ECO mode FORD F250 1997 User Guide

147
snow or gravel, or severe pavement irregularities
could also cause you to lose steering control of
your vehicle.
*
[GF01950(F )03/96]
RWARNING
If the anti-lock brake system warning
light remains on or comes on while
driving, have the braking system checked
by a qualified service technician as soon
as possible.
*
[GF02000(F )03/96]
NOTE: If a fault occurs in the anti-lock
system, and the brake warning light is
not lit, the anti-lock system is disabled
but normal brake function remains
operational.
[GF02950(F )04/96]
If Brakes Do Not Grip Well or Pedal is
ªLowº (F-250/350 Only)
%*
[GF03000(F )03/96]
If brakes do not grip well, it may indicate the
rear drum brakes need adjustment. To do this,
drive the vehicle in reverse at 5 mph (8 km/h)
on level, dry pavement. Stop the vehicle by
firmly applying the brakes. Repeat this
procedure four or five times.
*
[GF03050(FM)01/96]
If during normal operation the brake pedal
seems ªlowº, it may indicate the need for a
brake system inspection and/or service. You
should have your brakes checked as soon as
possible.
[GF03100(FM)04/96]
Occasional brake squeal during light to moderate
stops does not affect the function of the brake
system and is normal. However, if the squeal
becomes annoyingly loud or increases
significantly in frequency of occurrence, return
the vehicle to your dealer for inspection.
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com

155 %
*
[GF08050(FM)05/96]
Driving
%*
[GF08075(FM)05/96]
When to usej(Overdrive)
*
[GF08100(FM)01/96]
This is the normal driving position. As the
vehicle picks up speed, automatic upshifts to
second, third and fourth gears will occur when
jOverdrive is chosen on the selector and the
transmission control switch has not been
pressed. The transmission will shift into the
correct gear when the right speed is achieved,
for the accelerator pedal position you have
chosen.
*
[GF08125(FM)05/96]
When to use Drive
*
[GF08150(FM)01/96]
You will note that there isn't a drive position on
your gearshift indicator. However, you will find
a Transmission Control Switch and an indicator
light labeled ªOverdriveº located on the end of
the gearshift lever. Press this switch and the
word ªOFFº will illuminate on the shift lever
knob. With the word ªOFFº illuminated, the
transmission will operate in gears one through
three. Operating in the Overdrive ªOFFº mode
gives more engine braking than Overdrive and
is useful for descending hills or when towing.
[GF08175(FM)01/96]
quarter page art:0020771-C
Transmission Control Switch and indicator light (located
on the gearshift lever)
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com

156
*
[GF08200(FM)01/96]
To return the transmission to the normalj
Overdrive operation, press the transmission
control switch again. The Transmission Control
Indicator Light will not be illuminated when
Overdrive operation resumes. This switch may
be used to select O/D ON or O/D OFF any
time the vehicle is being driven.
*
[GF08225(FM)01/96]
When starting your vehicle, the overdrive system
will automatically be in the normal overdrive
mode.
[GF08250(FM)04/96]
If the Transmission Control Indicator Light is
flashing on and off steadily, a transmission
system malfunction was detected. The
transmission will operate in a failure
management mode and may have harsh
engagements, firm shift feel, or abnormal shift
schedule. If this condition persists, damage to
the transmission could occur. Contact your
dealer as soon as possible.
*
[GF08275(FM)05/96]
When to use 2 (Second)
*
[GF08300(FM)01/96]
Use 2 (Second) to start-up on slippery roads or
to provide additional engine braking on
downgrades. This position provides 2 (Second)
gear operation only.
*
[GF08325(FM)05/96]
When to use 1 (Low)
*
[GF08350(FM)01/96]
Use 1 (Low) to provide maximum engine
braking on steep downgrades. Upshifts from 1
(Low) can be made by manually shifting to 2
(Second) orj(Overdrive). Selection of 1 (Low)
gear provides only low gear operation from
start-up. Selection of 1 (Low) while at higher
speeds provides a shift to second gear, and a
shift to first gear will occur after the vehicle
decelerates to the proper speed.
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com

181
*
[GF20910(FM)01/96]
q
GAWR (Gross Axle Weight Rating)
*
[GF20915(FM)01/96]
q
GCWR (Gross Combined Weight Rating)
*
[GF20920(FM)01/96]
q
Maximum Trailer Weight Rating
*
[GF20930(FM)01/96]
q
Maximum Trailer Weight
*
[GF20940(FM)01/96]
q
Trailer Weight Range
*
[GF20950(FM)01/96]
Base Curb Weight
*
[GF20960(FM)01/96]
The Base Curb Weight is the weight of the
vehicle including fuel, coolants, lubricants,
emergency tools, spare wheel and tire. It also
includes any equipment that isstandardon that
model. It does not include passengers, cargo or
optional equipment installed by factory, dealer,
aftermarket supplier or customer.
*
[GF20970(FM)01/96]
Payload
*
[GF20980(FM)01/96]
Payload is the combined, maximum allowable
weight of cargo, occupants and optional
equipment that the truck is designed to carry. It
is Gross Vehicle Weight Rating minus the base
curb weight.
*
[GF20990(FM)01/96]
Gross Vehicle Weight (GVW)
*
[GF21000(FM)01/96]
If you add base curb weight and the weight of a
load (including passengers, cargo and optional
equipment) being carried at a particular time,
you get the Gross Vehicle Weight (GVW).
*
[GF21010(FM)01/96]
It is important to remember that GVWis not a
limit or a specification.If an owner loads up a
vehicle and weighs it, that's the GVW at that
moment. If the owner piles on more of a load
and weighs it again, that becomes the GVW.
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com

219 % [GF24030(FM)04/96]
High Speed Driving
*
[GF24040(FM)03/96]
Ford Motor Company recommends obeying
posted speed limits.
*
[GF24050(FM)03/96]
RWARNING
Driving too fast for conditions creates the
possibility of loss of vehicle control.
Driving at very high speeds for extended
periods of time may result in damage to
vehicle components.
*
[GF24060(F )05/96]
Speed limiter
*
[GF24070(F )03/96]
All models are equipped with an Electronic
Engine Control (EEC) system which limits the
maximum engine speed and thus road speed in
top gear. Vehicle operation is normal since the
controlled maximum speed is above posted
highway speeds in North America.
%*
[GF24080(FM)01/96]
Driving in Bad Weather
%*
[GF24090(FM)01/96]
Slippery roads
*
[GF24100(FM)01/96]
Drive cautiously on wet or snowy roads:
*
[GF24110(FM)01/96]
q
Do not quickly move the steering wheel
unless necessary.
*
[GF24120(FM)01/96]
q
Drive slower than you normally would.
*
[GF24130(FM)01/96]
q
Give your vehicle more distance to stop.
*
[GF24150(F )01/96]
q
To stop on ice, shift to N (Neutral) below 10
mph (16 km/h) and gently pump brakes
(except with 4WAL).
*
[GF24170(FM)01/96]
q
Consider using one of the lower gears.
*
[GF24180(F )01/96]
q
For 4x4 vehicles, engage 4WD, and try to
drive slowly away.
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com

254
*
[ER22700(FM)02/96]
3. Remove the positive (+) cable from the
booster battery.
*
[ER22800(FM)02/96]
4. Remove the other end of the positive (+)
cable from the discharged battery.
*
[ER22900(FM)02/96]
After the vehicle is started, let it idle for a while
to let the engine ªrelearnº its idle conditions.
Drive it around for a while with all electrical
accessories turned off to let the battery recharge.
Driveability may be deteriorated slightly until all
drive modes are ªrelearned.ºYou may need to
use a battery charger to fully recharge the
battery.
*
[ER23000(FM)03/96]
If you need to replace your battery, seeBattery
in theMaintenance and Carechapter.
%
*
[ER23100(FM)04/96]
Towing Your Vehicle
[ER23350(F )03/96]
The recommended method to tow your vehicle
is with flatbed or wheel lift equipment.
However, slingbelt towing is acceptable.On
vehicles equipped with an air dam,the towbar
will deform the rubber air dam.
*
[ER23500(FM)01/96]
When calling for a tow truck, tell the operator
what kind of vehicle you have. A towing
manual is available from Ford Motor Company
for all authorized tow truck operators. Have
your tow truck driver refer to this manual for
the proper hook-up and towing procedures for
your vehicle.
*
[ER23550(F )05/96]
RWARNING
Never use a tow bar that attaches to the
bumper when you tow your vehicle. This
could damage the bumper and cause an
accident.
File:10lterf.ex
Update:Tue May 28 08:49:52 1996
ProCarManuals.com

304
*
[MC39300(FM)01/96]
By law, anyone who manufactures, repairs,
services, sells, leases, trades vehicles, or
supervises a fleet of vehicles is not permitted to
intentionally remove an emission control device
or prevent it from working. In some of the
United States and in Canada, vehicle owners
may be liable if their emission control device is
removed or is prevented from working.
*
[MC39325(FM)01/96]
Do not drive your vehicle if it does not operate
properly. See your dealer if the engine runs on
for more than five seconds after you shut it off
or if it misfires, surges, stalls, or backfires.
%*
[MC39350(FM)01/96]
Information about your vehicle's emission
control system is on the Vehicle Emission
Control Information decal located on or near the
engine. This decal identifies engine displacement
and gives some tune-up specifications.
[MC39375(F )04/96]
NOTE: All current model year vehicles are
certified to the same year emissions
standards except certain vehicles
equipped with engines built prior to
January 1 of the model year which may
be certified to prior year emissions
standards. In either case, the
maintenance schedules contained in the
back of this Owner Guide must be
used to maintain your engine.
% [MC39400(FM)04/96]
Noise emissions warranty, prohibited
tampering acts
[MC39425(FM)04/96]
On January 1, 1978, Federal regulations became
effective governing the noise emissions on trucks
with a GVWR of over 10,000 lbs (4,536 kgs). The
following statements concerning prohibited
tampering acts and the noise warranty are found
in theWarranty Information Booklet, and are
applicable to completed F-Series chassis cabs
whose GVWR is over 10,000 lbs (4,536 kgs).
File:11ltmcf.ex
Update:Tue May 28 08:52:04 1996
ProCarManuals.com

306 [MC39750(FM)04/96]Maintenance
[MC39775(FM)04/96]
Instructions for maintenance and service of the
noise control system have been included in the
Maintenance Schedule and Recordbooklet and in
the ªGeneral Maintenance Checklist.º To aid the
noise control system throughout the life of the
vehicle, Ford Motor Company recommends that
this vehicle should be operated according to the
Owner's Guide. When installing replacement
parts, use caution not to violate the tampering
act as described above. Use the Maintenance
Record Log to list any inspections and services
performed on the vehicle.
%*
[MC39800(FM)03/96]
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
*
[MC39825(FM)04/96]
In some localities it may become a legal
requirement to pass an
Inspection/Maintenance (I/M) test of the
On-Board Diagnostic (OBD) II system. If the
vehicle's powertrain system or its battery has
just been serviced, the OBD II system is reset to
a not ready for I/M testing condition. To
prepare for I/M testing, the law specifies that
additional city and highway driving is necessary
to complete the check of the OBD II system.
[MC39830(FM)05/96]
The driving modes required to reach the ready
condition consist of a minimum of 30 minutes
city and highway driving as described below:
[MC39835(FM)05/96]
At least 20 minutes driving in stop and go, city
type traffic with at least four idle periods.
[MC39840(FM)05/96]
At least 10 minutes of driving on an expressway
or highway.
[MC39845(FM)05/96]
Before completing the above driving modes, the
engine must be warmed up and at operating
temperature. Once started, the vehicle must not
be turned off during these driving modes.
File:11ltmcf.ex
Update:Tue May 28 08:52:04 1996
ProCarManuals.com