washer fluid FORD MUSTANG 2004 4.G SVT Supplement Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 2004, Model line: MUSTANG, Model: FORD MUSTANG 2004 4.GPages: 24, PDF Size: 0.18 MB
Page 7 of 24
4.6L DOHC SUPERCHARGED V–8 ENGINE
1. Engine oil filler cap
2. Brake fluid reservoir
3. Engine oil dipstick
4. Power distribution box
5. Windshield washer fluid reservoir
6. Battery
7. Power steering fluid reservoir
8. Engine coolant reservoir
9. Intercooler reservoir
10. Air filter assembly
11. Auxiliary power distribution block
12. Supercharger
2004 Mustang(mus)
Supplement
USA English(fus)
Engine/Transmission
7
Page 14 of 24
Fluid Ford Part Name Capacity
Transmission
fluid
3Refer to the label on your
transmission3.9L
(8.2 pints)4
Windshield
washer fluidUltra-Clear Windshield
Washer Concentrate3.8L
(4.0 quarts)
1Add the coolant type originally equipped in your vehicle.2Rear axle lubricants do not need to be checked or
changed unless a leak is suspected, service is required or
the axle assembly has been submerged in water. The axle
lubricant should be changed any time the rear axle has
been submerged in water. Fill 6 mm to 14 mm (1/4 inch to
9/16 inch) below bottom of fill hole. Add 118 ml (4 oz.) of
Additive Friction Modifier C8AZ-19B546-A or equivalent
meeting Ford specification EST-M2C118–A for complete
refill of Traction-Lok axles.
3The TTC T56 6–Speed transmission on your SVT
Mustang Cobra uses automatic transmission fluid. Ensure
the correct automatic transmission fluid is used as
indicated in the label on your transmission.
4Service refill capacity is determined by filling the
transmission to the bottom of the filler hole with the
vehicle on a level surface.
OCTANE RECOMMENDATIONS
Your vehicle is designed
to use“Premium”
unleaded gasoline with
an (R+M)/2 octane rating
of 91 or higher for optimum performance. The use of
gasolines with lower octane ratings may degrade
performance. We do not recommend the use of
gasolines labeled as“Premium”in high altitude areas
that are sold with octane ratings of less than 91.
If your engine knocks under most driving conditions
while you are using fuel with the recommended
octane rating, see your dealer or a qualified service
technician to prevent any engine damage.
CHECKING ENGINE COOLANT
The concentration and level of engine coolant should
be checked at the mileage intervals listed in the
91(R+M)/2 METHOD
2004 Mustang(mus)
Supplement
USA English(fus)
Maintenance
14
Page 16 of 24
Note:Automotive fluids are not interchangeable; do
not use engine coolant, antifreeze or windshield
washer fluid outside of its specified function and
vehicle location.
Adding engine coolant
When adding coolant, make sure it is a 50/50
mixture of engine coolant and distilled water. Add
the mixture to the coolant reservoir,when the
engine is cool, until the appropriate fill level is
obtained.
Do not add engine coolant when the engine
is hot. Steam and scalding liquids released
from a hot cooling system can burn you badly.
Also, you can be burned if you spill coolant on hot
engine parts.
Do not put engine coolant in the windshield
washer fluid container. If sprayed on the
windshield, engine coolant could make it difficult
to see through the windshield.
The cooling system in your vehicle is filled with
either green-colored Motorcraft Premium Engine
Coolant meeting Ford specification ESE-M97B44–A
or yellow-colored Motorcraft Premium Gold Engine
Coolant meeting Ford Specification
WSS-M97B51–A1. To determine your vehicle’s
coolant type (color), check your coolant reservoir.
•
Add Motorcraft Premium Engine Coolant
(green-colored), VC-4–A (U.S.) or CXC-10
(Canada) or Motorcraft Premium Gold Engine
Coolant (yellow-colored), VC-7–A, depending
on the type of coolant originally equipped in
your vehicle.If you are unsure which type of
coolant your vehicle requires, check your coolant
reservoir or contact your local dealer.
•Do not add/mix an orange-colored, extended
life coolant such as Motorcraft Speciality
Orange Engine Coolant, VC-2 (US) or
2004 Mustang(mus)
Supplement
USA English(fus)
Maintenance
16