bonnet FIAT QUBO 2010 1.G User Guide
[x] Cancel search | Manufacturer: FIAT, Model Year: 2010, Model line: QUBO, Model: FIAT QUBO 2010 1.GPages: 230, PDF Size: 4.38 MB
Page 184 of 230

❒correctly position the new arm and tighten the nut
fully;
❒lower the cover.
SPRAY NOZZLES
If the jet is not coming out, firstly check that there is
fluid in the windscreen/rear window reservoir (for
versions/markets where provided) (see “Checking
levels” in this section).
Then check that the nozzle holes are not clogged;
use a needle to unblock them if necessary.
Windscreen (washer)
The window washer jets are fixed. The nozzle
holders are located under the bonnet (see fig. 175).Rear window (washer)
The rear window washer jets are fixed. The nozzle
holder is located above the rear window (see ).
fig. 175F0T0090
183
KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
Page 186 of 230

For example, it is advisable to wash the vehicle more
often in areas with high atmospheric pollution or if
you are travelling on roads sprinkled with salt.
To wash the vehicle properly, proceed as follows:
❒wash the body using a low pressure jet of water;
❒wipe a sponge with a slightly soapy solution over
the bodywork, frequently rinsing with the sponge;
❒rinse well with water and dry with a jet of air or a
chamois leather.
If you put the vehicle through a car
wash, take heed of the following:
❒remove the antenna from the roof so it does not
get damaged;
❒the car wash should use water added to a soapy
solution;
❒rinse thoroughly to avoid soap marks staying on
the bodywork or less visible parts.
Some car washes with old-style blades
and/or in a poor state of repair can
damage the paintwork, facilitating the
formation of lines that give the paint a dull/misty
appearance, especially on dark colours. If this
happens, lightly polish the paintwork with
appropriate products.
Dry the less visible parts particularly carefully, such
as the door frames, bonnet and the headlight frames,
where water may stagnate more easily. It is a good
idea to leave the vehicle outdoors for a while after
washing it to give water time to evaporate.Do not wash the vehicle after it has been left in the
sun or with the bonnet hot: this may alter the shine
of the paintwork.
Exterior plastic parts should be cleaned in the same
way as the rest of the vehicle. Where possible, do
not park the vehicle under trees; the resinous
substances released by many species give the paint a
dull appearance and increase the possibility of rust.
IMPORTANT Bird droppings should be washed
off immediately and thoroughly as the acid
they contain is particularly aggressive.
Detergents cause water pollution.The
vehicle should be washed in areas
equipped for collecting and purifying the
liquid used in the washing process.
Windows
Use specific detergents to clean the windows. Also
use clean cloths to avoid scratching the glass or
altering the transparency.
IMPORTANT Wipe the rear window gently with a
cloth in the direction of the filaments to avoid
damaging the heating device.
Engine compartment
At the end of each winter, thoroughly wash the
engine compartment, taking care to avoid spraying
the water jet directly onto the electronic control
185
KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
Page 190 of 230

CHASSIS MARKING
This is printed on the passenger compartment floor,
near the right front seat.
Slide the hatch A fig. 178 forward to access.
The marking includes:
❒type of vehicle;
❒chassis manufacture number.BODY PAINTWORK IDENTIFICATION
PLATE
This plate is applied inside the bonnet and shows the
following data fig. 179:
APaint manufacturer.
BColour name.
CFiat colour code.
DRespray and touch up code.
ENGINE MARKING
This is printed onto the cylinder block and shows the
type and production serial number.
fig. 178F0T0084fig. 179F0T0012
189
KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
Page 223 of 230

Index
ABS fault warning light ............ 123
ABS (fault warning light) .......... 123
ABS ................................................ 75
Air bag fault warning light ........ 121
Air bag (fault warning light) ..... 121
Airbags (general warnings) ...... 108
Air cleaner ................................... 177
Alarm fault warning light .......... 127
Alarm ............................................. 9
Alarm (warning light) ................ 127
Arrangements for dealing
with the vehicle at the end
of its life ..................................... 211
Ashtray .......................................... 56
ASR
– On/off message..................... 130
ASR system .................................. 78
– On/off message..................... 130
Battery
– Replacement .......................... 178
Battery (low charge warning
light) ............................................ 122
Battery (recharging) .................. 163Body
– Advice for preserving the
bodywork ............................... 184
– Protection from
atmospheric elements......... 184
– Vehicle body and
underbody guarantee .......... 184
Body paintwork
identification plate ................... 189
Bodywork versions.................... 190
Bonnet
– Closing ..................................... 71
– Opening ................................... 70
Boot ............................................... 62
Boot light ............................... 52-153
Brake Assist ................................. 76
Brake fluid/handbrake
warning light.............................. 120
Brake fluid.................................... 175
Brake fluid (warning light)........ 120
Brake lights (changing a
bulb) ............................................ 149
Brake pad wear warning
light ............................................. 129
Brake pad wear (warning
light) ............................................ 129
Brakes
– characteristics ....................... 193Brakes (pad wear warning
light) ............................................ 129
Break-in attempt warning
light ............................................. 127
Bulb types .................................... 144
Bump starting ............................. 132
Capacities.................................... 204
Carrying children safely
– Child seat compliance ......... 100
– Child seats .............................. 96
– Safety rules ............................ 101
Ceiling lights................................. 49
Ceiling light with movable
lens (changing a bulb).............. 151
Central and side vents ............... 38
Changing a bulb.................. 143-144
Changing an exterior
bulb .................... 146-147-148-150
Changing an interior bulb ........ 151
Changing a tyre .................. 132-133
Changing battery - key with
remote control.......................... 8
Chassis marking.......................... 189
Checking fluid levels.................. 171
Cigar lighter ................................. 55
Clutch ........................................... 192
CO
2emissions ........................... 209
222
KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX