change wheel FORD F SERIES MOTORHOME AND COMMERCIAL CHASSIS 1996 10.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: F SERIES MOTORHOME AND COMMERCIAL CHASSIS, Model: FORD F SERIES MOTORHOME AND COMMERCIAL CHASSIS 1996 10.GPages: 224, PDF Size: 1.25 MB
Page 12 of 224
8
*
[IN06750( ALL)12/93]
q
Wheel lug nuts must be retightened to proper
torque specifications at 500 miles/800 km of
new vehicle operation. Proper torque
specifications are provided in this guide. Also
retighten to proper torque specification at 500
miles/800 km after any wheel change or any
other time the wheel lug nuts have been
loosened.
*
[IN06900( M)01/93]
q
Use only the type of engine oil that Ford
recommends. Don't add anti-friction
compounds or special break-in oils during the
first few thousand miles of operation. These
additives may prevent piston ring seating.
File:ltinm.ex
Update:Tue Jun 20 16:47:32 1995
Page 44 of 224
40
%*
[SC06250( M)01/95]
Tilt Steering
*
[SC06300( ALL)05/95]
RWARNING
Never adjust the steering wheel when the
vehicle is moving.
[SC06600( M)03/94]
one third page art:0020090-D
Turn signal and tilt release wheel lever
*
[SC06700( ALL)04/95]
To change the position of the steering
column/wheel, pull the release lever on the
column toward you. Tip the steering wheel to
the desired position. Release the lever to lock the
steering wheel in place.
*
[SC07250( ALL)12/89]
Be sure the steering wheel locks in a notch. It is
not infinitely adjustable. Do not adjust the
steering wheel while the vehicle is in motion.
%
*
[SC07350( M)01/95]
Speed Control
*
[SC07450( ALL)05/95]
Your vehicle has speed control, so you can
automatically maintain a constant speed above
30 mph (50 km/h). The switches to operate the
speed control are on the steering wheel.
*
[SC07500( ALL)05/95]
Use of radio transmitting equipment that is not
Federal Communications Commission (FCC) or
in Canada the Canadian Radio and
Telecommunications Commission (CRTC)
File:ltscm.ex
Update:Tue Jun 20 16:46:36 1995
Page 57 of 224
53
*
[DR11100( ALL)06/94]
Forced Downshifts
*
[DR11200( ALL)04/95]
To gain extra acceleration injOverdrive or
Drive (O/D OFF), push the accelerator to the
floor. The transmission will automatically
downshift to the appropriate gear: third, second
or first.
*
[DR11235( ALL)03/94]
Power Braking
*
[DR11275( ALL)03/94]
Increasing the engine speed above idle without
vehicle movement (such as holding the brake) in
a forward or reverse gear causes transmission
stall.
*
[DR11285( ALL)03/94]
NOTE: Continued operation in the stall
condition can result in transmission
overheat, malfunction or fluid
expulsion.
%
*
[DR15915( ALL)01/95]
Steering Your Vehicle
%*
[DR15945( ALL)01/95]
Your vehicle comes with power steering. Power
steering uses energy from the engine to help
steer your vehicle.
%*
[DR15950( ALL)04/95]
If the amount of effort needed to steer your
vehicle changes at a constant vehicle speed, have
the power steering system checked. If the power
steering system breaks down (or if the engine is
turned off), you can steer the vehicle manually
but it takes more effort.
*
[DR15960( ALL)01/95]
Never hold the steering wheel to the extreme
right or left for more than five seconds if the
engine is running. This can damage the power
steering pump.
File:ltdrm.ex
Update:Tue Jun 20 16:46:11 1995
Page 65 of 224
61
*
[DR27801( ALL)01/95]
After you drive through the standing water,
apply your brakes gently several times as your
vehicle moves slowly. This helps to dry the
brakes.
*
[DR27820( ALL)07/94]
NOTE: If the transmission is submerged in
water, the fluid should be checked and
changed, if necessary.
*
[DR27825( ALL)03/93]
NOTE: All rear axle lube quantities must be
replaced every 100,000 miles
(160,000 km) or if the axle has been
submerged in water. Otherwise, the
lube should not be checked or changed
unless a leak is suspected or repair
required.
*
[DR27850( ALL)11/89]
Rocking the vehicle
*
[DR27950( ALL)05/95]
If your vehicle gets stuck (for example, in mud
or snow), you may rock it out of the spot. Shift
in a steady rhythm between forward and reverse
gears. Allow the transmission to fully engage,
then press lightly on the accelerator. Do not rock
the vehicle for more than a few minutes. This
may overheat the engine and transmission,
causing damage to both. In addition, other
vehicle systems and components may also be
damaged.
*
[DR27975( ALL)05/95]
RWARNING
Do not spin the wheels at over 35 mph
(55 km/h). The tires may fail and injure a
passenger or bystander.
File:ltdrm.ex
Update:Tue Jun 20 16:46:11 1995
Page 88 of 224
84
*
[RE15200( ALL)03/95]
Preparing to Change the Tire
*
[RE15250( ALL)12/91]
NOTE: To lift your vehicle by other than the
front or rear jacking points, be sure to
use only hoist adapters with a wide
contact surface.
*
[RE15325( E M)03/95]
1. Make sure that your vehicle will not move
or roll. Put the gearshift in P (Park). Set the
parking brake and block the wheel that is
diagonally opposite the tire that you are
changing.
[RE15445( FM)05/95]
On F-Super Duty vehicles, the parking brake is
on the transmission. Therefore, the vehicle will
not be prevented from moving when a rear
wheel is lifted, even if the vehicle is in Park and
the parking brake is applied. Be sure to block
both directions of the wheel that is diagonally
opposite to the wheel that is being lifted.
*
[RE15450( FM)05/95]
RWARNING
If the vehicle slips off the jack, you or
someone else could be seriously injured.
[RE15490( M)05/95]
RWARNING
Do not put any part of your body under
the vehicle. Do not start the engine when
your vehicle is on the jack. Never raise
your vehicle by using a bumper jack.
[RE15495( M)05/95]
The jack is only for changing the tire in
emergencies. The Ford F-Super Duty Jack is
recommended. Use safety stands if you want to
service the vehicle.
[RE15510( M)05/95]
If an alternative jack is used, it must have a
curved surface swivel head compatible with the
stripped chassis jacking surfaces and must have
a minimum load rating of 4 tons. Do not use a
button head type jack.
File:ltrem.ex
Update:Tue Jun 20 16:45:33 1995
Page 92 of 224
88
*
[RE24100( EFM)06/93]
Retighten the wheel lug nuts to the specified
torque at 100 miles (160 km), and again at 500
miles (800 km) of new vehicle operation and at
the intervals specified in theMaintenance Schedule
and Recordbooklet.
*
[RE24200( ALL)10/89]
Also retighten to the specified torque at 500
miles (800 km) of operation after any wheel
change or any time the lug nuts are loosened.
*
[RE24301( ALL)05/95]
RWARNING
Failure to retighten wheel lug nuts at
mileages specified could allow wheels to
come off while the vehicle is in motion.
% [RE24395( M)08/90]
eight pica chart:0020726-AFile:ltrem.ex
Update:Tue Jun 20 16:45:33 1995
Page 135 of 224
131
*
[SV26440( ALL)05/95]
RWARNING
Installing wheels without good
metal-to-metal contact at the wheel
mounting surface can cause the wheel lug
nuts to loosen and could allow the wheel
to come off while the vehicle is in motion.
*
[SV26445( EFM)05/90]
RWARNING
Also retighten at 500 miles (800 km) after
any wheel change or any time the lug
nuts are loosened.
%*
[SV26500( ALL)02/95]
Tire Rotation
*
[SV26600( ALL)03/95]
Because your vehicle's front and rear tires
perform different jobs, they often wear
differently. To make sure your tires wear evenly
and last longer, rotate them at the mileage
shown in theMaintenance Schedule and Record
booklet which came with your vehicle.
[SV26615( M)05/91]
Your front tires should be rotated from side to
side. If the spare tire is used in the rotation, the
pattern should be: left front to right front; right
front to the spare and the spare to left front.
[SV26665( M)05/91]
NOTE: Do not rotate the dual rear tires.
File:ltsvm.ex
Update:Tue Jun 20 16:44:35 1995
Page 150 of 224
146 [SV39450( M)06/90]Inspecting for Road Damage
[SV39460( M)06/90]
The suspension and steering linkage in your
vehicle should be inspected periodically for
abnormal looseness and damaged seals. Also be
alert for changes in steering action. Hard
steering, excessive free play or unusual sounds
when turning or parking indicate a need for
inspection or servicing.
[SV39470( M)06/90]
NOTE: After any severe impact such as
striking large potholes, inadvertent
sliding into curbs on icy roads, or a
collision involving the front end,
observe the steering wheel alignment.
If the steering wheel spokes seem to
be in a different position while going
down the road, have the front
suspension and steering checked for
possible damage.
File:ltsvm.ex
Update:Tue Jun 20 16:44:35 1995
Page 180 of 224
176
*
[BK01300( ALL)01/95]
To assure the durability of your vehicle and its
emission control systems, it is necessary that
scheduled maintenance be performed at the
designated intervals.
*
[BK01400( ALL)05/95]
Ford strongly recommends the use of genuine
Ford replacement parts. If other than Ford or
Motorcraft parts or Ford authorized
remanufactured parts are used for maintenance
replacements or for the service of components
affecting emission control, such non-Ford parts
should be equivalent to genuine Ford Motor
Company parts in performance and durability. It
is the owner's responsibility to determine the
equivalency of such parts. Please consult your
warranty booklet for complete warranty
information.
*
[BK01410( ALL)05/95]
No Cost PCV Valve Replacement
[BK01425( M)02/93]
THE PCV VALVE ON LIGHT TRUCKS IS A
CRITICAL EMISSION COMPONENT. YOUR
DEALER WILL REPLACE THE VALVE AT NO
COST AT 60,000 MILES/96,000 KILOMETERS
(EXCEPT CANADA VEHICLES).
*
[BK01435( ALL)06/94]
Wheel Lug Nuts
*
[BK01455( ALL)06/94]
Wheel lug nuts must be retightened to proper
torque specifications at 500 miles/800 km of
new vehicle operation (100 miles/160 km for
vehicles equipped for snowplowing). Proper
torque specifications are provided in your
Owner Guide. Also retighten to proper torque
specification at 500 miles/800 km after (1) any
wheel change or (2) any other time the wheel
lug nuts have been loosened.
File:ltbkm.ex
Update:Tue Jun 20 16:42:47 1995
Page 188 of 224
184 Severe Duty Schedule
*
[BK56400( ALL)08/94]
q
Lubricate steering linkage suspension,
driveshaft U-joint if equipped with grease
fittings and lubricate slip yoke (if equipped).
(2)
*
[BK56700( ALL)05/93]
q
Inspect disc brake system and lubricate
caliper slide rails. (2)
*
[BK56800( ALL)04/94]
q
Inspect drum brake systems, hoses and lines.
*
[BK56900( ALL)04/94]
q
Change fuel filter (Recommended but not
required for California Certified Vehicles).
*
[BK57000( ALL)05/93]
q
Inspect and lubricate front wheel bearings. (2)
*
[BK57100( ALL)04/93]
q
Inspect parking brake system for damage and
operation.
q
Inspect parking brake fluid (F-Super Duty
only).
*
[BK57450( FM)06/94]
q
Change rear axle lube (F-Super Duty only).
(4)
*
[BK57520( FM)02/95]
q
Check spring U-bolt torque (F-Super Duty).
*
[BK57550( ALL)04/93]
four pica chart:0060627-A
*
[BK57600( ALL)01/95]
33,000 MILES (55,000 Kilometers)
*
[BK57700( ALL)01/95]
q
Change engine oil and replace oil filter.
*
[BK57750( ALL)94/93]
q
Rotate tires and adjust air pressure. (3)(5)(6)
*
[BK58050( ALL)04/93]
four pica chart:0060627-A
File:ltbkm.ex
Update:Tue Jun 20 16:42:47 1995