ECU FORD AEROSTAR 1996 1.G User Guide

63
*
[ST04625(ALL)06/95]
RWARNING
Always set the parking brake fully and
make sure the gearshift is securely latched
in P (Park).
*
[ST04750(ALL)01/93]
RWARNING
Do not leave children, unreliable adults,
or pets alone in your vehicle. They could
accidentally injure themselves or others
through inadvertent operation of the
vehicle. Further, on hot, sunny days,
temperatures in a closed vehicle could
quickly become high enough to cause
severe and possibly fatal injuries to
people as well as animals.
%*
[ST04775(ALL)03/91]
Ignition Key Buzzer or Chime
*
[ST04780(ALL)03/91]
The buzzer or chime will sound if you open the
driver's door while the key is in the ignition.
Never leave your vehicle unattended with the
key in the ignition.
%
*
[ST04800(ALL)03/95]
Fuel-Injected Engines
*
[ST04900(ALL)03/95]
When starting a fuel-injected engine,the most
important thing to remember is to avoid
pressing down on the accelerator before or
during starting. Only use the accelerator when
you have problems getting your vehicle started.
SeeStarting Your Enginein this chapter for
details about when to use the accelerator while
you start your vehicle.
File:04cpsta.ex
Update:Tue Aug 29 17:35:31 1995

79 [LG04750(ALL)08/95]
An example of a condition which corrects itself
occurs when an engine running out of fuel
begins to misfire. In this case, the Check Engine
Warning Light may turn on and will then set a
Diagnostic Trouble Code indicating that the
engine was misfiring while the last of the fuel
was being consumed. After refueling, the Check
Engine Warning Light will turn off after the
vehicle has completed three consecutive warm
up cycles without a mifire condition occurring.
A warm up cycle consists of engine start from a
cold condition (engine at ambient temperature)
and running until the engine reaches normal
operating temperature.
[LG04825(ALL)07/95]
On the fourth engine start up, the Check Engine
Warning Light will turn off as soon as the
engine begins to crank. It is not necessary to
have the engine serviced.
[LG04875(ALL)07/95]
Under certain conditions, the Check Engine
Warning Light may come on if the fuel cap is
not properly installed. If the Check Engine
Warning Light comes on and you suspect the
fuel cap is not properly installed, pull off the
road as soon as it is safely possible and turn off
the engine. Remove and replace the fuel cap,
making sure it is properly seated.
[LG04900(ALL)07/95]
After completing three consecutive warm-up
cycles and on the fourth engine start-up, the
Check Engine Warning Light should turn off. If
the light does not go off after the fourth engine
restart, have your vehicle serviced by your
dealer or a qualified technician.
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

132
*
[FV32200(ALL)12/91]
To install the rear bucket seat:
[FV32300(ALL)12/91]
1. Lift the seat assembly into the vehicle and
drop the front and rear floor hooks into the
floor wells at a point just behind the floor
attachment pins.
[FV32500(ALL)05/89]
2. Rotate the seat latch handle forward, causing
the J hook to engage over the front of the
foremost well retainer.
[FV32801(ALL)02/92]
3. For right hand seats, continue rotating the
seat latch handle until it comes to a
complete stop on the top of the tube. This
will cause the seat assembly to slide forward,
engaging the front and rear floor hooks with
the floor well retainers.
[FV32901(ALL)02/92]
For left hand seats, push the seat latch
handle downward to a full stop. This locks
the seat in position. Before you engage the
safety belt, be sure it is not twisted. Remove
any twist, then insert the tongue end of the
detachable anchor into the detachable anchor
until you hear a ªsnapº and feel the latch
engage.
*
[FV33300(ALL)05/95]
RWARNING
Check to see that the seat is latched
securely in position. Keep floor area free
of objects that would prevent proper seat
engagement. Never attempt to adjust the
seat latch while the vehicle is in motion.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

140 [FV36001(ALL)06/95]
half page art:0095041-AInstallation and removal of the second and third passenger
bed and bench seat
*
[FV38301(ALL)05/95]
RWARNING
Never adjust the driver's seat or seatback
when the vehicle is moving.
*
[FV38350(ALL)05/95]
RWARNING
Always latch the vehicle seat to the floor,
whether the seat is occupied or empty. If
not latched, the seat may cause injury
during a sudden stop.
*
[FV38401(ALL)05/93]
RWARNING
Before using the seat, make sure that the
latch hooks are securely locked around the
floor pins.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

157
*
[AS02575(ALL)08/95]
How to insert a disc and begin play
*
[AS02600(ALL)08/95]
Insert one disc,label side upinto the disc
opening. When inserted, the disc automatically
loads into the unit and play starts at the
beginning of the first track (selection).
*
[AS02625(ALL)08/95]
When the disc reaches the end, the disc player
automatically returns to the beginning of the
disc and resumes playing.
*
[AS02650(ALL)08/95]
NOTE: Once a disc is inserted, the disc
opening is secured to prevent the
accidental insertion of a second disc.
*
[AS02675(ALL)08/95]
NOTE: The CD player has heat protection
circuitry to protect the laser diode. If
the temperature of the player reaches
167ÊF (75ÊC), theheat detection circuit
will shut off the player and ªTOO
HOTº will scroll in the display for
approximately five seconds (radio will
resume playing). When the temperature
returns to normal operating range, the
CD player will again be operational.
*
[AS02700(ALL)08/95]
How to stop and restart the CD player
[AS02725(ALL)08/95]
When a disc is loaded, the unit automatically
enters the play mode and the play indicator (
a)
illuminates. To stop temporarily, press the
ªPLAY/STOPº button or the ªAM/FMº button.
The stop indicator (
X) in the display illuminates
and operation returns to the radio mode. To
resume CD play, press the ªPLAY/STOPº
button once again.
*
[AS02750(ALL)08/95]
NOTE: If the ignition key is turned OFF
during play and then is set to the ON
or ACCESSORY position, the CD
player will resume playing in the mode
it was in when ignition was turned off.
File:09cpasa.ex
Update:Tue Aug 29 17:42:51 1995

187
*
[DR06300(ALL)01/95]
Once you place the gearshift securely into
position, gradually release the brake pedal and
use the accelerator as necessary.
%*
[DR06310(ALL)01/95]
NOTE: Your vehicle is equipped with a
brake-shift interlock feature. This
feature prevents you from shifting
from P (Park) unless you have the
brake pedal depressed. (The ignition
must be in the ON position.) If you
cannot shift from P (Park) with the
brake pedal depressed:
*
[DR06320(ALL)01/95]
1. Apply the parking brake.
*
[DR06330(ALL)01/95]
2. Remove the key.
*
[DR06340(ALL)08/95]
3. Insert the key and rotate it one position
clockwise (ignition in the OFF position).
*
[DR06350(ALL)08/95]
4. Apply the brake pedal and shift to N
(Neutral). (If the vehicle is shifted back to P
[Park], you must repeat the previous steps.)
*
[DR06360(ALL)01/95]
5. Start the vehicle.
*
[DR06370(ALL)07/95]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledServicing Your Aerostar
in this Owner Guide for instructions on checking
and replacing fuses.
*
[DR06375(ALL)05/95]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
File:10cpdra.ex
Update:Tue Aug 29 17:45:28 1995

190
*
[DR07600(ALL)01/95]
P (Park)
[DR07700(ALL)06/92]
Always come to a complete stop before you shift
into P (Park). This position locks the
transmission and prevents the rear wheels from
turning.
[DR07800(ALL)06/92]
To securely latch the gearshift in the P (Park)
position, pull it toward you, push it completely
counterclockwise against the stop, and then push
it toward the instrument panel.
*
[DR08000(ALL)06/95]
RWARNING
Always set the parking brake fully and
make sure the gearshift is securely latched
in P (Park).
*
[DR08100(ALL)06/95]
RWARNING
Never leave your vehicle unattended
while it is running.
*
[DR08500(ALL)06/94]
Forced Downshifts
[DR08600(ALL)08/95]
To gain acceleration inj(Overdrive) or Drive
(jposition with Overdrive cancelled) when
passing another vehicle, push the accelerator to
the floor. The transmission will downshift to 2
(Second) gear or to 1 (First) gear at calibrated
speeds.
*
[DR11235(ALL)03/94]
Power Braking
*
[DR11275(ALL)03/94]
Increasing the engine speed above idle without
vehicle movement (such as holding the brake) in
a forward or reverse gear causes transmission
stall.
*
[DR11285(ALL)03/94]
NOTE: Continued operation in the stall
condition can result in transmission
overheat, malfunction or fluid
expulsion.
File:10cpdra.ex
Update:Tue Aug 29 17:45:28 1995

204
*
[DR29151(ALL)01/95]
q
Use extra caution when driving your vehicle
while you tow. (SeeDriving while you towin
this chapter.)
*
[DR29201(ALL)01/95]
q
Service your vehicle more frequently if you
tow a trailer. (SeeServicing your vehicle if you
towin this chapter.)
[DR29250(ALL)03/90]
Standard length vehicles adapted for trailer tow
may require relocation of the underbody spare
tire. It is recommended that you secure the tire
under the rear-most seat using the hold-down
hardware located with the jack.
[DR29301(ALL)03/91]
one third page art:0020268-A
Spare tire stowage (standard length model)
*
[DR29350(ALL)05/94]
Do not tow a trailer until your vehicle has been
driven at least 500 miles (800 km).
File:10cpdra.ex
Update:Tue Aug 29 17:45:28 1995

206 [DR29510(ALL)08/95]
RWARNING
Do not allow people to ride in any area of
the vehicle that is not equipped with seats
and safety belts.
[DR29520(ALL)08/95]
RWARNING
Be sure everyone in your vehicle is in a
seat and using a safety belt properly.
*
[DR29525(ALL)07/95]
RWARNING
Cargo should always be secured to
prevent it from shifting and causing
damage to the vehicle or harm to
passengers.
*
[DR29551(ALL)03/91]
Each additional item of equipment affects how
much cargo a vehicle can carry. If a vehicle is
overloaded, performance will suffer and service
concerns may arise.
File:10cpdra.ex
Update:Tue Aug 29 17:45:28 1995

223
*
[DR40600(ALL)01/93]
To start, after being parked on a grade:
*
[DR40700(ALL)05/95]
q
Apply the brake pedal and hold.
*
[DR40800(ALL)08/95]
q
Start the engine.
*
[DR40900(ALL)08/95]
q
Shift transmission into gear and release the
parking brake.
*
[DR41000(ALL)08/95]
q
Release the brake pedal and move the vehicle
uphill to free the wheel chocks.
*
[DR41100(ALL)05/95]
q
Apply the brake pedal and hold while
another person retrieves the chocks.
[DR41200(ALL)08/95]
Luggage Rack (If equipped)
[DR41300(ALL)08/95]
Always distribute your luggage load evenly. Do
not load more than 100 pounds (45 kg) onto
rack or cause the vehicle to exceed the Gross
Vehicle Weight Rating (GVWR).
[DR41400(ALL)08/95]
The crossbars and cross slats are adjustable.
Loosen the adjustment screws, slide the bars and
slats as necessary, and retighten the screws.
[DR41500(ALL)08/95]
RWARNING
Be sure that items on the roof rack are
securely fastened.
[DR41600(ALL)08/95]
Use caution to avoid scratching the paint. Drive
carefully and avoid sudden starts and stops.
File:10cpdra.ex
Update:Tue Aug 29 17:45:28 1995