display FIAT MULTIPLA 2006 1.G Owner's Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2006, Model line: MULTIPLA, Model: FIAT MULTIPLA 2006 1.GPages: 266, PDF Size: 4.61 MB
Page 39 of 266

38
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLSWhen the external lights are on, âand ãwill always
go from TRIP to ILLUMINATION (see
“Dimmer” in this section).
With km/l consumption condition on.
WPress the button when TRIP A data is displayed to reset TRIP
A and TRIP B at the same time.
See WARNING LIGHTS
and MESSAGES
in this section
Standard display
QPress the MODE button to return automatically to the stan-
dard display
Failures
detected?NO
YES
V
VVVV
V
QW
QW
See
INITIAL
CHECK
continued
QWQW
Page 40 of 266

39
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
TRIP B
ONNO
YES
Back to
standard display
continued
Q
Q
W
W
QQWW
VVV
W
Press the button when TRIP
B data is displayed to reset TRIP
B only.
QPress the MODE button to auto-
matically return to the standard display
When the external lights are on,
âand ãwill always go from TRIP to
ILLUMINATION see “Dimmer”
in this section
Page 41 of 266

40
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
DIMMER
This function is used to adjust (increase/decrease) the brightness of the instrument panel and of the display.
Standard display
Back to standard displayAfter 10s without actions Adjust brightness
Turn ignition
key to MAR
IMPORTANT The display will be dimmed when the external
lights are switched on. This function will not be available in the
event of a failure to the dimmer and the display will be on at maxi-
mum brightness.
â
ãâ
ã
Q
Switch side/
taillights on
Page 59 of 266

58
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
D AND
CONTROLS
If there is a fault
If an anomaly affecting the automatic system is
detected the words “AIR-COND FAULTY” will be
displayed.
The automatic system will continue to work for as
long as possible.If the fault involves the fan control (C) and the fan still
works, it will automatically operate at 1st speed.
If the fault involves an air temperature sensor, the
required air temperature control (A) will work as a
manual air temperature mixing control.
Climate control functions in automatic mode
Reason
To reach the required
temperature as soon as possible
after you get into the car
To reach the new temperature
required as quickly as possible
To prevent the entry of harmful
gas; to prevent the windows
steaming up; to speed up air
cooling
Fast window
demisting/defrosting Automatically enabled
function
Compressor on if the required
temperature is lower than or the
same as that outside
Compressor on if the required
temperature is lower than or the
same as that outside
Compressor on
Compressor on - Maximum air
flow/temperature - Air
recirculation off - Air distribution
to windows Signal to
user
Button √led on
Button √led on
Buttons √
and Tled on
Button √led on
Button Tled off Action performedby the user
Car start-up
(key to MAR)
Required
temperature
variation
Recirculation Ton
MAX/DEF
function on
Page 92 of 266

91
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
FAILURE WARNINGS
ABS failure
It is indicated by the instrument panel warning light
>coming on
together with the message on the reconfigurable multifunction display
(see section “Warning lights and messages”).
In this case the braking system will still be effective, although without the
anti-lock device. Drive carefully to the nearest Fiat Dealership to have
the system checked.
EBD failure
It is indicated by the instrument panel warning lights
>and xcoming
on together with the message on the reconfigurable multifunction display
(see section “Warning lights and messages”).
In this case with sharp braking the rear wheels might lock too early, with
the possibility of skidding. Drive extremely carefully to the nearest Fiat
Dealership to have the system checked.
F0G0633m
F0G0634m
WARNINGIf the low brake fluid warning light xcomes on together with the message on the
reconfigurable multifunction display, stop the car immediately and contact the nearest
Fiat Dealership. Fluid leaks from the hydraulic system, in fact, can compromise the
braking system, both traditional systems and systems with ABS.
Page 94 of 266

93
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0E0384m
FAILURE WARNINGS
In the event of failure, the ESP system is automatically disconnected and
the instrument panel warning light (A) comes on together with the
message on the display (see section “Warning lights and messages”).
In this case, go to a Fiat Dealership as soon as possible.
WARNINGDuring the use of the space-saver spare wheel, the ESP system carries on working.
However, you must remind that the space-saver spare wheel presents dimensions
smaller than the standard tyre and therefore its grip is reduced as to the other car
tyres.
For correct operation of the ESP system, the tyres must absolutely be of the same
brand and type on all wheels, in perfect conditions and, above all, of type, brand
and size specified.WARNING
Page 97 of 266

96
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
EOBD SYSTEM
The European On Board Diagnostic system (EOBD) fitted to engine and
automatic transmission (where provided) electronic control units allows
monitoring and warning of any malfunction to the electronic systems that
could increase exhaust emissions.
The objective is:
❒To keep system efficiency under control
❒Warn when a fault causes emission levels to increase
❒Warn of the need to replace deteriorated components
This diagnostic system indicates the presence of deteriorated
components or system malfunctioning (see section “Warning lights and
Messages”) by the turning on of the instrument panel warning light
U
(together with the relevant message on the multifunction display, where
provided).
NOTE: The car is provided with a diagnostic connector that can be
interfaced with appropriate tools, which makes it possible to read the
error codes stored in the control units, together with a series of specific
parameters for engine operation and diagnosis.
This test can also be performed by traffic controller agents.
IMPORTANT: After a servicing operation at Fiat Dealership aimed to
eliminate malfunctioning connected to the EOBD system, in order to
check the system thoroughly it could be required to run a bench test
and, if necessary, road tests which may also call for a long journey.
F0G0382m
If turning the ignition key to MAR, the warning light Udoes not turn on or if, while travelling it
turns on glowing steadily or flashing (together with the message on the multifunction display),
contact Fiat Dealership as soon as possible. Warning light
Uoperation can be checked by means
of special equipment by traffic controller agents. Always comply with the traffic regulations in force
in the country where you are travelling.
Page 111 of 266

110
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
DIESEL PARTICULATE FILTER (DPF)
The Diesel Particulate Filter is a mechanical filter,
integral with the exhaust system, that physically traps
particulates present in the exhaust gases of Diesel
engines.
The diesel particular filter has been adopted to
eliminate almost totally particulates in compliance with
current / future law regulations.
During normal use of the car, the engine control unit
records a set of data (e.g.: travel time, type of route,
temperatures, etc.) and it will then calculate how much
particulates has been trapped by the filter.
Since this filter physically traps particulates, it shall be
cleaned (reclaimed) at regular intervals by burning
carbon particles.
Reclaiming procedure is controlled automatically by
the engine control unit according to the filter
conditions and the conditions of use of the car.During reclaiming the following phenomena could take
place: idling slight increase, fan activation, slight smoke
increase, high exhaust temperatures. These situations
shall not be considered as faults and they do not affect
car performance and environment.
If the dedicated message is displayed, refer to section
“Warning lights and messages”.
Page 154 of 266

153
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
153
GENERAL INFORMATION
The fault messages appearing on the multifunction display when the respective panel warning light comes on are
accompanied by specific suggestions (example: “contact garage”, “turn off engine”, “check manual”, etc...). These
suggestions are short and cautionary. The purpose is to suggest the prompt action to be taken by the driver when a
fault occurs. Suggestions are neither comprehensive nor alternative to the specifications contained in this Owner
Handbook, which you should read very carefully. If a fault is reported, always refer to the instructions given in this
section. The following illustrations are only examples of what can be displayed:
Fault message
Fault message
Fault messageSuggestion
Suggestion
Suggestion
The two messages (“Fault message” and “Suggestion”) will
alternate on the display.
Page 155 of 266

154
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
154
IMPORTANT The presence of warning lights may vary according to the engine version and fittings.
The warning lights come on in the following circumstances:
Warning Messagelight on panel on display
ENGINE COOLANT TOO HOT (red)
Turning the key to MAR the warning light on the dial turns on, but it should go off after about 4
seconds.
The warning light turns on together with the message when the engine is overheated. If the warn-
ing light comes on while the car is moving, stop the car and keep the engine running. Accelerate
slightly to favour a better circulation of coolant. If the warning light does not go out in the follow-
ing two or three minutes, stop the engine and contact a Fiat Dealership.
LOW BRAKE FLUID LEVEL AND/OR HANDBRAKE ENGAGED (red)
Turning the ignition key to MAR the warning light on the dial turns on, but it should go off after
about 4 seconds. The warning light turns on together with the message when the level of the brake
fluid in the reservoir falls below the minimum level, due to possible leak in the circuit and when the
handbrake is engaged.
x
u
If the warning light xturns on when travelling, check that the handbrake is not
engaged. If the warning light stays on with the message and the handbrake is not
applied, stop immediately and contact Fiat Dealership.WARNING