warning FORD ASPIRE 1997 1.G Owner's Guide

80
*
[SS17010(ALL)03/96]
WARNING
Carefully follow all of the manufacturer's
instructions included with the safety seat
you put in your vehicle. If you do not
install and use the safety seat properly,
the child may be injured in a sudden stop
or collision.
*
[SS17025(ALL)01/96]
If you choose to install a child safety seat in the
front seat, move the seat as far back as possible.
[SS17050(ALL)04/96]
1. Position the child seat on the passenger seat
of the vehicle.
*
[SS17075(ALL)02/96]
2. Pull down on shoulder belt, then grasp
shoulder belt and lap belt together. See
Figure 1.
[SS17125(ALL)02/96]
half page art:0032244-C
Grasping the shoulder and lap belt together
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

82 [SS17160(ALL)03/96]
half page art:0032270-BBuckling the belt
*
[SS17190(ALL)01/96]
WARNING
Failure to follow all instructions on the
proper use of child seats or the vehicle
restraint systems can result in serious
injury or death in the event of a sudden
stop or collision.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

85 [SS17400(ALL)01/96]
half page art:0032246-C
Removing slack from the belt
*
[SS17450(ALL)05/96]
WARNING
Rear-facing child seats or infant carriers
should never be placed in the front seats.
*
[SS17500(ALL)02/96]
6. Before placing the child in the child seat,
forcibly tilt the seat from side to side, and
tug it forward to make sure that the seat is
securely held in place. See Figure 7.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

88
*
[SS20650(ALL)01/96]
Tether Anchorage Hardware
[SS20700(ALL)01/96]
All vehicles built for sale in Canada include a
tether anchor hardware kit for use with
Canadian child safety seats.
[SS20725(ALL)04/96]
Vehicles built for sale in the USAdo notinclude
the tether anchor hardware kit, but it can be
obtained at no charge from any Ford or
Lincoln-Mercury dealer.
[SS20750(ALL)01/96]
Your vehicle has two tether attachment locations
in the luggage compartment. To access the tether
attachment locations, you must pry off the caps.
*
[SS20800(ALL)01/96]
Be sure to follow the child safety seat
manufacturer's instructions.
*
[SS20850(ALL)01/96]
WARNING
Tighten the anchor according to
specifications. Otherwise, the safety seat
may not be properly secured and the child
may be injured in a sudden stop or
collision.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

90 %
*
[SS24110(ALL)01/96]
Safety Belts for Children
*
[SS24120(ALL)01/96]
Children who are too large for child safety seats
should always wear safety belts. (See instructions
with your child seat, or contact its manufacturer,
to determine maximum size of child that will
safely fit in the seat.)
*
[SS24130(ALL)01/96]
WARNING
If safety belts are not properly worn and
adjusted as described, the risk of serious
injury to the child in a collision will be
much greater.
*
[SS24140(ALL)01/96]
If the shoulder belt portion of one of the lap and
shoulder belts can be positioned so that it does
not cross or rest in front of the child's face or
neck, the child should wear the lap and shoulder
belt. Moving the child closer to the center of the
vehicle may help provide a good shoulder belt
fit.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

91
*
[SS24150(ALL)01/96]
To improve the fit of lap and shoulder belts on
children who have outgrown child safety seats,
Ford recommends use of a belt-positioning
booster seat that is labelled as conforming to all
Federal motor vehicle safety standards.
Belt-positioning booster seats raise the child and
provide a shorter, firmer seating cushion that
encourages safer seating posture and better fit of
lap and shoulder belts on the child. A
belt-positioning booster should be used if the
shoulder belt rests in front of the child's face or
neck, or if the lap belt does not fit snugly on
both thighs, or if the thighs are too short to let
the child sit all the way back on the seat cushion
when the lower legs hang over the edge of the
seat cushion. You may wish to discuss the
specific needs of your child with your
pediatrician.
*
[SS24160(ALL)01/96]
WARNING
Do not use a belt-positioning booster with
a lap-only belt.
*
[SS24170(ALL)01/96]
Lap belts and the lap belt portion of lap and
shoulder belts should always be worn snugly
and below the hips, touching the child's thighs.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

93
Starting
%*
[TO04100(ALL)01/96]
Fuel-Injected Engines
*
[TO04200(ALL)01/96]
When starting a fuel-injected engine,the most
important thing to remember is to avoid
pressing down on the accelerator before or
during starting. Only use the accelerator when
you have problems getting your vehicle started.
SeeStarting Your Enginein this chapter for
details about when to use the accelerator while
you start your vehicle.
*
[TO04500(ALL)01/96]
Starting Your Vehicle
%*
[TO05000(ALL)01/96]
Preparing to Start Your Vehicle
*
[TO05100(ALL)02/96]
WARNING
Do not start your vehicle in a closed
garage or in other enclosed areas. Exhaust
fumes can be toxic. Always open the
garage door before you start the engine.
*
[TO05200(ALL)01/96]
Before you start your vehicle, do the following:
*
[TO05300(ALL)01/96]
1. Make sure all occupants in the vehicle
buckle their safety belts. SeeSafety Restraints
in the Index for more details.
*
[TO05400(ALL)01/96]
2. Make sure the headlamps and other
accessories are turned off when starting.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

94
*
[TO05500(ALL)01/96]
3.If you have an automatic transaxle, make
sure that the gearshift is in P (Park) and the
parking brake is set before you turn the key.
*
[TO05600(ALL)01/96]
If you have a manual transaxle, make sure
that the parking brake is fully set, push the
clutch pedal to the floor, and put the
gearshift into Neutral before you turn the
key.(Remember, the starter will operate
only if the clutch pedal is pushed all the
way to the floor.)
*
[TO05800(ALL)02/96]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to the
Instrumentationchapter.
%*
[TO06000(ALL)01/96]
Starting Your Engine
*
[TO06100(ALL)01/96]
To start your engine:
*
[TO06300(ALL)01/96]
1. Follow the steps underPreparing to Start
Your Vehicleat the beginning of this section.
*
[TO06320(ALL)01/96]
2. Keep your foot on the brake pedal and turn
the ignition key to the ON position.
*
[TO06330(ALL)01/96]
3. DO NOT depress the accelerator pedal when
starting your engine. DO NOT use the
accelerator while the vehicle is parked.
*
[TO06340(ALL)01/96]
4. Turn the key to the START position
(cranking) until the engine starts. Allow the
key to return to the ON position after the
engine has started.
*
[TO06400(ALL)01/96]
If you have difficulty in turning the key,
rotate the steering wheel slightly because it
may be binding.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

96 %
*
[TO06860(ALL)01/96]
If the engine does not start after two attempts:
*
[TO06865(ALL)01/96]
1. Turn the ignition key to the OFF position.
*
[TO06870(ALL)01/96]
2. Press the accelerator all the way to the floor
and hold it.
*
[TO06875(ALL)01/96]
3. Turn the ignition key to the START position.
*
[TO06880(ALL)01/96]
4. Release the ignition key when the engine
starts.
*
[TO06885(ALL)03/96]
5. Release the accelerator gradually as the
engine speeds up.
*
[TO06890(ALL)03/96]
If the engine still does not start, the fuel pump
shut-off switch may have been triggered. For
directions on how to reset the switch seeFuel
Pump Shut-Off Switchin the index.
%*
[TO08350(ALL)01/96]
A computer system controls the engine's idle
speed. When you start your vehicle, the engine's
idle speed normally runs high. These faster
engine speeds will make your vehicle coast
slightly faster than its normal idle speed. It
should, however, slow down after a short time.
If it does not, have the idle speed checked.
*
[TO08365(ALL)01/96]
If the engine idle speed does not slow down
automatically, do not allow your vehicle to idle
for more than 10 minutes. Have the vehicle
checked.
*
[TO08375(ALL)01/96]
WARNING
Extended idling at high engine speeds can
produce very high temperatures in the
engine and exhaust system, creating the
risk of fire or other damage.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

97
*
[TO08500(ALL)01/96]
WARNING
Do not park, idle, or drive your vehicle in
dry grass or other dry ground cover. The
emission system heats up the engine
compartment and exhaust system, which
can start a fire.
%*
[TO08600(ALL)01/96]
Using the Engine Block Heater
(If equipped)
*
[TO08610(ALL)01/96]
Engine block heaters are strongly recommended
if you live in a region where temperatures reach
-10ÊF (-23ÊC) orbelow. An engine block heater
warms the engine coolant, which improves
starting, warms up the engine faster, and allows
the heater-defrost system to respond quickly.
*
[TO08620(ALL)01/96]
To turn the heater on, simply plug it into a
grounded 110-volt outlet. Ford recommends that
you use a 110-volt circuit that is protected by a
ground fault circuit interrupter.
*
[TO08650(ALL)01/96]
WARNING
To prevent electrical shock, do not use
your heater with ungrounded electrical
systems or two-pronged (cheater) adapters.
*
[TO08670(ALL)01/96]
For best results, plug the heater in at least three
hours before you start your vehicle. Using the
heater for longer than three hours will not
damage the engine, so you can plug it in at
night to start your vehicle the following
morning.
*
[TO08700(ALL)04/96]
Shift-lock System (If equipped)
*
[TO08800(ALL)04/96]
For your safety, the automatic transaxle has a
shift-lock system, which prevents shifting the
transaxle out of the P (Park) position without
depressing the brake pedal when the ignition
key is in the ON position.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997