGNever press button (C) when travelling.

114
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
USING THE REAR SEAT BELTS
Side seat belts
The seat belt has a double buckle. Unwind the belt slowly. Take tongue
(C) and insert it into seat (D). Then take tongue (A) and insert it into
seat (B). Make sure both buckles are well fastened.
When removing the side seats, wind up the belts and fasten the buckles
to the pins on the right and left sides of the car.
When repositioning the seats, make sure you do not invert them. The
correct position of the seats is shown on the labels fixed to the back of
the seats:
aleft-hand seat
bcentre seat
cright-hand seat
After refitting, the black section of the belts on the side seats should face
the outside of the car.
F0E0024m
F0E0025m
F0E0026m

115
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
Centre seat belt
The belt has a double buckle. Slowly unwind the belt from its reel (A),
take the tongue (D) and insert it in slot (E), then place tongue (B) in slot
(C); make sure both buckles lock properly.
When there is no-one in the centre seat fold both belt sections and place
the buckles in the receptacle (A), inside the locking slots.
When refitting the seats take care not to reverse their positions: the
centre seat is easily distinguished by the table on the seat back.
F0E0027m
Remember that in the event of a violent collision, back seat passengers not
wearing seat belts also represent a serious danger for the front seat
passengers.WARNING

116
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
F0E0023m
SEAT BELT HEIGHT ADJUSTMENT
Always adjust the height of the seat belt to fit the person wearing it. This
precaution could greatly reduce the risk of injury in case of collision.
Correct adjustment is obtained when the belt passes half way between
the end of the shoulder and the neck.
The seat belt can be adjusted to one of 4 different positions.
To raise the belt
Lift ring (A) to the required position.
To lower
Press knob (B), at the same time moving ring (A) down to the required
position.
Then check that the seat belt is locked by pushing down ring (A) without
pressing knob (B).
WARNINGMake the height adjustment when the car is stationary.
After adjustment, always check that the slider is anchored in one of the positions
provided. To do this, with the button released, exert a further pressure to allow the
anchor device to catch if release did not take place at one of the preset positions.WARNING

117
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
PRETENSIONERS
To increase the efficiency of the front seat belts, Fiat Multipla is fitted
with pretensioners on all the three front seats.
Do not place objects under the centre seat as this could damage the
pretensioner system. These devices “feel” through a sensor, that a
violent crash is in progress and rewind the seat belts a few centimetres.
In this way they ensure that the seat belt adheres perfectly to the wearer
before the restraining action begins. The seat belt locks to indicate that
the device has intervened; the seat belt cannot be drawn back up even
when guiding it manually.
WARNINGThe pretensioner can only be used once. After a collision that has triggered it, have
it replaced at a Fiat Dealership. Pretensioner validity is indicated on the label in
the lower oddment compartment: the pretensioners should be replaced at a Fiat
Dealership as this date approaches.
Operations which lead to knocks, vibrations or localised heating (over 100°C for a maximum of 6
hours) in the area around the pretensioners may cause damage or trigger them. These devices are
not affected by vibrations caused by irregularities of the road surface or low obstacles such as kerbs,
etc. Contact a Fiat Dealership for any assistance.
F0E0656m

118
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
IMPORTANT To obtain the highest degree of
protection from the action of the pretensioning device,
wear the seat belt keeping it firmly close to the chest
and pelvis.
A small amount of smoke may be produced. This
smoke is in no way toxic and presents no fire hazard.
The pretensioner does not require any maintenance
or greasing. Anything that modifies its original
conditions invalidates its efficiency. If due to unusual
natural events (floods, seas storm, etc.) the device has
been affected by water and mud, it must necessarily be
replaced.LOAD LIMITING DEVICES
To increase passenger’s safety, the front side seat belt
reels have a built-in load limiting device which allows
controlled sag in such a way as to dose the force
acting on the shoulders during the belt restraining
action in case of front crash.
GENERAL INSTRUCTIONS
FOR THE USE OF THE SEAT BELTS
The driver must comply with (and have the car
occupants follow) all the local law regulations
concerning the use of seat belts.
Always fasten the seat belts before starting.
WARNINGFor maximum safety, keep the back of your seat upright, lean back into it and
make sure the seat belt fits closely across your chest and hips. Make sure that the
seat belts of the front and rear passengers are fastened at all times! You increase
the risk of serious injury or death in a collision if you travel with the belts
unfastened.
Under no circumstances should the components of the seat belts and pretensioners
be tampered with or removed. Any operation should be carried out by qualified
and authorised personnel. Always contact a Fiat Dealership.WARNING

119
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
Seat belts are also to be worn by expectant mothers: the risk of injury in
the case of accident is greatly reduced for them and the unborn child if
they are wearing a seat belt. Of course they must position the lower part
of the belt very low down so that it passes under the abdomen.
IMPORTANT The belt should not be twisted, make sure that it is taut
and adheres to the passenger’s body. The upper part should pass over
the shoulder and cross the chest diagonally. The lower part should
adhere to the pelvis and to the abdomen of the passenger. Do not use
any objects (pegs, stoppers, etc.) to keep the belts away from the body.
IMPORTANT Never travel with a child sitting on the passenger’s lap with
a single belt to protect them both. Do not fasten other objects to the
body.
F0E0028m
F0E0029m
F0E0030m