FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual SIERRA 1982 1.G FORD FORD https://www.carmanualsonline.info/img/11/5458/w960_5458-0.png FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual
Trending: ECO mode, fuel cap, reset, fuel tank capacity, fuel type, engine, ABS

Page 1 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual General
Fuel tank capacity (all models)  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60.0 litres (13.1 gallons)
Fuel octane rating:
Leaded  . . . . . . . . . . . . . . . . . . . .

Page 2 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual Torque wrench settingsNmlbf ft
2.0 litre SOHC models
Refer to Chapter 4
, PartA Specifications for items not listed here
Fuel pressure regulator fuel feed union nut . . . . . . . . . . . . . . . . . .

Page 3 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual manual mixture adjustment is possible.
On models with a catalytic converter, an
evaporative emission control (EVAP) system is
fitted. This prevents the release of fuel vapour
into the atmosphere. With

Page 4 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual working on the exhaust system, ensure
that the converter is well clear of any
jacks or other lifting gear used to raise the
car and do not drive the car over rough
ground, road humps, etc., in such a

Page 5 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual 5The system will remain depressurised until
the fuel pump is primed prior to starting the
engine. Remove the container or cloth, as
applicable, on completion.
Refer to Chapter 1, Section 41.
2.0 litre

Page 6 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual 21Fit the small spring, valve, diaphragm
(ensuring that it locates correctly), large
spring, and the spring cup.
22Carefully place the ball into position on
the spring cup, and ensure that it locates

Page 7 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual alternatively make arrangements to collect the
contents of the fuel tank which will otherwise
be released. Disconnect the hose from the
pump.
6Slowly loosen the fuel flow damper fitted to
the pump out

Page 8 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual Note: A tachometer and an exhaust gas
analyser will be required to check the idle
mixture on completion.
1Disconnect the battery negative lead.
2Depress the locking clip on the airflow
meter wiring pl

Page 9 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual Note: A tachometer and an exhaust gas
analyser will be required to check the idle
mixture on completion. New seals and
retaining clips must be used when refitting the
injectors, and special grease wil

Page 10 of 16

FORD SIERRA 1982 1.G Fuel And Exhaust Systems Fuel Injection Workshop Manual 26Further refitting is a reversal of removal,
ensuring that all hoses, pipes and wiring plugs
are correctly connected.
27On completion, where applicable, check
and if necessary adjust the idle mixture
Page:   1-10 11-20 next >
Trending: fuel cap release, ECO mode, automatic transmission, reset, engine, gas type, ABS