remove seats FIAT PANDA 2007 169 / 2.G Owners Manual

62
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
To restore the use of the rear seat: lift the
seat back and push it backwards until you
hear the locking click and make sure the
seat belts are at the front of the seat back.
The car can be fitted, as optional, with sep-
arate rear seats.
The boot extension possibilities offered
by the split seat are many and they should
be chosen according to the number of
passengers and the amount of luggage to
be carried:
❒total extension with right and left side
of the seat tilted as described above;
❒partial extension with left or right side
of the seat tilted and place only for No.
1 rear passenger.
IMPORTANT If in the boot there is a
rather heavy load and you are travelling at
night, check and adjust aiming of the main
beam headlights (see “Headlights” in this
section).EXTENDING THE BOOT
(versions with rear sliding seat)
fig. 79 and 80
Partial extension
Use lever A(in the passenger’s compart-
ment) or the central tab Din the boot to
move the seat forward.
Total extension
Remove the rear parcel shelf as previous-
ly described (see versions with rear fixed
seat).
Use lever Aor central tab Din the boot
to move the seat to the required position
(e.g.: fully forward for total boot exten-
sion);
Lift lever Bor Cor pull side tabs Eor F
in the boot to release the seat back rest
section to tilt; both if you want to tilt the
whole back rest. EXTENDING THE BOOT
(versions with rear fixed seat)
fig. 78
Proceed as follows:
1) Remove the rear parcel shelf and fit it
behind the back rests. To remove the rear
parcel shelf, release catches A(one per
side) and pull the rear parcel shelf out-
wards.
2) Operate the levers on the seat back
outer side and tilt the seat back forwards
putting aside the seat belts.
For central seat belts with three anchor
point see paragraph “Use of the central
seat belt” in section “Safety devices”.
fig. 78F0G0131mfig. 79F0G0257m
A heavy load that has not
been secured may cause se-
rious harm.
WARNING
060-080 Panda New GB 21-06-2007 13:48 Pagina 62

65
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
HEADLIGHTS
ADJUSTING THE HEADLIGHT
BEAM
The correct positioning of the headlight
beams is very important for the comfort
and safety not only of the person driving
the car but also all other road users. This
also covered by a specific law.
To ensure you and other drivers have the
best visibility conditions when travelling
with the headlights on, the headlights must
be set properly.
Have the headlight positioning checked at
a Fiat Dealership and adjusted if necessary.
Check the positioning of the headlight
beams whenever the weight or the load
position is changed.
ROOF RACK/
SKI RACK
FASTENERS fig. 84
The roof rack fastener seats Aare shown
in the figure.
To secure the roof rack, remove plugs B
(two per side).
A roof rack/ski rack especially designed for
Fiat Panda is available from Lineaccessori
Fiat.
On some versions, bars carrying all ob-
jects can be provided as an optional.
fig. 84F0G00203m
After travelling a few kilo-
metres, check that the at-
tachment fastening screws are tight.
WARNING
Never exceed the permitted
weight (see section “Techni-
cal specifications”.
060-080 Panda New GB 21-06-2007 13:48 Pagina 65

87
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
All restraint devices must bear the certi-
fication data, together with the control
brand, on a solidly fixed label which must
absolutely never be removed.
Over 1.50 m in height, from the point of
view of restraint systems, children are
considered as adults and wear the seat
belts normally.
Lineaccessori Fiat offers seats for each
weight group, which are the recommend-
ed choice, as they have been designed and
experimented specifically for Fiat cars.CARRYING CHILDREN
SAFELY
For optimal protection in the event of a
crash, all passengers must be seated and
wearing adequate restraint systems.
This is even more important for children.
This prescription is compulsory in all EC
countries according to EC Directive
2003/20/EC.
Compared with adults, their head is pro-
portionally larger and heavier than the rest
of the body, while the muscles and bone
structure are not completely developed.
Therefore, correct restraint systems are
necessary, other then adult seat belts.
The results of research on the best child
restraint systems are contained in the Eu-
ropean Standard ECE- R44. This Standard
enforces the use of restraint systems clas-
sified in five groups:
Group 0 0-10 kg in weight
Group 0+ 0-13 kg in weight
Group 1 9-18 kg in weight
Group 2 15-25 kg in weight
Group 3 weight 22 - 36 kg
SERIOUS DANGER: Never
place cradle child’s seats on
the front passenger seat of
cars fitted with passenger’s
air bag. The air bag activa-
tion could cause serious in-
juries, even mortal. You are advised
to carry children always on the rear
seats, as this is the most protected po-
sition in the case of a crash. In any
case, children’s seats must absolutely
not be fitted on the front seat of cars
with passenger’s air bag, which dur-
ing inflation could cause serious in-
jury, even mortal, regardless of the se-
riousness of the crash that triggered
it. Children may be placed on the
front seat of cars fitted with passen-
ger’s air bag deactivation. In this case,
it is absolutely necessary to check the
warning light
Fon the cluster to
make sure that deactivation has ac-
tually taken place (see paragraph
“Passenger’s front air bag” at item
“Front air bags”). The front passen-
ger’s seat shall be adjusted in the
most backward position to prevent
any contact between child’s seat and
dashboard.
WARNING
081-100 Panda New GB 21-06-2007 13:49 Pagina 87

95
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
MANUALLY DEACTIVATING
THE PASSENGER’S FRONT
AIR BAG
Should it be absolutely necessary to car-
ry a child on the front seat, the passenger’s
air bag on the car can be deactivated.
Deactivation/reactivation takes place with
ignition key at STOPand operating it in
the special key switch in the glovebox.
The key can be fitted and extracted in
both positions.
IMPORTANT Operate the switch only
when the engine is not running and the ig-
nition key is removed. PASSENGER’S FRONT AIR BAG
fig. 17
It consists of an instant-inflating cushion
contained in a special recess in the dash-
board; its volume is bigger than the dri-
ver’s one.
fig. 17F0G0057m
SERIOUS DANGER: Never
place cradle child’s seats on
the front passenger seat of
cars fitted with passenger
air bag. Air bag activation
could cause serious injuries,
even mortal. In the case of need, al-
ways deactivate the passenger’s air
bag when a child’s seat is placed on
the front seat. The front passenger’s
seat shall be adjusted in the most
backward position to prevent any
contact between child’s seat and
dashboard. Even if not compulsory by
law, you are recommended to reacti-
vate the air bag immediately as soon
as child transport is no longer neces-
sary.
WARNING
081-100 Panda New GB 21-06-2007 13:49 Pagina 95

PARKING
Proceed as follows:
❒ Stop the engine and engage the hand-
brake;
❒engage a gear (1stif the car is faced up-
hill or reverse if it is faced downhill) and
leave the wheels steered.
Block the wheels with a wedge or a stone
if the car is parked on a steep slope.
Do not leave the ignition key at MARto
prevent draining the battery, always re-
move the ignition key when leaving the
car.
Never leave children unattended in the
car. Always remove the ignition key when
leaving the car and take it out with you.HANDBRAKE fig. 1
The handbrake lever is located between
the two front seats.
Pull the handbrake lever upwards until the
car cannot be moved.
Four or five clicks are generally enough
when the car is on level ground while nine
or ten may be required if the car is on a
steep slope or laden.
IMPORTANT If this is not the case, con-
tact Fiat Dealership to have the handbrake
adjusted.
When the handbrake lever is pulled up
and the ignition key is at MAR, the in-
strument panel warning light xwill turn
on. STOPPING THE ENGINE
Turn the ignition to STOPwhile the en-
gine is idling.
IMPORTANT After taxing drive, you
should allow the engine to “catch its
breath” before turning it off by letting it
idle to allow the temperature in the en-
gine compartment to fall.
fig. 1F0G0037m
104
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
A quick burst on the acceler-
ator before turning off the en-
gine serves absolutely no
practical purpose, it wastes
fuel and is damaging especially to tur-
bocharged engines.
101-112 Panda New GB 21-06-2007 13:50 Pagina 104

142
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
Figure 34
D12V-21W bulb for reversing light on
right light unit;
❒rear fog light on left light unit;
❒on right hand drive versions, re-
versing light in the left rear light
cluster and in the rear fog lamp in
the right rear light cluster;
E12V-21W bulb for direction indica-
tors;
F12V-21/5W double-light bulb for stop
light and taillights;
❒slacken the four screws B-fig. 33from
their seats;
❒remove the bulb-holder C;
❒remove the bulbs, pushing them slight-
ly anti-clockwise;
❒refit by reversing the above mentioned
operations.
fig. 33F0G0097mfig. 34F0G0098m
REAR LIGHT UNIT
To change the bulb proceed as follows:
❒slacken the three screws A-fig. 32
from their seats, pull gently outwards
until releasing the whole headlight from
the three clips (press-fitted) and release
the connector;
fig. 32F0G0096m
123-154 Panda New GB 21-06-2007 13:51 Pagina 142

175
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
CLEANING SEATS AND FABRIC
AND VELVET PARTS
Use a soft brush or vacuum cleaner to re-
move dust. Velvet is cleaned better if the
brush is moistened.
Rub the seats with a sponge moistened
with a solution of water and neutral de-
tergent.
INTERIOR PLASTIC PARTS
For routine cleaning of interior plastic
parts use a soft cloth moistened with wa-
ter and neutral soap. Remove grease or
persisting stains using appropriate solvent-
free products designed to preserve ap-
pearance and colour of plastic compo-
nents.
IMPORTANT Never use spirit or petro-
leum to clean the instrument panel.INTERIORS
Periodically check that water is not
trapped under the mats (due to water
dripping off shoes, umbrellas, etc.) which
could cause oxidisation of the sheet met-
al. Engine compartment
At the end of the winter the engine com-
partment should be carefully washed,
without directing the jet against electron-
ic control units. Contact a specialised
workshop to have this done.
IMPORTANT The car should be washed
with the engine cold and the ignition key
at STOP. After washing make sure that
the various protections (e.g. rubber caps
and various covers) have not been dam-
aged or removed.
Front headlights
IMPORTANT Never use aromatic sub-
stances (e.g.: petrol) or ketones (e.g.: ace-
tone) for cleaning front headlight plastic
lens.
Never use flammable prod-
ucts like oil ether or rectified
petrol for cleaning car interiors. Elec-
trostatic discharges generated by rub-
bing during cleaning operations could
cause fire.
WARNING
Do not keep aerosol cans in
the car: they might explode.
Aerosol cans must never be exposed
to a temperature above 50° C. The
temperature inside the car exposed
to the sun may go well beyond that
figure.
WARNING
155-176 Panda New GB 21-06-2007 13:52 Pagina 175