run flat FIAT PANDA 2009 169 / 2.G LPG Supplement Manual

12
FIAT PANDA LPG
ELECTRONIC
CONTROL UNIT
The vehicle has a dedicated electronic
control unit for the LPG system; it uses
the incoming signals from the petrol in-
jection control unit and converts them in-
to signals for the injection of the LPG.
The control unit for the injectors has the
same strategy as the petrol control unit
(phased, sequential, multipoint).
LPG/PETROL SWITCH
The LPG/petrol switch fig. 7is located on
the protective fuse flap (left side of the
dashboard) and includes:
A. LPG/petrol operating mode request
button;
B. LPG gauge: 5 leds of which 4 green and
1 red to indicate the reserve. The red LED
only comes on when the last green LED
goes out.
The red LED indicates the reserve con-
dition;
ON. LPG operation mode indicator:
green LED on continuously, under the
buttonA;
OFF. petrol operation mode indicator:
yellow LED on continuously, under the
buttonA.
IMPORTANT When the ignition key is
turned to the MARposition the LEDs on
the ignition switch come on in accordance
with the following rule:
–with petrol operation mode se-
lected: yellow LED OFF activation;
–with LPG operation selected: all
LEDs on the switch are on continuously
and the green LED ONflashes.To select the type of fuel system desired
(LPG or petrol), press button A-fig. 7.
To change the type of fuel system, it is ad-
visable to operate the button with the ve-
hicle stationary and the engine running or,
whilst driving, after having released the ac-
celerator.
If the switching takes place during accel-
eration or pick-up, there may be a brief
flat spot (fall in power).
fig. 7F0Z0807m
Do not switch between the
two operating modes whilst
starting the engine.
603_97_595GB PANDA GPL Euro 5 16-12-2009 12:58 Pagina 12