ignition FORD AEROSTAR 1996 1.G User Guide

77 %
*
[LG04150(ALL)07/95]
Safety Belt Warning Light and Chime
[LG04301(ALL)03/95]
This warning light and chime remind you to
fasten your safety belt. One of the following will
take place:
*
[LG04325(ALL)03/95]
q
If the safety belt is not buckled when the key
is turned to the ON position, the light comes
on for 1 to 2 minutes and the chime sounds
for 4 to 8 seconds.
*
[LG04351(ALL)02/95]
q
If the safety belt is buckled while the light is
on and the chime is sounding, both the light
and chime turn off.
*
[LG04365(ALL)05/95]
q
If the safety belt is buckled before the
ignition is turned to the ON position, neither
the light nor the chime will come on.
*
[LG04400(ALL)10/92]
one inch art:0020046-B
Safety belt warning light symbol
%*
[LG04425(ALL)03/95]
Door Ajar Light and Chime
[LG04450(ALL)03/95]
This light turns on along with an audible chime
if one of the doors is not completely shut when
you turn the ignition to the ON position.
[LG04475(ALL)05/95]
one inch art:0020787-A
Door ajar light
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

78 %
*
[LG04500(ALL)03/95]
Check Engine Warning Light
*
[LG04550(ALL)05/95]
The Powertrain On-Board Diagnostic II (OBD II)
system consists of the hardware and software
necessary to monitor the operation of the
powertrain. The OBD II system is designed to
check the function of the vehicle's powertrain
control system during normal operation. If an
emission problem is detected, the Check Engine
Warning Light (in the cluster) is turned on.
*
[LG04575(ALL)05/95]
Modification or additions to the vehicle may
cause incorrect operation of the OBD II system.
Additions such as burglar alarms, cellular
phones, and CB radios must be carefully
installed. Do not install these devices by tapping
into or running wires close to powertrain control
system wires or components.
[LG04600(ALL)07/95]
The light comes on briefly when you turn the
ignition key to the ON position, but it should
turn off when the engine starts. If the light does
not come on when you turn the ignition to ON
or if it comes on and stays on when you are
driving, have your vehicle serviced as soon as
possible. This indicates a possible problem with
one of the vehicle's emission control systems.
You do not need to have your vehicle towed in.
[LG04650(ALL)08/95]
If the light turns on and off at one (1) second
intervals while you are driving the vehicle, it
means that the engine is misfiring. If this
condition persists, damage could occur to the
engine or catalytic convertor. Have your vehicle
serviced at the first opportunity. You do not
need to have your vehicle towed in.
[LG04700(ALL)08/95]
If the light turns on and off on rare occasions
while you are driving, it means that a
malfunction occurred and the condition corrected
itself.
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

80
*
[LG05300(ALL)05/95]
one inch art:0020048-A
Check engine warning light symbol
[LG05525(ALL)03/94]
Electronic 4-Wheel Drive Warning Light
(If equipped)
[LG05550(ALL)03/95]
The Electronic 4-Wheel Drive Warning Light
turns on when the Electronic 4-Wheel Drive
system is not working properly. This light comes
on briefly when you turn the ignition key to the
ON position, but should turn off when the
engine starts. If the light does not come on when
you turn the ignition to the ON position, or if it
comes on and stays on when you are driving,
have your vehicle serviced as soon as possible.
[LG05560(ALL)03/94]
The 4WD light will go off after a few seconds
and stay off if all systems are operating
correctly. If a problem is detected, the 4WD
warning light will flash a certain number of
times indicating the location of the problem. The
flashing will continue until the problem is
corrected. Each time the ignition key is turned
on the controller will detect the problem and
flash the signal. The 4WD system remains safe to
operate and the vehicle should be returned for
service.
[LG05575(ALL)03/94]
one inch art:0020529-B
Electronic 4-wheel drive warning light
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

81 %
*
[LG05900(ALL)01/95]
Charging System Light
*
[LG06000(ALL)03/95]
This light indicates that your battery is not being
charged and that you need to have the electrical
system checked.
[LG06050(ALL)05/95]
one inch art:0095040-A
Charging system light
*
[LG06100(ALL)07/95]
This light comes on every time you turn the
ignition to the ON or START position (engine
off). The light should go off when the engine
starts and the alternator begins to charge.
*
[LG06300(ALL)01/95]
If the light stays on or comes on when the
engine is running, have the electrical system
checked as soon as possible.
%*
[LG06305(ALL)06/93]
Supplemental Air Bag Readiness Light and
Tone Generator
*
[LG06310(ALL)06/93]
This light illuminates for six seconds when the
ignition is turned to the ON position. If the light
fails to illuminate, continues to flash, remains on,
or if a series of five beeps is heard, have the
system serviced as soon as possible.
*
[LG06315(ALL)05/95]
one inch art:0020778-B
Supplemental air bag readiness light
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

82 %
*
[LG06400(ALL)05/94]
Battery Voltage Gauge (Voltmeter)
*
[LG06601(ALL)05/94]
This gauge shows you the battery voltage when
the ignition key is in the ON position.
*
[LG06700(ALL)11/89]
If you are running electrical accessories (when
the engine is off, or idling at a low speed), the
pointer may move toward the lower end of the
normal band. If it stays outside the normal band
area, have your vehicle's electrical system
checked as soon as it is safely possible.
*
[LG06701(ALL)05/95]
If the battery is operating under cold weather
conditions, the pointer may indicate in the upper
range of the NORMAL band while the battery is
charging. If you are running electrical accessories
with the engine off or idling at a low speed, or
the battery is not fully charged, the pointer may
move toward the lower end of the NORMAL
band.
*
[LG06750(ALL)05/94]
If it stays outside the NORMAL band, have your
vehicle's electrical system checked as soon as it
is safely possible.
*
[LG06900(ALL)03/93]
quarter page art:0020052-D
Battery voltage gauge
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

84 %
*
[LG08900(ALL)01/95]
High Beam Light
*
[LG09001(ALL)03/95]
This light comes on when the headlamps are
turned to high beam or when you flash the
lights.
*
[LG09025(ALL)11/89]
one inch art:0020537-B
High beam indicator light
%*
[LG09300(ALL)05/95]
Chime for Headlamps On
[LG09400(ALL)07/95]
This chime sounds if the driver or passenger
door is open when the parking lamps or
headlamps are on. The chime sounds until you
close the door, turn off the lamps or turn the
ignition to the ON position.
[LG09450(ALL)12/91]
NOTE: The chime will not sound when the
autolamp has activated the shutoff
delay.
%*
[LG09500(ALL)01/95]
Fuel Gauge
*
[LG09700(ALL)06/93]
The fuel gauge displays approximately how
much fuel is in the fuel tank only when the
ignition switch is ON.
*
[LG09850(ALL)01/95]
For a proper fuel gauge indication after adding
fuel, the ignition switch should be in the OFF
position while the vehicle is being refueled.
*
[LG09900(ALL)01/95]
The fuel gauge indicator may vary slightly while
the vehicle is in motion. This is the result of fuel
movement within the tank. An accurate reading
may be obtained with the vehicle on smooth,
level ground.
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

110
*
[SC01800(ALL)11/89]
If the turn indicator light in the instrument
panel does not illuminate or remains on (doesn't
flash) when you signal a turn, the turn signaling
system is malfunctioning. Have this condition
corrected as soon as possible, but make sure that
you use the accepted hand signals in the
meantime.
%*
[SC03200(ALL)03/95]
High Beams and Flashing the Lamps
[SC03800(ALL)05/95]
one third page art:0095014-A
Headlamp high beam and flash-to-pass operation
%*
[SC04400(ALL)03/95]
Windshield Wipers and Washer
*
[SC04500(ALL)03/95]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
[SC04950(ALL)05/95]
one third page art:0095015-A
Interval wiper on turn signal lever Ð wiper and washer
operation
File:07cpsca.ex
Update:Tue Aug 29 17:38:34 1995

127
%*
[FV19250(ALL)02/95]
Windows
[FV20500(ALL)01/89]
Sliding side windows
[FV20700(ALL)08/95]
one third page art:0020207-B
Opening the sliding side window
%*
[FV22901(ALL)03/91]
Using the Power Windows (If equipped)
[FV23001(ALL)06/95]
Each front door has a power control that opens
and closes the window on that door. The
driver's door has a master control switch that
operates both front door windows. You must
place the ignition switch in the ON or ACC
position to use your power window controls.
*
[FV23401(ALL)08/95]
RWARNING
When driving your vehicle make sure that
the liftgate door and window are closed to
prevent exhaust fumes from being drawn
into the vehicle. This will also prevent
cargo from falling out.
*
[FV23501(ALL)07/95]
RWARNING
Do not let children play with the power
windows. They may seriously hurt
themselves. Make sure occupants are clear
of the window(s) before closing.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

150
%*
[AS00250(ALL)08/95]
Compact Disc Radio
*
[AS00300(ALL)08/95]
The Compact Disc Radio combines the Electronic
Stereo Radio with the Ford Compact Disc Player.
*
[AS00350(ALL)08/95]
Using the Controls on Your New Radio/CD
Player
*
[AS00400(ALL)08/95]
Most of the features of this unit work for both
radio and CD operation. Also, some of the knobs
and buttons control several different functions,
so be sure to read all of the operating
instructions carefully.
*
[AS00450(ALL)08/95]
How to turn the radio on and off
*
[AS00500(ALL)08/95]
Press the ªPOWERº button to turn the radio on.
Press it again to turn it off.
*
[AS00550(ALL)08/95]
How to adjust the volume
[AS00600(ALL)08/95]
Press the (+/s) end of the ªVOLº button to
increase/decrease the volume. Bars illuminate in
the display to show the relative volume level.
*
[AS00650(ALL)08/95]
NOTE: If the volume level is set above a
certain listening level when the
ignition switch is turned off, when the
ignition switch is turned back on, the
volume will come back to a ªnominalº
listening level. However, if the radio
power is turned off, the volume will
remain in the position it was set at
when radio power was switched off.
*
[AS00700(ALL)08/95]
Selecting the AM or FM frequency band
*
[AS00750(ALL)08/95]
Push the ªAM/FMº button to select the desired
frequency band. When in the radio mode,
pushing the button more than once will alternate
between AM, FM1 and FM2. These functions are
used with the station memory buttons described
underHow to tune radio stations.
File:09cpasa.ex
Update:Tue Aug 29 17:42:51 1995

155
*
[AS02200(ALL)08/95]
q
Adjusting speaker fader
*
[AS02250(ALL)08/95]
Fade control allows you to adjust the sound
distribution between the front and rear
speakers. Push the ªAUDIOº button
repeatedly until the display reads ªFADE.º
Push the ª+º side of the ªVOLº button to
shift the sound to the front speakers, and
push the ª-º side to shift the sound to the
rear speakers.
*
[AS02275(ALL)08/95]
NOTE: Illuminated bars in the display show
relative levels of bass and treble and
positions of speaker balance and fader
functions after adjustments are made,
then revert to volume level set.
%*
[AS02300(ALL)08/95]
Clock operation
[AS02325(ALL)08/95]
When in the radio mode, push the ªCLOCKº
button to switch from radio frequency to clock.
Only the clock numerals will be displayed in the
clock mode Ð there is no AM/PM indication.
When in the clock mode, the time will be
displayed until the button is pushed again.
However, if you retune the radio while it is in
the clock mode, the new radio frequency will be
displayed for approximately ten seconds and
then change back to clock display.
*
[AS02350(ALL)08/95]
When in the CD mode, push the ªCLOCKº
button to change the display from elapsed time
mode to track number mode to clock mode. If
the CD track selection is changed when you are
in the clock or elapsed time mode, the new track
number will be displayed for approximately ten
seconds and then revert back to the previous
mode.
*
[AS02375(ALL)08/95]
The clock can also be viewed with the ignition
off. Push the ªCLOCKº button and the time will
be displayed momentarily.
File:09cpasa.ex
Update:Tue Aug 29 17:42:51 1995