headlamp FORD MUSTANG 2009 5.G Quick Reference Guide

MUSTANG QUICK REFERENCE GUIDE 2009
How does it feel to own an American Icon?
Your 2009 Mustang is the newest member of a
proud family of legendary road machines.
45 years of refinement and innovation have made
your new Mustang one of the most exciting,
comfortable, safest and smartest cars to ever roam
the American road. This Quick Reference Guide
was designed to help you get to know your new
Mustang. It will allow you to familiarize yourself with
many of your new Mustang’s features and functions.
For the most detailed information and important
safety information refer to your Owner’s Guide.
Use extreme caution when using any device or
feature that may take your attention off the road.
Your primary responsibility is the safe operation of
the vehicle. Only use non-essential features and
devices when it is safe to do so.
1 2
3
4
5
6 7
8 9
10
11
12
1 HEADLAMPS, FOG LAMPS (IF EQUIPPED) AND PANEL DIMMER CONTROLTurn the control one position to the right to turn on the parking lamps,
instrument panel lamps, license plate lamps and tail lamps. Turn the control to
the second position on the right
to turn on the headlamps. Pull the control
towards you to activate the fog lamps (if equipped). The fog lamps will not operate
when the control is turned off
or when the high beams are on. Use the panel
dimmer control to adjust the level of brightness on the instrument panel during
parking lamp and headlamp operation. Move the control to the full upright position,
past the detent, to turn on the interior lamps.
2 TIRE PRESSURE MONITORING SYSTEM (TPMS) When the Tire Pressure Monitoring System (TPMS) warning light is lit, one or more of
your tires is significantly under-inflated. You should stop and check the tires as soon as
possible and inflate them to the proper pressure, as shown on the Safety Compliance
Certification Label or Tire Label (located on the edge of the driver’s door). Driving on
a significantly under-inflated tire causes the tire to overheat and can eventually lead
to tire failure.
NOTE Outside temperatures affect tire pressure; refer to the Owner’s
Guide for additional tire information.
3 ANTI-LOCK BRAKE SYSTEM (IF EQUIPPED)The ABS warning lamp will momentarily illuminate when the ignition is turned on.
If the light fails to illuminate when the ignition is turned on, stays on or flashes, have
your vehicle serviced. In an emergency, apply continuous force to the brake pedal.
Do not pump the brakes. Any pulsation or mechanical noise you may feel or hear
is normal.
4 SERVICE ENGINE SOON LIGHTThe Service Engine Soon indicator light illuminates when the ignition is first turned
on. If the light stays on or blinks, the On Board Diagnostics System has detected a
malfunction. Drive moderately (avoid heavy acceleration or deceleration) and have
your vehicle serviced immediately.
5 GEARSHIFT / OVERDRIVE CONTR OLDrive with the vehicle in D (Overdrive) for the best fuel economy. You can deactivate
overdrive by pressing the transmission control switch on the right side of the
shift handle. You may want to deactivate overdrive when driving conditions cause
excessive shifting such as heavy city traffic, hilly terrain, heavy loads, etc. and when
engine breaking is required. To return to overdrive, simply press the transmission
control switch again.
6 TILT STEERING COLUMN (IF EQUIPPED) To adjust the steering wheel, push the lever down to unlock the steering column. While
the lever is in the down position, tilt the steering column to your desired position. Then,
while holding the steering column in place, pull the lever up to its original position to lock
the steering column.
7 TRACTION CONTROL™ (IF EQUIPPED)
This system helps you maintain the stability and steerability of your vehicle on slippery
road surfaces such as snow, ice or gravel. The system works closely with many of the
elements already present in the Anti-Lock Braking System. The system defaults to on.
However, should you become stuck, try switching the Traction Control
™ off. Remember
to reactivate Traction Control™ once you resume normal driving.
8 SPEED CONTROLTo set the speed control, press and release ON. Accelerate to the desired speed.
Press and release the SET + control. Take your foot off the accelerator pedal. The
speed control indicator light
will illuminate in the cluster. To set a higher speed:
press and hold SET+ until the desired speed is reached, or briefly press SET+ to
increase the speed by small amounts. To set a lower speed: press and hold SET- until
the desired speed is reached, or briefly press SET- to decrease the speed by small
amounts. Press RESUME to return to the previously set speed. To turn speed control
off, depress the brake pedal or clutch pedal (if equipped).
9 WINDSHIELD WIPER / WASHERThe windshield wiper/washer lever controls the windshield wiper modes, speeds and
the windshield washer. For intermittent operation, move the control up one position, then
rotate the rotary control to the speed you want. For normal or low speed wiper operation,
move the control up two positions from OFF. For high-speed operation, move the control up
three positions from OFF. For windshield washer control, pull the end of the stalk toward
you. A quick pull and hold, and the wipers will swipe three times with washer fluid. A long
pull and hold, and the wipers and washer fluid will be activated for up to ten seconds.
10 MYCOLOR™ (IF EQUIPPED)
The instrument cluster gauges are backlit with white backlighting when the headlamps
are off. When the headlamps are on, you can select one of six preset colors or create
your own color (MyColor
™) for the nighttime gauge backlighting. Headlamps must be
on to set up the nighttime display. NOTE A gauge in a warning condition will be lit red
when the headlamps are on. Press SETUP to get to the DISPLAY COLOR set-up menu. Pressing RESET will scroll through the following selectable colors: Green, Purple, Orange,
Blue, White, Red, and Adjust (to define MyColor
™).
Adjusting MyColor
™: The vehicle must be stationary to enter the MyColor™ adjust mode.
To enter the MyColor™ adjust mode, hold RESET for three seconds at the Adjust menu,
or press SETUP to scroll through the display colors again. When in the MyColor™ adjust
mode, pressing RESET will step through the Red, Green, Blue and Exit options. You can
create your own color by adjusting the levels of the three primary colors to achieve any
of 125 different combinations. Pressing SETUP will increment the proportion of the color
(Red, Green, or Blue) being adjusted. Try many combinations and record your favorites. To
save and exit MyColor™, adjust and hold RESET for three seconds when prompted.*
11 MESSAGE CENTER (IF EQUIPPED)With the ignition turned on, the message center displays important vehicle information by
constantly monitoring vehicle systems. You may select display features on the message
center for a display of status. The system will also notify you of potential vehicle problems
with a display of system warnings followed by a long indicator chime.*
12 SECURILOCK™ PASSIVE ANTI-THEFT SYSTEMThis system is designed to help prevent the engine from being started unless a
coded key programmed to your vehicle is used. Your SecuriLock™ system is armed
immediately after turning the ignition off. The theft indicator (if equipped) will flash
every two seconds when the vehicle is armed. Switching the ignition to the ON
position with a coded key disarms the system. Your vehicle comes with two coded
keys. You can purchase additional coded keys from your dealer.*
AMBIENT / MOOD LIGHTING (IF EQUIPPED) Your vehicle may be equipped with an ambient lighting feature which, when activated,
illuminates the footwells, cup holders and console bin with a choice of seven
colors. Ambient lighting is operational when the ignition is on or in the accessory
position. Press the control repeatedly to turn on, cycle through your color choices,
and turn off.
ADjUSTING THE FRONT POWER SEATS (IF EQUIPPED)The control is located on the side of the seat. Press the front to raise or lower the front
portion of the seat cushion. Press the rear to raise or lower the rear portion of the seat
cushion. Press the control to move the seat forward, backward, up or down.*
INSTRUMENT PANEL
*For more detailed information, please refer to your Owner’s Guide.