low beam FIAT PANDA 2008 169 / 2.G 4x4 Supplement Manual

4
FIAT PANDA 4 x 4
❒signalling with light on constantly: this
indicates that there is a problem with
the 4x4 drive; go to a Fiat Dealership
as soon as possible (where provided,
the display will show a dedicated mes-
sage). In addition, on versions with ESP,
if the ELD is on, the LED in the button
will go out.HEADLIGHT WASHER
(where provided)
The headlight washing system consists of
two nozzles for washing the external
headlight lens. This function can be acti-
vated using the windscreen washer stalk
only if dipped beams or main beams are
on. Operating the stalk to wash the wind-
screen will automatically start the head-
light washer.
This version features a windscreen wash-
er fluid reservoir with improved capaci-
ty, i.e.: 4.5 litres.
IF A TYRE
IS PUNCTURED
General instructions
The car can be delivered (upon request/if
provided) with space-saver spare wheel or
with quick tyre repair kit (called Fix & Go).
Wheel changing and correct use of the jack
and space-saver spare wheel call for some
precautions as listed in the Owner Hand-
book this Supplement is attached to. In the
Owner Handbook you will also find how
to use the Fix & Go kit (quick tyre repair
kit).
To change a wheel proceed as follows:
❒stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely. The
ground should be flat and adequately
firm;
❒turn the engine off and pull up the hand-
brake;
❒engage first gear or reverse;
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 4

7
FIAT PANDA 4 x 4
IF AN EXTERIOR LIGHT
BURNS OUT
(Fiat Panda 4 x 4 CROSS
version)
IMPORTANT To change an external light
on Fiat Panda 4 x 4 and Fiat Panda 4 x 4
Climbing versions, refer to the Owner
Handbook this Supplement is attached to.
For the type of bulb and power rating re-
fer to paragraph “When needing to change
a bulb” in section “In an emergency” in the
attached Owner Handbook.
FRONT LIGHT UNITS
To change the dipped beam bulb, proceed
as follows:
❒remove the cover A-fig. 11;
❒disconnect the connector C-fig. 12;
❒release the bulb holder catch A;
❒remove the bulb Band fit the new bulb.To change the front sidelight bulb, pro-
ceed as follows:
❒remove the cover A-fig. 11;
❒remove the bulb holder A-fig. 12
❒remove the bulb B;
❒fit the new bulb.To change the front fog light bulb, proceed
as follows:
❒remove the cover A-fig. 11;
❒disconnect the connector D-fig. 14;
❒turn slightly the bulb holder B and re-
move it;
❒remove the bulb C and fit the new bulb.
To change the main beam bulb, proceed
as follows:
fig. 11F0G0617m
fig. 12F0G0618m
fig. 13F0G0619m
fig. 14F0G0628m
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 7