fuel pressure FORD PROBE 1997 2.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: PROBE, Model: FORD PROBE 1997 2.GPages: 288, PDF Size: 1.64 MB
Page 21 of 288
17
*
[IS05400(ALL)01/96]
The fuel gauge indicator may vary slightly while
the vehicle is in motion. This is the result of fuel
movement within the tank. You can get a more
accurate reading with the vehicle on smooth,
level ground.
[IS05500(ALL)01/96]
Charging System Gauge
[IS05600(ALL)01/96]
This gauge tells you your battery's voltage when
you turn your ignition key to ON. When you
start your engine, the pointer should move to
the NORMAL range if you are not operating
any electrical accessories. (If electrical accessories
are operating and the engine is not running, the
pointer may move into the red area).
[IS05700(ALL)01/96]
If the pointer moves into the red area when no
electrical accessories are operating, have the
vehicle's electrical system checked.
%*
[IS05800(ALL)04/96]
Engine Oil Pressure Gauge
[IS05900(ALL)01/96]
The gauge needle should stay in the NORMAL
range (indicating normal engine oil pressure). If
the needle drops below the NORMAL range into
the low range, there is a loss of oil pressure.
[IS06000(ALL)01/96]
If this happens:
*
[IS06100(ALL)04/96]
1. Pull off the road as soon as safely possible.
*
[IS06200(ALL)04/96]
2. Shut off the engine immediately or severe
engine damage could result.
[IS06300(ALL)01/96]
3. Check the oil level when the vehicle is on
level ground.
[IS06400(ALL)01/96]
4. Add only as much oil as the engine needs
before you drive the vehicle again. Do not
overfill the oil reservoir. For more
information, seeAdding engine oilin the
Index.
File:03prisp.ex
Update:Thu May 16 09:43:45 1996
Page 208 of 288
206
*
[MC21000(ALL)02/96]
If the acid touches someone's skin, eyes, or
clothing, immediately flush the area with water
for at least 15 minutes. If someone swallows the
acid, have him or her drink lots of milk or water
first, then Milk of Magnesia, a beaten egg, or
vegetable oil. Call a doctor immediately.
%*
[MC21100(ALL)02/96]
RWARNING
Applying too much pressure on the ends
when lifting a battery could cause acid to
spill. Lift the battery with a carrier or
with your hands on the opposite corners.
[MC24000(ALL)04/96]
Wiper blade maintenance
*
[MC24100(ALL)01/96]
Check the windshield wiper blades at least twice
a year. Also check them whenever they seem
less effective than usual. Such substances as tree
sap and some hot wax treatments used by
commercial car washes reduce the effectiveness
of wiper blades.
*
[MC24200(ALL)01/96]
If the blades do not wipe properly, clean both
the windshield and the wiper blades. Use
undiluted windshield washer solution or a mild
detergent. Rinse thoroughly with clear water. Do
not use fuel, kerosene, paint thinner, or other
solvents to clean your wiper blades. These will
damage your blades.
*
[MC24300(ALL)01/96]
To make reaching the wiper blades easy, simply
turn the ignition switch to ACC and turn your
wipers on. Wait for them to reach a vertical
position and turn the ignition to OFF. Do not
move the wipers manually. Moving the wipers
manually may damage them.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996
Page 210 of 288
208 [MC24575(ALL)01/96]
two third page art:0032367-AReplacing the wiper blades
%*
[MC24600(ALL)01/96]
Tires
*
[MC24700(ALL)03/96]
Look at your tires each time you fill your fuel
tank. If one tire looks lower than the others,
check the pressure in all of them. Always follow
these precautions:
*
[MC24900(ALL)02/96]
q
Use an accurate tire pressure gauge.
*
[MC25000(ALL)02/96]
q
Check the tire pressure when tires are cold,
after the vehicle has been parked for at least
one hour or has been driven less than 3 miles
(5 km).
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996
Page 218 of 288
216 [MC30400(ALL)01/96]
half page art:0032107-CManual fuel filler-lid override (behind left rear trim panel
in hatch)
[MC30500(ALL)01/96]
To fill the fuel tank:
*
[MC30600(ALL)01/96]
1. After opening the fuel filler door, remove
the cap carefully and slowly by turning it
counterclockwise 1/2 to 3/4 turn.
*
[MC30700(ALL)01/96]
RWARNING
The fuel system may be under pressure. If
the fuel cap is venting vapor or if you
hear a hissing sound, wait until it stops
before completely removing the cap.
*
[MC30800(ALL)01/96]
2. Put the nozzle all the way inside the fuel
filler pipe before pumping the fuel.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996
Page 219 of 288
217
*
[MC30900(ALL)01/96]
NOTE: If you spill any fuel on the body of
your vehicle, clean it off immediately.
The fuel may dull or soften the paint
if you do not wash it off.
%*
[MC31000(ALL)03/96]
3. Replace the fuel cap completely when you
are finished. Turn it clockwise 1/4 turn until
it is tight. It will click when it is fully
tightened.
*
[MC31100(ALL)01/96]
4. Push the fuel door closed.
*
[MC31200(ALL)01/96]
If you lose the fuel cap, replace it with an
authorized Motorcraft or equivalent part.
%*
[MC31300(ALL)01/96]
RWARNING
If you do not use the proper fuel cap, the
pressure in the fuel tank can damage the
fuel system or cause it to work improperly
in a collision.
*
[MC31400(ALL)01/96]
NOTE: If you replace your fuel cap with an
aftermarket fuel filler cap, the customer
warranty may be void for any damage
to the fuel tank and/or fuel system.
%*
[MC31500(ALL)01/96]
Choosing the Right Fuel
*
[MC31600(ALL)05/96]
Use only UNLEADED FUEL. The use of leaded
fuel is prohibited by law and could damage
your vehicle. The damage may not be covered
by your warranty.
*
[MC31700(ALL)05/96]
Your vehicle was not designed to use fuel
containing manganese-based additives such as
MMT. Additionally, vehicles certified to
California emission standards (indicated on the
underhood Vehicle Emissions Control
Information label) are designed to operate on
California reformulated gasolines. If California
reformulated gasoline is not available when you
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996
Page 225 of 288
223
*
[MC38500(ALL)01/96]
To make sure that the catalytic converter and the
other emission control parts continue to work
properly:
*
[MC38600(ALL)01/96]
q
Use only unleaded fuel.
*
[MC38700(ALL)01/96]
q
Avoid running out of fuel.
*
[MC38800(ALL)01/96]
q
Do not turn off the ignition while your
vehicle is moving, especially at high speeds.
*
[MC38900(ALL)01/96]
q
Do not push start your vehicle.
*
[MC38950(ALL)03/96]
q
Have the services listed in yourMaintenance
Schedulebooklet performed according to the
specified schedule.
*
[MC39000(ALL)01/96]
RWARNING
Do not park, idle, or drive your vehicle in
dry grass or other dry ground cover. The
emission system heats up the engine
compartment and exhaust system, which
can start a fire.
*
[MC39100(ALL)01/96]
Watch for fluid leaks, strange odors, smoke, loss
of oil pressure, the charge warning light, the
check engine light, or the temperature warning
light. These sometimes indicate that the emission
system is not working properly.
*
[MC39200(ALL)01/96]
Do not make any unauthorized changes to your
vehicle or engine. Changes that cause more
unburned fuel to reach the exhaust system can
increase the temperature of the engine or
exhaust system.
%*
[MC39300(ALL)01/96]
In general, maintenance, replacement, or service
of the emission control devices or systems in
your new Ford Motor Company vehicle or
engine may be performed at your expense by
any automotive repair establishment or
individual using automotive parts equivalent to
those with which your vehicle or engine was
originally equipped.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996
Page 234 of 288
232 %
*
[MC62000(ALL)01/96]
Cleaning the Exterior Lamps
*
[MC62100(ALL)01/96]
Do not use dry paper towel, chemical solvents
or abrasive cleaners to clean the lamps, as these
may cause scratches or crack the lamps.
*
[MC63000(ALL)01/96]
Cleaning the Engine
*
[MC63100(ALL)01/96]
A clean engine is more efficient because the
engine is able to cool properly. A build up of
grease and dirt acts as an insulator, keeping the
engine warmer than normal.
*
[MC63200(ALL)01/96]
q
Extreme care must be used if a power washer
is used to clean the engine. The high pressure
fluid could penetrate sealed parts and
assemblies causing damage or malfunctions.
*
[MC63300(ALL)04/96]
q
In order to avoid possible cracking of the
engine block or fuel injection pump, do not
spray a hot engine or injection pump with
cold water.
*
[MC63400(ALL)04/96]
q
The alternator, distributor and air intake must
be covered. Covering these components will
help prevent water damage.
*
[MC63500(ALL)01/96]
Never wash or rinse the engine while it is
running. Water getting into the engine may
cause internal damage.
%*
[MC63600(ALL)03/96]
Cleaning the Wheels
*
[MC63700(ALL)03/96]
Wash the wheels with the same detergent you
use to wash your vehicle's body. Do not use
acid-based wheel cleaners, steel wool, abrasives,
fuel, or strong detergents. These substances will
damage protective coatings. Use tar and road oil
remover to remove grease and tar.
*
[MC63800(ALL)03/96]
NOTE: Before going to a car wash, find out if
the brushes are abrasive.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996
Page 276 of 288
280 Index
Engine
check engine warning light....... 15
does not start...........128, 130
fuel injected engine, starting...... 125
fuel pump shut-off switch....... 130
preparing to start........... 125
starting................ 126
starting after a collision........ 130
storing your vehicle.......... 234
Engine block heater........... 129
Engine coolant
checking and adding......... 196
checking hoses............ 199
disposal...........184, 193, 203
preparing for storage......... 236
proper solution........184, 193, 203
temperature gauge........... 18
Engine coolant temperature gauge
description............... 18
mechanical............... 18
Engine coolant temperature
gauge:electronic............. 18
Engine fan............... 184
Engine:idle speed control......... 128
Engine oil
changing oil and oil filter....... 191
checking and adding......... 191
dipstick............... 191
disposal...........184, 193, 203
engine oil pressure gauge........ 17
filter, specifications.......... 237
specifications............. 190
synthetic oil............. 190
ªbreak-inº oils............. 6
viscosity............... 190
Exhaust fumes............. 130
File:prixp.ex
Update:Tue Jun 11 11:04:36 1996
Page 278 of 288
282 Index
Fuel pump shut-off switch
engine does not start......... 130
starting after a collision........ 130
G
Gas cap (see Fuel cap).......... 215
Gas mileage (see Fuel economy) . . . 217, 220
Gasoline (see Fuel)............ 215
Gauges, Electronic
engine coolant temperature gauge.... 18
fuel gauge............... 16
odometer................ 19
speedometer.............. 19
Gauges, Mechanical
engine coolant temperature gauge.... 18
engine oil pressure gauge........ 17
fuel gauge............... 16
odometer................ 19
speedometer.............. 19
tachometer............... 19
trip odometer.............. 19
GAWR (Gross Axle Weight Rating)
calculating.............. 152
definition............... 151
driving with a heavy load....... 151
Gearshift
automatic operation.......... 138
column-mounted........... 138
downshifting............. 150
floor-mounted............ 148
locking the gearshift........... 61
positions.............138, 148
shifting the gears.........138, 148
upshifting.............. 150
Gearshift:shifting the gears......138, 148
GVWR (Gross Vehicle Weight Rating)
calculating.............. 152
definition............... 151
driving with a heavy load....... 151
File:prixp.ex
Update:Tue Jun 11 11:04:36 1996