change wheel FORD FOCUS 2014 3.G Quick Reference Guide

insTrumenT paneL
1 Trunk*/Liftgate* Release
2 Cruise Control*
To Set Your Cruise Control Speed
1. Press the ON control and release.
2. Accelerate to the desired speed.
3. Press the SET + control and release,
then take your foot off the accelerator.
After you set your speed, you can press
SET +/ SET – to adjust your cruise speed. To
disable, tap the brake, press the clutch pedal
or pull the CAN (Cancel) control toward you.
Note: Using the clutch pedal to cancel a set
speed may cause the engine speed to
increase briefly.
3 Information Display
Provides information about various systems
on your vehicle. Use the left, 5-way controls
located on the steering wheel to choose and
confirm settings and messages. Refer to the
Information Displays chapter of your Owner’s
Manual for more information.
4 Service Engine Soon Light
Illuminates briefly when the ignition
is turned on. If it remains on or is blinking after the engine is started, the On-Board
Diagnostics (OBD-II) system has detected a
malfunction.
Drive in a moderate fashion and
contact your authorized dealer as soon
as possible.
5 Tilt/Telescope Steering Column
Unlock the steering wheel by pulling the
lever down. Adjust the wheel to the desired
position. Push the lever back up to lock the
steering wheel in place.
6 Voice Controls*
Pull toward you to access
voice recognition.
Press to answer a call.
Press to exit phone mode or end a call.
7 Push Button Start*
Allows you to start your vehicle by pressing
the ENGINE START/STOP button while
fully pressing down on the brake (automatic
transmission) or clutch and brake (manual
transmission) pedal(s). Press the button
again to turn the engine off.
Note: Your intelligent access key must be
inside the vehicle for keyless starting to work.
8 Audio Controls*
Use the right-hand, 5-way controls to
adjust your audio system:
(Volume): Press to increase (+)
or decrease (–) volume levels.
(Seek): Press the right arrow to hear the
next saved radio station, CD track or MP3 choice.
Press the left arrow to hear the previous selection.
Press M to select a different audio source.
9 Wiper Controls
Use the rotary control on the stalk to adjust the
wipe intervals. Pull the stalk toward you to spray
and wash the windshield. Press the button at the
end of the lever to turn the rear wiper* on, off or
change to intermittent wipe.
10 Hazard Control
11 Power Door Locks
Press the control to lock or unlock
the doors. When the light on the
button is on, it indicates that all
of the doors and the luggage compartment are
locked. When the light is off, it indicates that either
the luggage compartment or one or more of the
doors are unlocked.
2014 focus
4*if equipped
26
38
5
49
1011
3
7
5
1
*if equipped

2014 focusessenTiaL informa Tion
18
Fuel Tank Capacity/Fuel Info
Your vehicle has a 12.4 gallon (46.9L) fuel tank capacity.
Your vehicle may be flex-fuel capable. If so, it will have
a yellow ring around the fuel inlet. Flex fuel vehicles
are designed to use ETHANOL (E85) fuel blends and
UNLEADED FUEL. Please see your Owner’s Manual for
specific refueling instructions when using E85.
Non-flex fuel vehicles use only UNLEADED fuel with an
octane rating of 87. Do not use fuel
E20 - E85 ethanol (E85),
diesel fuel, fuel-methanol, leaded fuel or any other
fuel because it could damage or impair the emission
control system.
Easy Fuel® Sy s t e m
To Use
• Put your vehicle into P (Park) and turn the ignition off.
• Open the fuel-filler door.
• Insert the nozzle.
• Begin fueling.
• Wait 10 seconds between
the time the refueling nozzle
is shut off until you remove
the nozzle from the vehicle
to allow residual fuel in the
nozzle to drain into
the tank.
• When using a portable fuel container, slowly insert the
fuel funnel (located in the spare tire compartment)
and pour the fuel into the funnel.
Note: Do not use aftermarket funnels as they will not work
with the Easy Fuel system and may cause damage. Properly
clean the funnel after each use.
Tire Pressure Monitoring System
Your vehicle illuminates a low tire pressure warning light in your instrument cluster when one or more of your
tires is significantly underinflated. If this happens, stop
and check your tires as soon as possible, then inflate them
to the proper pressure. Refer to the Inflating Your Tires
section in the Wheels and Tires chapter of your Owner’s
Manual for more information.
Location of Spare Tire and Tools
Your spare tire and tools are located beneath the carpeted
floor panel in the rear of your vehicle.
• The spare tire is designed for emergency use
only and should be replaced as soon as possible.
• For complete details on changing your tire, refer
to the Changing a Road Wheel section in the
Wheels and Tires chapter of your Owner’s Manual.
Powershift Six-speed Automatic Transmission*

This transmission is designed for
fun-to-drive performance and
exceptional fuel efficiency, by using the
advantages of a manual transmission
with the convenience of an automatic
transmission. You may notice the
following characteristics of
this technology:
• Mechanical noises after the engine is turned off, after
the driver door is opened and during some transmission
shifting events. These are normal and do not
cause damage.
• Firm gearshifts when moving the accelerator pedal
back and forth quickly.
Your transmission continuously makes electronic
adjustments to optimize shift quality and acceleration
performance. Most adjustments will be made during the
first 1,000 miles (1610 kilometers) of operation. During
this break-in period, slight vibrations may be felt when
accelerating the vehicle from low speeds.
Roadside Assistance
Your new Ford vehicle comes with the assurance and
support of 24-hour emergency roadside assistance.
To receive roadside assistance in the United States,
call 1-800-241-3673. In Canada, call 1-800-665-2006.
SelectShift Automatic® Transmission*
Gives you the ability to manually
change gears if you’d like. To use,
move the gearshift lever from D (Drive)
to S (Sport). Activate SelectShift by
using the + / – thumb toggle located
on the side of your gearshift lever to
manually make shifts. Press the (+)
button to upshift. Press the (–)
button to downshift.
*if equipped19