fuel pump FORD ESCORT 1997 7.G Owners Manual

Fuel pump shut-off switch
The fuel pump shut-off switch
stops the fuel pump when the
vehicle has been involved in a
collision or substantial jolt. If the
vehicle does not start, it is possible
that the fuel pump shut-off switch
needs to be reset.
If you see or smell fuel, do
not reset the switch or try
to start your vehicle. Have all the
passengers get out of the vehicle
and call the local fire department
or a towing service.
The fuel pump shut-off switch is
located in the rear passenger side
of your vehicle. With the sedan
model, a label marks its location.
Press the button on the switch to
reset the fuel pump:
²Sedan
Controls and features
43

2. Press the accelerator all the way
to the floor and hold.
3. Turn the key to START. Release
it once the engine starts.
4. Release the accelerator
gradually as the engine speeds up.
If the engine still does not start,
refer toFuel pump shut-off
switchin theRoadside
emergencieschapter.
Using the engine block heater
(if equipped)
Engine block heaters are strongly
recommended if you live in a
region where temperatures
consistently reach -29ÉC (-20ÉF) or
below during the winter months.
An engine block heater warms the
engine coolant, which improves
starting, warms up the engine
faster, and allows the
heater-defrost system to respond
quickly.
If your vehicle is equipped with an
engine block heater, use it
whenever the temperature is -23ÉC
(-10ÉF) or below.
To turn the heater on, plug it into
a grounded 110-volt outlet. It is
recommended that you use a
110-volt circuit that is protected
by a Ground Fault Circuit
Interrupter.
For best results, plug the heater in
at least three hours before you
start your vehicle. Using the heater
for longer than three hours will not
damage the engine, so you can
Starting
90

USING THE HAZARD SWITCH
Use the hazard flashers to warn
traffic of vehicle problems:
²Slide the hazard switch to the
right to activate the hazard
flashers.
²Slide the hazard switch to the
left to deactivate the
continuously blinking flashers.
RESETTING THE FUEL PUMP
SHUT-OFF SWITCH
The fuel pump shut-off switch
stops the fuel pump when the
vehicle has been involved in a
collision or major jolt. If the
vehicle does not start, it is possible
that the fuel pump shut-off switch
needs to be reset.
If you see or smell fuel, do
not reset the switch or try
to start your vehicle. Have all
passengers get out of the vehicle
and call the local fire department
or a towing service.
To reset the fuel pump, press the
button on the switch. The switch is
located immediately below the hole
in the trunk side trim.
Roadside emergencies
107

Number Fuse amperage
ratingCircuits protected
4 BTN 40 amp Passenger
compartment fuses 1,
2, 6, 12, 13, 7
5 (ABS) 60 amp Anti-lock brake
system (ABS)
6 Cooling fan 40 amp Cooling fan
7 Head Ð Head lamp relay
8 Not used Ð Ð
9 OBD II 10 amp On-board diagnostics
10 Fuel pump 20 amp Fuel pump
11 Head RH 20 amp Passenger side
headlamps
12 Head LH 20 amp Driver side headlamps
CHANGING THE TIRES
Temporary spare tire
information
The temporary spare tire for your
vehicle is labeled as such. It is
smaller than a regular tire and is
designed for emergency use only.
If you use the temporary
spare tire continuously or
do not follow these precautions,
the tire could fail, causing you to
lose control of the vehicle,
possibly injuring yourself or
others.
When driving with the temporary
spare tire,do not:
Roadside emergencies
114

Cleaning the instrument panel
Any cleaner or polish that
increases the gloss of the upper
portion of the instrument panel
should be avoided. The dull finish
in this area is to help protect the
driver from windshield reflection.
Cleaning the exterior lamps
Do not use dry paper towels,
chemical solvents, or abrasive
cleaners to clean the lamps; these
products may cause scratches or
crack the lamps.
Cleaning the engine
A clean engine is more efficient
than a dirty one because a buildup
of grease and dirt acts as an
insulator and keeps the engine
warmer than normal. Follow these
guidelines to clean your engine:
²Take care when using a power
washer to clean the engine. The
high pressure fluid could
penetrate sealed parts and
cause damage.
²In order to avoid cracking the
engine block or fuel injection
pump, do not spray these
components with cold water.
²The alternator and air intake
must be covered to prevent
water damage when cleaning the
engine.
²Never wash or rinse the engine
while it is running; water in a
running engine may cause
internal damage.
Maintenance and care
177

Engine oil ..................................130
check oil warning light ...............9
checking and adding ..............130
Exhaust fumes ............................91
Fan ...............................................18
Flashing the lights ......................27
Floor mats ...................................39
Foglamps ..............................27,163
Fuel
capacity ...................................179
improving fuel economy ........106
low fuel warning light ................7
safety information relating to
automotive fuels .....................153
Fuel pump shut-off switch ..43,107
starting after a collision ...........43
Fuse panels
engine compartment ..............113
instrument panel ....................111
Fuses ..........................................109
charts ................................111,113
checking and replacing ..........109
circuit breakers .......................110
Gauges, Electronic ......................12
Gauges, Mechanical ....................12
engine coolant temperature
gauge .........................................13
fuel gauge ..................................13
odometer ...................................14
speedometer .............................13
trip odometer ............................14
Gearshift .................................36,97
GVWR (Gross Vehicle Weight
Rating) .......................................101
definition .................................101
Hazard flashers ....................29,107
Head restraints ...........................54
Headlamps
daytime running lights .............26
replacing bulbs .......................162
turning on and off ....................26High beams
indicator light .............................9
operation ...................................27
High-mount brakelamp
replacing the bulb ..................164
Hood ..........................................128
prop rod ..................................128
release lever ............................128
working under the hood ........124
Idle
relearning ................................144
Ignition
positions of the ignition ...........25
Inspection/maintenance (I/M)
testing ........................................158
Instrument cluster
sport .........................................6,7
standard ......................................6
Instrument panel ........................15
lighting up panel and interior 6,15
location of components ...........4,5
Interval wipers ............................30
Jump-starting your vehicle ......120
attaching cables ......................121
disconnecting cables ..............122
Lamps ........................................160
bulb replacement
specifications chart ................172
daytime running light system ..26
dome lamps .............................170
fog lamps ............................27,163
headlamps ..........................26,162
high beams ................................27
high-mount brakelamp ...........164
illuminated entry system .........33
interior lamps ....................31,170
map lamps ..........................31,171
replacing bulbs .......................160
tail lamps ..........................167,168
License plate lamps ..................165
Liftgate .................................40,164
warning light .............................10
Index
188