auxiliary battery FIAT MULTIPLA 2006 1.G Owners Manual

166
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
JUMP STARTING
If the battery is flat, it is possible to start the engine using an auxiliary
battery with the same capacity or a little higher than the flat one.
Proceed as follows:
❒Connect positive terminals (+) of the two batteries with a jump lead.
❒With a second lead, connect the negative terminal (-) of the auxiliary
battery to an earth point
Eon the engine or the gearbox of the car to
be started.
IMPORTANT Do not directly connect the negative terminals of the two
batteries: any sparks may ignite the detonating gas which could come out
of the battery. If the auxiliary battery is installed on another car, avoid
metal parts touching accidentally between this car and the one with the
flat battery.
❒Start the engine.
❒When the engine has been started, remove the leads reversing the
order above.
If after a few attempts the engine does not start, do not insist but contact
the nearest Fiat Dealership.
F0E0670m
Never use a battery charger to start the engine as this could damage the electronic systems of your
vehicle, particularly the ignition and fuel supply control units.
WARNINGThis starting procedure must be carried out by qualified personnel because
incorrect operations may cause electrical discharge of considerable intensity. The
liquid contained in the battery is poisonous an corrosive. Avoid contact with the
skin and eyes. Keep naked flames and lighted cigarettes away from the battery and
do not cause sparks.

208
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
Thousands of km
●●●
●● ● ●
●● ● ●
●
●●
●●●●● ●●●●
●●
●●●●● ●●●●
●●●
●●●●● ●●●●
●●
●●
●
●
●● ● ●
●● ● ●
●●●●● ●●●●
●●●
●●●●● ●●●●
20 40 60 80 100 120 140 160 180
(*) Or every 4 years for particularly demanding use (cold climates, driving in the city idling for a long time)
Or every 5 years, regardless of the km covered
(**) Engine oil and oil filter shall be changed when the corresponding warning light turns on (see section “Warning lights and Messages”), or in
any case every 2 years.
Check and adjust tappet clearance, if required (JTD 120 versions)
Check and adjust handbrake lever stroke
Check exhaust emissions/smoke (JTD 120 versions)
Check exhaust emissions
Check antievaporation system
Change fuel (JTD 120 versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (diesel versions)
Replace fuel filter cartridge (diesel versions)
Check and top up, if required, fluid levels (engine coolant,
brakes, windscreen washer, battery, etc.)
Check mechanical oil level
Check timing belt conditions
Replace timing belt (*)
Replace auxiliary belt
Change spark plugs (petrol versions)
Check engine control system operation
(through diagnostic socket)
Change engine oil and oil filter (petrol versions)
Change engine oil and oil filter
(JTD versions with DPF) (**)
Change brake fluid (or every 24 months)
Change pollen filter (or every 12 months)