manual transmission FORD AEROSTAR 1997 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: AEROSTAR, Model: FORD AEROSTAR 1997 1.GPages: 347, PDF Size: 1.79 MB
Page 168 of 347
168
%*
[GF04000(ALL)01/96]
Steering Your Vehicle
%*
[GF04100(ALL)01/96]
Your vehicle comes with power steering. Power
steering uses energy from the engine to help
steer your vehicle.
%*
[GF04150(ALL)03/96]
If the amount of effort needed to steer your
vehicle changes at a constant vehicle speed, have
the power steering system checked. If the power
steering system breaks down (or if the engine is
turned off), you can steer the vehicle manually
but it takes more effort.
*
[GF04200(ALL)01/96]
Never hold the steering wheel to the extreme
right or left for more than five seconds if the
engine is running. This can damage the power
steering pump.
*
[GF04300(ALL)01/96]
NOTE: After any severe impact such as
striking large potholes, sliding into
curbs on icy roads, or a collision
involving the front end, observe the
steering wheel alignment. If the spokes
of the steering wheel seem to be in a
different position while going straight
down the road, have the front
suspension and steering checked for
possible damage.
[GF10000(ALL)03/96]Automatic Transmission
Operation (4R44E/5R55E)
[GF10050(ALL)06/96]
If your vehicle is equipped with an automatic
transmission, it will be either a four speed
overdrive transmission (4R44E) or a five speed
overdrive transmission (5R55E). All 3.0L engines
use the 4R44E transmission, while all 4.0L
engines use the 5R55E transmission. Both
transmission types have a lockup torque
converter. Transmission operation is controlled
by the Powertrain Control Module (PCM).
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996
Page 173 of 347
173
*
[GF12870(ALL)05/96]
RWARNING
Never leave your vehicle unattended
while it is running.
%*
[GF12900(ALL)05/96]
R (Reverse)
*
[GF12950(ALL)05/96]
With the gearshift in the R (Reverse) position,
the vehicle will move backward. You should
always come to a complete stop before shifting
into or out of R (Reverse).
*
[GF12975(ALL)01/96]
N (Neutral)
*
[GF12990(ALL)06/96]
With the gearshift in the N (Neutral) position,
the vehicle can be started and is free to roll.
Hold the brake pedal down while in this
position.
*
[GF12995(ALL)06/96]
RWARNING
Do not leave the vehicle unattended with
the transfer case in the N (Neutral)
position. Always set the parking brake
fully and turn off the ignition when
leaving the vehicle.
*
[GF13000(ALL)06/96]
With the transfer case in N (Neutral), the vehicle
is free to move with either the automatic
transmission in P (Park) or with the manual
transmission in any driving gear.
[GF13050(ALL)03/96]
Driving (4R44E Transmission)
%*
[GF13100(ALL)05/96]
When to usej(Overdrive)
*
[GF13150(ALL)05/96]
This is the normal driving position. As the
vehicle picks up speed, automatic upshifts to
second, third and fourth gears will occur when
jOverdrive is chosen on the selector and the
transmission control switch has not been
pressed. The transmission will shift into the
correct gear when the right speed is achieved,
for the accelerator pedal position you have
chosen.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996
Page 175 of 347
175
*
[GF13400(ALL)05/96]
When to use 2 (Second)
*
[GF13450(ALL)05/96]
Use 2 (Second) to start-up on slippery roads or
to provide additional engine braking on
downgrades. This position provides 2 (Second)
gear operation only.
*
[GF13475(ALL)05/96]
When to use 1 (Low)
*
[GF14000(ALL)05/96]
Use 1 (Low) to provide maximum engine
braking on steep downgrades. Upshifts from 1
(Low) can be made by manually shifting to 2
(Second) orj(Overdrive). Selection of 1 (Low)
gear provides only low gear operation from
start-up. Selection of 1 (Low) while at higher
speeds provides a shift to second gear, and a
shift to first gear will occur after the vehicle
decelerates to the proper speed.
*
[GF14500(ALL)05/96]
Forced Downshifts
[GF14550(ALL)03/96]
To gain acceleration inj(Overdrive) or Drive
(jposition with Overdrive cancelled) when
passing another vehicle, push the accelerator to
the floor. The transmission will downshift to the
appropriate gear: third, second or first.
[GF14600(ALL)03/96]
Driving (5R55E Transmission)
[GF14650(ALL)05/96]
When to usej(Overdrive)
*
[GF14700(ALL)05/96]
This is the normal driving position. As the
vehicle picks up speed, automatic upshifts to
second, third, fourth and fifth gears will occur
whenj(Overdrive) is chosen on the selector
and the transmission control switch has not been
pressed. The transmission will shift into the
correct gear when the right speed is achieved,
for the accelerator pedal position you have
chosen.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996
Page 338 of 347
Index 347
Lights, warning and indicator (continued)
engine oil pressure........... 16
hazard warning light........ 78,199
high beam............... 14
oil pressure.............. 16
safety belt............... 11
service engine soon........... 12
turn signal indicator.......... 75
Load limits
GAWR................ 179
GVWR................ 179
trailer towing............. 181
Lubricant specifications......... 296
Lug nuts
standard............... 219
tightening sequence........216, 221
Lumbar support, seats.......... 106
Lumbar support pad.......... 106
M
Maintenance schedule and record
(see separate Maintenance Schedule
and Record booklet).......... 3
Maintenance (see Servicing)....... 229
Manual transmission
fluid capacities............ 294
lubricant specifications........ 296
Master cylinder, brakes......... 236
Methanol in fuel............ 265
Mileage, calculating fuel economy.... 268
Mirrors
dual electric remote control....... 91
rearview................ 91
side view mirrors............ 91
side view mirrors (power)........ 91
Motorcraft parts............. 293
File:cpixa.ex
Update:Fri Jun 7 14:33:41 1996