tyre pressure FIAT PANDA 2008 169 / 2.G 4x4 Supplement Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2008, Model line: PANDA, Model: FIAT PANDA 2008 169 / 2.GPages: 26, PDF Size: 1.16 MB
Page 2 of 26
1
FIAT PANDA 4 x 4
This Supplement describes the main fea-
tures of Fiat Panda 4 x 4 versions togeth-
er with a few instructions for use. For all
the other information not contained here-
in, refer to the Owner Handbook this sup-
plement is attached to.
FIAT PANDA 4 x 4 DRIVE LINE
The Fiat Panda 4 x 4 has a transmis-
sion system comprising two differ-
entials and an electronically con-
trolled coupling.
Thanks to this system, under poor
grip conditions the four-wheel drive
will engage automatically (i.e.: no
driver’s action required) and provide
optimum torque distribution be-
tween front and rear axle.
Fiat Panda 4 x 4 is therefore suited
for all types of roads: in fact, it is ca-
pable of coping well with snowy, icy,
muddy and dirt roads, even with
steep slopes.SUMMARY
ABS SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
ESP SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
ELD - ELECTRONIC LOCKING DIFFERENTIAL . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
HEADLIGHT WASHER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
IF A TYRE IS PUNCTURED . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
IF AN EXTERIOR LIGHT BURNS OUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
WASHING THE CAR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
TOWING THE CAR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
TOWING TRAILERS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
SERVICE SCHEDULE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
ENGINE CODES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
BODY VERSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
WHEELS AND TYRES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
INFLATING PRESSURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
SNOW CHAINS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
TRANSMISSION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
STEERING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
DIMENSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
PERFORMANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
CAPACITIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
WEIGHTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
FUEL CONSUMPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
CO
2EMISSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 1
Page 7 of 26
6
FIAT PANDA 4 x 4
❒make sure the space-saver spare wheel
supporting surfaces on the hub are
clean and free from any impurities that
could cause wheel bolts loosening;
❒fit the space-saver spare wheel match-
ing one of the wheel holes Owith pins
N-fig. 8;
❒fasten the four fastening bolts;
fig. 8F0G0204m
fig. 9F0G0206m
fig. 10F0G0615m
❒turn the jack handle to lower the car
and remove the jack;
❒fasten the bolts completely, working in
a criss-cross fashion as shown in fig. 9.
After changing the wheel
❒put the jack partly open and the tools
used into the tool bag;
❒stow the bag with tools into its place
under the driver’s seat.
IMPORTANT Replaced wheel shall be
placed in the boot under the cover mat as
shown in fig. 10.
IMPORTANT Do not use inner tubes
with tubeless tyres. Check tyre and space-
saver spare wheel pressure regularly.IMPORTANT Changing original wheels
with others of different type (i.e.: with al-
loy rim instead of steel rims and vice ver-
sa) will involve to change the whole set
of wheel bolts with others of suitable
length. It is however recommended to
keep replaced bolts in the event of future
refitting of the original wheels.
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 6
Page 13 of 26
12
FIAT PANDA 4 x 4
20 40 60 80 100 120 140 160 180
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●● ● ●
●●●●● ●●●●
●●●●● ●●●●
●
●● ● ●
●● ● ●
●● ● ●
●●
SERVICE SCHEDULE
Thousands of km
Check tyre conditions/wear and adjust pressure
if required
Check light system operation (headlights, direction indicators,
hazard lights, passenger compartment lights, boot lights,
warning lights, etc.)
Check windscreen wiper/washer operation,
adjust nozzles
Check windscreen/rear window blade
position/wear
Check front disk brake pad conditions and wear
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts,
underbody protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness
and lubrication
Check tension and adjust accessory drive belts
(excluding engines with automatic belt tighteners)
Sight inspect accessory drive belt conditions
Check and adjust tappet clearance (petrol versions)
Check handbrake lever stroke
Check antievaporation system (petrol versions)
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 12
Page 16 of 26
15
FIAT PANDA 4 x 4
To prevent damages to the
viscous joint do not cover long
distances with underinflated
tyres (tyres partly or com-
pletely flat).
RIMS AND TYRES
All Fiat Panda 4x4 version tyres have been designed to obtain best performance on both regular roadbed and not asphalted and/or
snowy or icy roads. These tyres are characterised by high road-holding performance off-road and good driveability on both snowy/icy
roads and dry or wet roadbeds. WINTER type tyres are also available (Contiwinter TS800 185/65/ R14 86T) that should be used
if the vehicle is mainly used on roads covered in snow. The following tyres are provided:
5.5J x 14
5.5J x 14
5.5J x 14
6J x 15
165/70 R14 81T M+S
185/65 R14 86T M+S ()
165/70 R14 81T M+S (*)
185/65 R14 86T M+S (*)
175/65 R15 84T M+S ()4.00B x 14
4.00B x 14
4.00B x 14
4.00B x 15135/80 R14 84P
135/80 R14 84P
135/80 R14 84P
125/80 R15 95M Fiat Panda 4 x 4
Fiat Panda 4 x 4
Climbing
Fiat Panda 4 x 4
CROSS Version Rims Tyres Space-saver spare wheel
Rim Tyre
(*) Optional tyre
() Tyres that cannot be fitted with snow chains
Versions Medium load Full load Space-saver
front rear front rearspare wheel
1.22.2 2.0 2.3 2.3 2.8
1.3 Multijet2.3 2.1 2.3 2.3 2.8 / 4.2(*)
(*) For Fiat Panda 4 x 4 CROSS versions with 125/80 R15 95M
space-saver spare wheel
INFLATION PRESSURES (bar)
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 15