jacking FORD AEROSTAR 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: AEROSTAR, Model: FORD AEROSTAR 1996 1.GPages: 353, PDF Size: 2.87 MB
Page 217 of 353
237
*
[RE15100(ALL)05/95]
RWARNING
Make sure the spare tire and jacking
equipment are stowed and secured in the
proper storage location.
%*
[RE15200(ALL)03/95]
Preparing to Change the Tire
*
[RE15250(ALL)12/91]
NOTE: To lift your vehicle by other than the
front or rear jacking points, be sure to
use only hoist adapters with a wide
contact surface.
*
[RE15325(ALL)03/95]
1. Make sure that your vehicle will not move
or roll. Put the gearshift in P (Park). Set the
parking brake and block the wheel that is
diagonally opposite the tire that you are
changing.
*
[RE15335(ALL)12/91]
NOTE: Make sure the ignition is in the OFF
position.
*
[RE15420(ALL)06/95]
When one of the back wheels is off the ground,
the transmission alone will not prevent the
vehicle from moving or slipping off the jack,
even if the vehicle is in P (Park). To prevent the
vehicle from moving when you change a tire, be
sure the parking brake is set, then block the
wheel (both directions) that is diagonally
opposite (other side and end of the vehicle) to
the tire being changed.
*
[RE15430(ALL)05/95]
RWARNING
If the vehicle slips off the jack, you or
someone else could be seriously injured.
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995
Page 219 of 353
239
*
[RE16800(ALL)12/91]
3. Use the tapered end of the lug nut wrench
to unscrew wheel ornaments attached by
retaining screws. Remove any wheel trim.
Insert the tapered end of the lug nut wrench
behind wheel covers or hubcaps and twist
off.
*
[RE16900(ALL)10/89]
4. Loosen the wheel nuts by pulling up on the
handle of the lug nut wrench about one-half
turn (counterclockwise). Do not remove the
wheel lug nuts until you raise the tire off the
ground.
[RE17000(ALL)02/95]
5. Unfold the jack handle and lock into the
jack. Use the jack handle to slide the jack
under the vehicle.
%*
[RE17100(ALL)05/95]
Removing and Replacing the Tire
%*
[RE17300(ALL)06/95]
1. Positioning the jack
[RE17400(ALL)02/89]
a. To raise a front wheel, place the jack
under a horizontal portion of the
underbody member behind the wheel, as
shown.
[RE17500(ALL)01/89]
one third page art:0020293-A
Front jacking point
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995
Page 220 of 353
240 [RE17600(ALL)01/89]
b. To raise a rear wheel, place the jack
under a horizontal portion of the
underbody member ahead of the wheel
as shown.
[RE17700(ALL)01/89]
one third page art:0020294-A
Rear jacking point
[RE17800(ALL)01/89]
c. Turn the jack handle clockwise until the
wheel is completely off the ground.
[RE17900(ALL)05/91]
RWARNING
Never place the jack under the rocker
panels.
*
[RE21151(ALL)10/92]
one third page art:0020939-B
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995