brake fluid FORD SIERRA 1993 2.G Braking System Workshop Manual

FORD SIERRA 1993 2.G Braking System Workshop Manual SIERRA 1993 2.G FORD FORD https://www.carmanualsonline.info/img/11/5452/w960_5452-0.png FORD SIERRA 1993 2.G Braking System Workshop Manual

Page 1 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual System type
Conventional braking system (except P100 models)  . . . . . . . . . . . . . . . Front discs and rear drums with vacuum servo assistance, dual
hydraulic circuit split front/rear, decelerati

Page 2 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual Torque wrench settingsNmlbf ft
Caliper carrier bracket-to-hub carrier bolts . . . . . . . . . . . . . . . . . . . . . .51 to 6138 to 45
Front caliper guide bolts . . . . . . . . . . . . . . . . . . .

Page 3 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual 8Open the bleed screw half a turn and have
your assistant depress the brake pedal slowly
to the floor and then, after the bleed screw is
retightened, quickly remove his foot to allow
the pedal to retu

Page 4 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual the caliper, free it using a screwdriver with the
guide pin bolt fitted, as shown (see
illustration). Do not use a screwdriver to free
the inboard pad, as this may damage the
piston dust seal. The inb

Page 5 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual the caliper, and the caliper body is modified
accordingly. Also, plastic covers are fitted to
the caliper guide bolts (see illustrations).
22Procedures are unchanged from those
given above.
Rear disc

Page 8 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual 27Unhook the return springs and remove the
leading shoe. Note the direction of wheel
rotation arrows on the shoes.
28Remove the hold-down cup, spring and
pin from the trailing (rear) shoe by depressin

Page 9 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual neck with a rubber band, or by refitting the
cap. This will reduce the loss of fluid during
the following procedure.
3Disconnect the flexible fluid hose from the
rigid brake pipe under the wing of the

Page 10 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual Note: Complete dismantling of the rear caliper
should not be attempted unless Ford spring
compressor (tool No 12-007) is available, or
unless the problems likely to arise in the
absence of the tool ar

Page 11 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual 15A long thin pair of circlip pliers will now be
required to release the key plate retaining
circlip from the caliper bore (see illustration).
With the circlip removed, the pushrod and key
plate can b

Page 12 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual Specifications. To do this, fix the measuring
equipment, and rotate the disc, noting the
variation in measurement as the disc is
rotated. The difference between the minimum
and maximum measurements re
Page:   1-10 11-20 next >