light FIAT SEDICI 2009 2.G Manual Online

216
(1) (2)
(3)
(4)
(5)
62J085
(28) (27) (26) (25) (6) (7) (9) (11)
(12) (13) (14) (15) (16) (17) (18) (19)
(24)
(8) (10)
(22) (21)
(23) (20)
79J092
80A
50A
50A
80A
80A
15A
15A
20A
60A
40A
30A
30A
30A
50A
30AAll electric load
Power window, Ignition Wiper, Starter
Tail light, Rear defogger, Door lock, Hazard/
Horn, Dome
Heater, Air compressor, Power steering
Radiator fan, Front fog light, Head light
Head light (Right) fuse
Head light (Left) fuse
Front fog light fuse
Power steering control module fuse
ABS motor fuse
Radiator fan fuse
ABS solenoid fuse
Starting motor fuse
Ignition switch fuse
Blower fan fuse FUSES IN THE ENGINE COMPARTMENT
For Gasoline Engine Model
Main fuse / Primary fuse
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 216

217
20A
15A
15A
15A
–
–
–
–
–
–
–
–
–
–Air compressor fuse
Throttle motor fuse
Automatic transaxle fuse (for versions/markets, where provided)
Fuel injection fuse
Automatic transaxle relay (for versions/markets, where provided)
Air compressor relay
Fuel pump relay
Condenser fan relay
Front fog light relay
Throttle motor relay
FI MAIN
Starting motor relay
Radiator fan relay
Shift lock relay
Main fuse / Primary fuse
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
(24)
(25)
(26)
(27)
(28)
(29)
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 217

218
(6) (7)(4) (5) (2) (1)
(3)
79J172
(33) (30) (29) (28) (8) (9) (14)
(16) (15) (17) (18) (19) (20) (21) (22)
(27)
(10) (11) (13)(12)
(25) (24)
(26) (23)
(32) (31)
79J149
80A
30A
140A
50A
30A
30A
30A
15A
15A
20A
50A
60A
40A
30A
30A
30A
50A
30A
(34) (35)(36)
(37)
(38)
79J173
Glow
Fuel heater
All electric load
Light
Sub heater
Sub heater
Sub heater
Head light (Right) fuse
Head light (Left) fuse
Front fog light fuse
Ignition
Power steering control module fuse
ABS motor fuse
Radiator fan fuse
ABS solenoid fuse
Starting motor fuse
Ignition
Blower fan fuse For Diesel Engine Model
Main fuse / Primary fuse
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 218

219
10A
20A
30A
20A
–
–
–
–
–
–
–
–
–
–
–
–
–
10A
10A
15A
Main fuse / Primary fuse
(19)
(20)
(21)
(22)
(23)
(24)
(25)
(26)
(27)
(28)
(29)
(30)
(31)
(32)
(33)
(34)
(35)
(36)
(37)
(38)Air compressor fuse
Fuel pump fuse
Condenser fan fuse
Fuel injection fuse
Sub heater relay 3
Air compressor relay
Fuel pump relay
Condenser fan relay
Front fog light relay
Sub heater relay 2
Sub heater relay
Starting motor relay
Radiator fan relay
Radiator fan relay
Radiator fan relay
Fuel heater
Fuel injection main
EPI
Fuel injection
INJ DVR
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 219

220
15A
15A
10A
10A
15A
15A
30A
30A
10A
15A
10A
10A
10A
20A
15A
10A
15A
10A
10A
15A
30A
15A
10A
79J093
79J011
Rear wiper
Ignition coil
Back-up light
Meter
Accessory
Accessory 2
Power window
Wiper
IG1 SIG
Air bag
Anti-lock brake system
Tail light
Stop light
Door lock
4WD light
ST SIG
Seat heater
IG 2 SIG
Rear fog light
Dome
Rear defogger
Horn / Hazard
Fiat CODE (Immobilizer) FUSES UNDER THE DASH BOARD
Main fuse / Primary fuse
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 220

221
BULB REPLACEMENT
The fuses are also located under the dri-
ver’s side of the dashboard. Remove the
fuse box cover by pulling it off. The am-
perage of each fuse is shown on the top
of the fuse box cover.
Always be sure to replace a
blown fuse with a fuse of the
correct amperage. Never use a sub-
stitute such as aluminum foil or wire
to replace a blown fuse. If you re-
place a fuse and the new one blows
in a short period of time, you may
have a major electrical problem.
Have your vehicle inspected imme-
diately by your Fiat Dealership.
WARNING
65D046
OK
BLOWN
– Light bulbs can be hot
enough to burn your finger
right after being turned off. This is
true especially for halogen headlight
bulbs. Replace the bulbs after they
become cool enough.
– The headlight bulbs are filled with
pressurized halogen gas. They can
burst and injure you if they are hit or
dropped. Handle them carefully.
WARNING
IMPORTANT The oils from your skin may
cause a halogen bulb to overheat and burst
when the lights are on. Grasp a new bulb
with a clean cloth.
IMPORTANT Frequent replacement of a
bulb indicates the need for an inspection
of the electrical system. This should be
carried out by your Fiat Dealership.CENTER INTERIOR LIGHT
(for versions/markets, where provided)
Pull down the lens by using a plane screw
driver covered with a soft cloth as shown.
To install it, simply push it back in.
The bulb can be removed by simply pulling
it out. When replacing the bulb, make sure
that the contact springs are holding the
bulb securely.
60G115
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 221

222
HEADLIGHT
Open the engine food. Disconnect the
coupler (1). Remove the sealing rubber (2).
Push the retaining spring (3) forward and
unhook it. Then remove the bulb. Install
a new bulb in the reverse order of remo-
val.
(2)
(1)
(3)
80JM069
(3)
80JM113
(2)
(4)
(3)
(1)
79JM026
NOTE You can see the position of retai-
ning spring (3) from the hole of headlight.For Diesel Engine Model
To approach the air cleaner side head li-
ght:
❒ Loosen the bolt (1).
❒ Pull up the air cleaner (2) and pull out
the air cleaner hose (4) from the air
cleaner (2).
❒ Loosen the bolts (3) and remove the air
cleaner hose (4).
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 222

223
SIDE TURN SIGNAL LIGHT
As the bulb is built-in type, the light as-
sembly must be replaced. Remove the light
assembly by sliding the light housing left-
ward with your finger.
64J195
OTHER GENERAL LIGHTS
Bulb holder
1.Removal
2.Installation
To remove a bulb holder from a light
housing, turn the holder counterclockwise
and pull it out. To install the holder, push
the holder in and turn it clockwise.
(1)
(1) (2)(2)
54G123
(1)
(2) (3)
(4)
54G124
Bulb
3.Removal
4.Installation
There are two types of bulb, “Full glass
type” (1) and “Glass/ metal type” (2).
To remove and install a full glass type bulb
(1), simply pull out or push in the bulb.
To remove a glass metal type bulb (2)
from a bulb holder, push in the bulb and
turn it counterclockwise. To install a new
bulb, push it in and turn it clockwise.
You can access the individual bulb or bulb
holders as follows.
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 223

224
(1)(2)
80JM123
(1)
(2)
80JM11480JM071
(3)
79JM025
Front turn signal light (1)
Front position light (2)
Front fog light
(for versions/markets, where provided)
NOTE To replace the bulb easily, turn the
steering wheel to the opposite side of the
replacing fog light.
❒ Insert a flat blade screwdriver into the
hole (2) and remove the clips (1) by twi-
st the driver as shown in the illustration.
❒ Remove the bolts (3).❒ Open the fender cover. Disconnect the
coupler with pushing the lock release.
❒ Turn the bulb holder counterclockwi-
se and remove it.
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 224

225
80JM13180JM068
Rear combination light
(tail, stop, turn signal, etc.)Spot light
(for versions/markets, where provided)
Pull down the lens by using a flat blade
screwdriver covered with a soft cloth as
shown. To install it, simply push it back in.
75F087
License plate light
183-230 SEDICI LUM FL GB 1E 19-06-2009 11:00 Pagina 225