flat tire FORD AEROSTAR 1997 1.G Owners Manual

125
*
[SS11650(ALL)05/96]
NOTE: For additional important safety
information on the proper use of seat
belts, child seats, and infant seats,
please read the entire Safety Restraints
chapter in this owner guide.
%*
[SS11700(ALL)05/96]
How Does the Air Bag Supplemental
Restraint System Work?
*
[SS11800(ALL)05/96]
The Air Bag Supplemental Restraint System is
designed to activate when the vehicle sustains
sufficient longitudinal (lengthwise) deceleration
that is equal to or greater than hitting an
immovable barrier head on at a range of about
8-14 mph (13-23 km/h). The fact that the air
bags did not inflate in a collision does not mean
that something is wrong with the system.
Rather, it means the forces were not of the type
sufficient to cause activation.
*
[SS11900(ALL)05/96]
If the vehicle is in a moderate or severe frontal
collision, the system is activated and the air bags
inflate rapidly. After the air bag inflates, it will
quickly deflate. After the air bag deployment,
you may notice a smoke-like, powdery residue
or smell the burnt propellant. This is normal.
The residue may consist of cornstarch or talcum
powder (which is used to lubricate the air bag)
or sodium compounds, such as sodium
carbonates (e.g. baking soda) that result from the
combustion process that inflates the air bag.
Small amounts of sodium hydroxide may be
present which may irritate the skin and eyes, but
none of the residue is toxic. The Air Bag
Supplemental Restraint System will reduce, but
not eliminate all injuries in an accident.
*
[SS12000(ALL)05/96]
RWARNING
Several air bag system components get hot
after inflation. Do not try to touch them
after inflation.
File:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996

178 [GF16025(ALL)01/96]How the Electronic 4-Wheel Drive (E-4WD)
System Works
[GF16036(ALL)01/96]
Under normal driving conditions, when the road
is firm, dry and level, the engine power is
distributed one-third to the front axle and
two-thirds to the rear axle. However, if a wheel
begins to slip, the microprocessor will sense this
condition and signal the system to transmit more
power to the axle with more traction. (You may
feel a momentary surge of power.)
[GF16046(ALL)01/96]
NOTE: The microprocessor is disabled when
the brakes are applied or when the
transmission selector is in the P (Park)
or N (Neutral) positions.
[GF16055(ALL)01/96]
Driving Your Electronic 4-Wheel Drive
(E-4WD) Vehicle
[GF16065(ALL)01/96]
Since your E-4WD vehicle is unique, follow these
steps to be safe:
[GF16075(ALL)01/96]
q
Avoid unnecessary turns or other maneuvers
that could cause loss of control and possible
injury.
[GF16076(ALL)01/96]
q
Use the same size and type of tire and wheel
as originally provided for your vehicle and
inflate the tires to the manufacturer's
recommended air pressure.
[GF16077(ALL)01/96]
q
Become familiar with your vehicle's operating
characteristics and study this Owner Guide
for specific operating instructions. Be sure all
occupants wear the safety belts provided.
Drive cautiously, defensively, and at speeds
safe for current road conditions.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

181 [GF29250(ALL)01/96]
Standard length vehicles adapted for trailer tow
may require relocation of the underbody spare
tire. It is recommended that you secure the tire
under the rear-most seat using the hold-down
hardware located with the jack.
[GF29301(ALL)01/96]
one third page art:0020268-A
Spare tire stowage (standard length model)
*
[GF29350(ALL)01/96]
Do not tow a trailer until your vehicle has been
driven at least 500 miles (800 km).
%
*
[GF29401(ALL)01/96]
Vehicle Loading/Towing
Information
*
[GF29450(ALL)01/96]
Your vehicle's load capacity is designated by
weight, not volume, so you cannot necessarily
use all available space with large or heavy loads.
Maximum safe vehicle weights as well as tire,
rim sizes and inflation pressures are specified for
your vehicle at the assembly plant on the Safety
Compliance Certification Label. The Certification
Label is located on the left front door lock facing
or the door latch post pillar.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

186
*
[GF31110(ALL)03/96]
With the tires inflated to the specified pressure,
the total weight of your vehicle must not exceed
the GVWR and GAWR specified on the Safety
Compliance Certification Label. This includes full
fuel tank(s), vehicle equipment, and occupants as
well as the cargo load.
*
[GF31120(ALL)01/96]
GCWR (Gross Combined Weight Rating)
*
[GF31130(ALL)01/96]
GCWR is the maximum combined weight of the
towing vehicle (including passengers and cargo)
and the loaded trailer. The GCWR is specified
by the manufacturer to indicate the combined
maximum loaded weight that the vehicle is
designed to tow.
*
[GF31140(ALL)01/96]
Maximum Trailer Weight Rating
*
[GF31150(ALL)01/96]
The maximum trailer weight rating is the
maximum weight of a trailer the vehicle is
permitted to tow. It is specified by the
manufacturer and is determined by subtracting
the vehicle curb weight for each
engine/transmission combination, any required
option weight for trailer towing and the weight
of the driver from the GCWR for the towing
vehicle.
*
[GF31160(ALL)01/96]
Maximum Trailer Weight
*
[GF31170(ALL)01/96]
The maximum trailer weight is the maximum
weight of a trailer the loaded vehicle is
permitted to tow. It is determined by subtracting
the weight of the loaded towing
vehicle (including passengers and cargo) from
the GCWR for the towing vehicle.
*
[GF31180(ALL)01/96]
Trailer Weight Range
*
[GF31190(ALL)01/96]
The trailer weight range is a specified range by
weight, which the trailer must fall within,
ranging from zero to the maximum trailer
weight rating.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

209 %
*
[ER00510(ALL)05/96]
Circuit Breakers
[ER00515(ALL)01/96]
If you need to check a circuit breaker, locate the
fuse panel first. Otherwise, locate the circuit
breaker according to the instructions on the
charts given earlier in this chapter.
*
[ER00520(ALL)01/96]
However, you should know that the circuit
breakers will reset themselves and allow the
electrical parts to work again once the overload
on the circuit is removed. If the circuit breakers
continue to cut off electricity, have your vehicle's
electrical system checked.
*
[ER00525(ALL)01/96]
Diagnostic equipment is needed to check circuit
breakers. Refer to the manufacturer's
instructions.
[ER00530(ALL)01/96]
If you replace a circuit breaker, use one with the
same amperage rating. To remove a circuit
breaker, grip it with your finger and thumb and
pull it straight out of its socket.
%
*
[ER03600(ALL)02/96]
Changing a Tire
*
[ER03700(ALL)02/96]
If you get a flat tire while you are driving, do
not apply the brake heavily. Instead, gradually
decrease the speed. Hold the steering wheel
firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off
the ignition, set the parking brake, and turn on
the hazard flashers.
%*
[ER03800(ALL)01/96]
The Conventional Spare Tire
*
[ER03900(ALL)05/96]
If you have the conventional spare tire, you can
use it as a spare or as a regular tire. This spare
tire is identical to the other tires that come with
your vehicle, although the wheel may not match.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

210 %
*
[ER04000(ALL)02/96]
The Temporary Spare Tire
%*
[ER04100(ALL)02/96]
You may have a high pressure temporary spare
tire. This spare tire is smaller than a regular tire
and is designed for emergency use only. Use it
only when you get a flat tire and replace it as
soon as you can. This spare tire is marked with
the words ªTEMPORARY USE ONLYº so that
you can easily identify it.
*
[ER04200(ALL)02/96]
RWARNING
If you use the temporary spare tire
continuously or do not follow these
precautions, the tire could fail, causing
you to lose control of the vehicle, possibly
injuring yourself or others.
[ER04250(ALL)01/96]
RWARNING
The tire size on the E-4WD must be
maintained.
[ER04260(ALL)01/96]
Your vehicle may have a full diameter mini
spare or a full size tire. This full diameter mini
spare is special for the E-4WD and another mini
spare from another vehicle can not be
substituted without the possibility of damage to
your vehicle. All tires should be inflated to the
manufacturer's recommended pressures.
*
[ER04275(ALL)05/96]
RWARNING
To avoid injury, never run the engine
with one wheel off the ground, such as
when changing a tire.
*
[ER04280(ALL)01/96]
Extended use of other than matching size spare
tires on a Traction-Lok axle could result in a
permanent reduction in effectiveness. This loss of
effectiveness does not affect normal driving and
should not be noticeable to the driver.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

211
*
[ER04300(ALL)02/96]
When you drive with the temporary spare tire,
DO NOT:
*
[ER04400(ALL)02/96]
q
exceed 50 mph (80 km/h) under any
circumstances.
*
[ER04500(ALL)02/96]
q
load your vehicle so that it is heavier than
the maximum vehicle load rating listed on
the tire decal.
*
[ER04600(ALL)02/96]
q
tow a trailer.
*
[ER04700(ALL)02/96]
q
use tire chains on this tire.
*
[ER04800(ALL)02/96]
q
try to repair the temporary spare tire or
remove it from its wheel.
*
[ER04900(ALL)02/96]
q
use the wheel for any other type of vehicle.
*
[ER05000(ALL)02/96]
q
drive through an automatic car wash with
this tire. Because the temporary spare tire is
smaller than a conventional tire, it reduces
the ground clearance. Your vehicle may get
caught in the rails and it could be damaged.
%*
[ER05100(ALL)02/96]
Spare Tire Location
[ER05200(ALL)01/96]
If your vehicle is a standard length van model,
the spare tire is mounted inside a carrier at the
left rear quarter panel. To remove the spare tire,
remove the wing nut and plate. A flat tire can
be temporarily stowed in the same location.
[ER05300(ALL)01/96]
quarter page art:0020264-A
A side mounted spare tire
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

214 [ER06300(ALL)01/96]3. Rotate wrench clockwise until tire is secured.
(Raising mechanism will slip.)
[ER06400(ALL)04/96]
4. Check for proper seating against underbody
supports and retighten if necessary.
[ER06500(ALL)01/96]
half page art:0020266-B
Spare tire Ð underbody carrier
[ER06600(ALL)01/96]
RWARNING
Do not stow any conventional spare tire
or flat temporary spare tire in the
underbody position. Doing so may cause
damage to the tire, rear axle, or brake
lines. (Standard length only)
[ER06800(ALL)01/96]
A flat tire can be temporarily secured to the
floor pan under the rear-most seat. To
temporarily secure a flat tire:
[ER06900(ALL)01/96]
1. Remove the spare tire ªJº bolt, plate and
wing nut from their stowed location on the
jack.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

215 [ER07000(ALL)01/96]
2. Position the flat tire, valve stem up, under
the rear-most seat and over the ªJº bolt
attaching bracket on the floor pan.
[ER07100(ALL)01/96]
3. Insert the ªJº hook bolt through the center of
the wheel and hook on bracket.
[ER07200(ALL)01/96]
4. Install plate over ªJº hook bolt and secure
with wing nut.
[ER07300(ALL)01/96]
quarter page art:0020267-A
A Stowed position of ªJº bolt, plate and wing nut
(Standard length model)
[ER07400(ALL)01/96]
one third page art:0020268-A
Flat tire stowage (Standard length model)
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

216 [ER07600(ALL)01/96]
half page art:0020270-AExtended van underbody outside spare wheel/flat tire
storage
*
[ER15100(ALL)01/96]
RWARNING
Make sure the spare tire and jacking
equipment are stowed and secured in the
proper storage location.
%*
[ER15200(ALL)03/96]
Preparing to Change the Tire
*
[ER15250(ALL)01/96]
NOTE: To lift your vehicle by other than the
front or rear jacking points, be sure to
use only hoist adapters with a wide
contact surface.
*
[ER15325(ALL)03/96]
1. Make sure that your vehicle will not move
or roll. Put the gearshift in P (Park). Set the
parking brake and block the wheel that is
diagonally opposite the tire that you are
changing.
*
[ER15335(ALL)01/96]
NOTE: Make sure the ignition is in the OFF
position.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996