seats FIAT PUNTO EVO 2010 1.G Owners Manual

39
F0U0023mfig. 29
Horiziontal adjustment fig. 29
Lift the lever A and push the seat forwards or backwards:
in the driving position your arms should rest on the rim
of the steering wheel.
Any adjustments should be carried out on-
ly when the vehicle is stationary.
WARNING
After releasing the adjustment lever, al-
ways check that the seat is locked on the
guides by trying to move it back and forth. If it is
not locked, the seat may move unexpectedly and
make you lose control of the car.
WARNING
The fabric covers on your vehicle have been
designed to resist normal wear and tear.
Some precautions are however needed.
Avoid prolonged rubbing against clothing acces-
sories, such as metal buckles, bosses, Velcro strips
and the like, which by applying a high pressure on
the fabric in a small area could cause the break-
age of some threads and damage the upholstery.
FRONTSEATS
Height adjustment fig. 29
(for versions/markets where provided)
Move lever B upwards or downwards to achieve the re-
quired height.
IMPORTANT Adjustment must be carried out only when
seated in the relevant seat.
Backrest angle adjustment fig. 29
Turn knob C.
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
037-081 PUNTO FL EN 4ed 18-01-2010 12:23 Pagina 39

For maximum protection, keep the back
of your seat upright, lean back into it and
make sure the seat belt fits closely across your
chest and hips.
WARNING
Always check that the seat is properly
locked on the guides by trying to push it
backwards and forwards.
WARNING
Folding down the backrest (3-door versions)
fig. 30
To access the rear seats, pull handle A upwards: the back-
rest will fold forwards and the seat will slide forwards when
you push the backrest.
When you put the backrest back up, the seat will return
to its original position (mechanical memory).Electric lumbar support adjustment fig. 31
(for versions/markets where available)
To adjust the support for your back, use controls E.
fig. 31F0U0025mfig. 30F0U0024m
40
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
037-081 PUNTO FL EN 4ed 18-01-2010 12:23 Pagina 40

The fabric upholstery of your car is designed
to withstand normal wear and tear for
a long time. Some precautions are howev-
er needed. Avoid prolonged rubbing against cloth-
ing accessories, such as metal buckles, bosses,
Velcro strips and the like, which by applying a high
pressure on the fabric in a small area could cause
the breakage of some threads and damage the up-
holstery.
Heated seats fig. 32
(for versions/markets where available)
With the key turned to MAR, press button F to switch the
function on/off. When the function is enabled, the LED on
the button turns on.REAR SEATS
To fold the rear seats, refer to the “Extending the boot”
paragraph in this section.
fig. 32F0U0026m
41
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
037-081 PUNTO FL EN 4ed 18-01-2010 12:23 Pagina 41

REAR HEAD RESTRAINTS fig. 34
(for versions/markets where provided)
To move the head restraint upwards, raise it until hear-
ing the click (position of use).
To bring it back to the position of non-use, press button
A and push the head restraint down into the back rest.
To extract the rear head restraints press buttons A and
B simultaneously and release them upwards.
IMPORTANT When the rear seats are in use, the head
restraints must always be in the position of use.
Any adjustment of the steering wheel po-
sition must be carried out only with the car
stationary and the engine turned off.
WARNING
STEERING WHEEL
The driver can adjust the height and axial position of the
steering wheel.
To carry out the adjustment, proceed as follows:
❒release lever A-fig. 35 by pushing it forwards (position 1);
❒adjust the steering wheel;
❒lock lever A by pulling it towards the steering wheel (po-
sition 2).
fig. 35F0U0029mfig. 34F0U0028m
43
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
037-081 PUNTO FL EN 4ed 18-01-2010 12:23 Pagina 43

fig. 40
HEATING AND VENTILATION SYSTEM
1. Fixed upper vent – 2. Adjustable central vents – 3. Fixed side vents – 4. Adjustable side vents – 5. Lower vents for
front seats – 6. Lower vents for rear seats.
47
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
F0U0034m
037-081 PUNTO FL EN 4ed 18-01-2010 12:23 Pagina 47

76
F0U0065mfig. 70
FRONT ARMREST WITH STORAGE
COMPARTMENT
(for versions/markets where provided)
Certain versions are fitted with an armrest A-fig. 69 be-
tween the front seats.KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
F0U0063mfig. 71
To bring this to the standard position of use, push it down
as shown in fig. 69.
Press button A-fig. 70 to raise the top of the armrest in
order to use storage compartment B. Use lever C to tilt
down the armrest with respect to its normal position.
DOOR POCKETS fig. 71
There are document/map pockets and a bottle holder
built into each of the door panels.
F0U0064mfig. 69
037-081 PUNTO FL EN 4ed 18-01-2010 12:23 Pagina 76

94
F0U0091mfig. 100
OPENING THE BOOT IN AN
EMERGENCY fig. 99
To open the boot from inside if the car battery is flat or
the electric lock of the rear door is faulty, proceed as fol-
lows:
❒tilt the rear seats fully forward (see “Extending the boot”
in this section);
❒press lever B inside the boot.KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
F0U0090mfig. 99
EXTENDING THE BOOT
Partial extension (1/3 or 2/3) fig. 100
(for versions/markets where provided)
The boot can be partially (1/3 or 2/3) or totally extended
by splitting the rear seat.
Proceed as follows:
❒fully lower the rear seat head restraints;
❒check that the seat belt is not twisted;
❒tilt the cushions forward as shown by the arrow
fig. 100;
❒lift handle A or B-fig. 101 to release either the left or
right part of the backrest and guide the backrest down
onto the cushion.
082-128 PUNTO FL EN 4ed 20-01-2010 15:06 Pagina 94

97
F0U0096mfig. 107
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
F0U0098mfig. 106
Once removed, the parcel shelf can be positioned between
the back of the front seats and the folded cushion of the
rear seat fig. 107.
F0U0100mfig. 108
BONNET
OPENING
Proceed as follows:
❒pull the lever fig. 108 in the direction of the arrow;
❒pull the catch A-fig. 109 as shown in the diagram;
❒lift the bonnet and, at the same time, release the bon-
net support rod from its locking device D-fig. 110; then
insert the end of the bonnet support rod C-fig. 111 in-
to the hole E.
IMPORTANT Before opening the bonnet, check that wind-
screen wiper arms are not lifted from the windscreen.
082-128 PUNTO FL EN 4ed 20-01-2010 15:06 Pagina 97

101
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
F0U0105mfig. 113
Headlight alignment adjustment fig. 113
To adjust, press buttons Òand on the control panel.
The display located on the instrument panel provides the
visual indication of the positions during the adjustment op-
eration.
Position 0 – one or two people in the front seats.
Position 1 – five people.
Position 2 – five people + load in the boot.
Position 3 – driver + maximum permitted load stowed in
the boot.
IMPORTANT Check the beam alignment every time the
load transported changes.
FRONT FOG LIGHTS ALIGNMENT
(for versions/markets where provided)
Contact a Fiat Dealership to have the direction checked
and, if necessary, adjusted.HEADLIGHTS
LIGHT BEAM DIRECTION
The correct direction of the headlights is essential for the
comfort and safety of the driver and other road users. The
headlights must be correctly directed to ensure the best
visibility. Contact a Fiat Dealership to have the direction
checked and, if necessary, adjusted.
HEADLIGHT ALIGNMENT CORRECTOR
This device works with the key in the MAR position and
the dipped headlights on. The car will tilt backwards when
it is loaded, raising the light beam. The beams must there-
fore be aimed again in this case.
082-128 PUNTO FL EN 4ed 20-01-2010 15:06 Pagina 101

130
CONOSCENZA
DELLA
VETTURA
AVVIAMENTO
E GUIDA
SPIE E
MESSAGGI
IN EMERGENZA
MANUTENZIONE
E CURA
DATI TECNICI
INDICE
F0U0114mfig. 131
IMPORTANT When the red band next to the backrest
folding levers fig. 131 disappears, it means the backrest is
properly secured. If you can still see the red band, the back-
rest is not securely fastened. When returning the backrest
to its normal position, make sure it is correctly fastened
and you hear the lock click.
IMPORTANT After putting the seats back to their normal
position, make sure the seat belts are positioned so they
are ready to use.KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Remember that, in the event of a violent
collision, back seat passengers not wearing
seat belts represent a serious danger not only to
themselves but also to the front seat passengers.
WARNING
Ensure that the backrest is properly se-
cured on both sides so that it does not fly
forwards in the event of sharp braking and injure
passengers.
WARNING
SBR SYSTEM
(for versions/markets where provided)
The car is fitted with the SBR system (Seat Belt Reminder),
consisting of a warning sound which, together with the
warning light
the driver and front passenger that their seat belt is not
fastened.
For permanent deactivation, contact a Fiat Dealership.
With a digital display, the SBR system can be reactivated
only at a Fiat Dealership.
With a multifunction display, the SBR system can also be
re-enabled through the setup menu.
129-148 PUNTO FL EN 4ed 18-01-2010 12:25 Pagina 130