technical specifications FIAT QUBO 2010 1.G Repair Manual

EMERGENCY OPENING FROM THE INSIDE
In the event of an emergency, you can open the
tailgate from inside as follows:
❒Open the sliding side door and fully fold the rear
seats;
❒from inside the boot, press lever A fig. 63 and
open the tailgate.
WARNING
If you are travelling in areas with few
f
illing stations and you want to
transport fuel in a spare tank, comply with the
law by using only an approved, suitably secured
tank.However, the risks in case of collision
increase.
WARNING
Never exceed the maximum allowed
load
in the boot (see "Technical
Specifications" section). Make sure that the
objects are well arranged in the boot so that
they will not be projected forwards following
sudden braking.
DOUBLE REAR SWING DOORS
(for versions/markets, where provided)
The double rear swing doors fig. 64 are fitted with a
spring-loaded system that stops them when they
have opened to an angle of approximately 90
degrees.
fig. 63F0T0285fig. 64F0T0139
63
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

To open them wider to an angle of 180 degrees, push
the locking device A fig. 65 (one on each side) as
shown in the diagram and simultaneously open the
doors.
WARNING
The spring-loaded system is designed for
o
ptimum usage. Accidental knocks or a
strong gust of wind may release the springs,
forcing the doors to close.Opening/closing the first swing door from the
outside
To open the door, turn the metallic insert of the key
in the lock or press button
on the remote
control and then pull handle A fig. 66 in the direction
of the arrow.
To close the door, turn the key in the lock or press
button
on the remote control.
WARNING
When closing, shut the right-hand door 2
fully
fig. 64 before you close the
left-hand door 1 fig. 64. Never shut the two
doors at the same time.
fig. 65F0T0375fig. 66F0T0140
64
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Emergency opening of the first swing door
from the inside
From inside, use device A fig. 67.Opening the second swing door
After having opened the first door, pull handle A fig.
68 in the direction shown by the arrow.
IMPORTANT Pull handle A fig. 68 in the direction of
the arrow only.
REMOVING THE PARCEL SHELF
The parcel shelf fig. 69consists of two parts.
To remove it completely, proceed as follows:
❒open the tailgate and lift the front part A fig. 69 by
releasing the pin A fig. 70 from the seat F fig. 70;
❒lift the rear part B fig. 69 by releasing the pins B
and C fig. 70 from the seat D and E fig. 70.
fig. 67F0T0060fig. 68F0T0142
65
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

If the seat is completely folded down, remove the
parcel shelf as described and store it horizontally
between the back of the front seats and the folded
rear seat.
To refit the parcel shelf, follow the same procedure
in reverse.WARNING
You must not use the folded rear seat to
carr
y luggage.The load could be thrown
forward into the back of the front seats,
seriously injuring the occupants.
EXTENDING THE BOOT
Proceed as follows:
❒open the tailgate and remove the parcel shelf (as
described in the previous paragraph);
❒completely lower the rear seat headrest;
❒move the seat belt to the side, making sure that it
is fully extended and not twisted;
fig. 69F0T0062
fig. 70F0T0456
BA
fig. 71F0T0444
66
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

❒for versions with single rear seat: operate backrest
retainer lever A fig. 71 and fold the backrest
forwards to obtain a flat loading area. When you
lift the lever, you will see a red band B fig. 71.
❒for versions with split rear seat: lift backrest retainer
lever A fig. 72 and fold the backrest forwards to
obtain a flat loading area. When you lift the lever,
you will see a red band B fig. 72.Versions with single rear seat
To further expand the load compartment, pull tab A
fig. 73 behind the rear seat backrest and fold seat
and backrest forwards.
fig. 72F0T0288
fig. 73F0T0416
A
fig. 74F0T0445
67
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

To fix the seat, take the red straps A shown in fig. 74
and fix the ends of the straps in position A and B as
shown in fig. 75Versions with split rear seat
To further expand the load compartment, pull tabs A
and B fig. 76 behind the rear seat backrests and fold
seats and backrests forwards.
fig. 75F0T0446
fig. 76F0T0289
A
fig. 77F0T0447
68
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

To fix the seat, take the red straps A shown in fig. 77
and fix the ends of the straps in position A and B as
shown in fig. 78 for each of the two parts of the seat.
Removing the rear seat
The rear seat can be removed to further expand the
load compartment and carry large loads. After
folding down the rear seat as described previously,act on the two brackets A fig. 79 positioned under
the side of the seat (one per side).
Repositioning the rear seat
Proceed as follows:
❒check that the seat belt webbing is correctly
inserted in the corresponding bracket:
❒take the cushion back to horizontal position and
check that it is secured correctly;
❒tip back the backrest and check that it is secured
correctly.
An ideogram under the split seat fig. 80 indicates the
method for resecuring the seat to the brackets
screwed to the floor.
fig. 78F0T0448fig. 79F0T0455
69
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

SECURING YOUR LOAD
Hooks (various number, according to version) are
fixed to the floor fig. 81 for easy securing load.BONNET
OPENING
Proceed as follows:
❒pull lever A fig. 82 in the direction indicated by the
arrow;
❒operate the lever B fig. 83 and lift the bonnet;
❒lift the bonnet;
❒lift the engine bonnet supporting lever A fig. 84
and move it until it clicks.
fig. 80F0T0302
fig. 81F0T0418fig. 82F0T0045
70
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

WARNING
Before opening the bonnet , check that
win
dscreen wiper arm is not lifted from
the windscreen.CLOSING
Proceed as follows:
❒lift the bonnet with one hand and pull the device A
fig. 85 towards yourself while you are lowering the
B;
❒lower the bonnet to approximately 20 centimetres
from the engine compartment and let it drop.
Make sure that the bonnet is completely closed
and not only fastened by the safety catch by trying
to open it. If it is not perfectly closed, do not try
to press the bonnet lid down but open it and
repeat the procedure.
IMPORTANT A plate summarising the described
bonnet opening/closing operations is affixed under
the bonnet (see fig. 86).
fig. 83F0T0067
fig. 84F0T0216fig. 85F0T0283
71
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

WARNING
For safety reasons, the bonnet must
al
ways be perfectly closed while
travelling. Make sure that the bonnet is
perfectly closed and that the lock is engaged. If
you discover during travel that the lock is not
fully engaged, stop immediately and close
the bonnet in the correct manner.
ROOF RACK/SKI RACK
FASTENERS
The fasteners are located at points A, B and C fig.
87.
ROOF RAILS
(for versions/markets, where provided)
On some versions, the vehicle has two rails fig.
88which, with the addition of special accessories, can
be used to carry various objects (e.g. skis,
surfboards, etc.).
WARNING
Respect the regulations in force
c
oncerning maximum clearance.
fig. 86F0T0215fig. 87F0T0154
72
KNOW YOUR
VEHICLE
SAFETY
ST
ARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX