headrest GEELY CK 2008 Workshop Manual

331(VI) Seat Removal, Installation and AdjustmentFront SeatSee Figure
Disassembly of Front Seat
1.Headrest Assembly 2. Headrest Support3.Snap Ring4.Front Seat Backassembly
5.Front Seat Back Cover 6.Cap Nut7.Front Seat Coupling Plastic Gasket
8.Track Assembly 9.Front Seat Cushion Cover 10.Front Seat Cushion Assembly
11.Adjuster Assembly12.Adjuster Hinge Cover1. Removal1Remove 4 bolts and the seat from the vehicle;
2Turn the headrest lock handle to"Non-LOCK". Remove headrest and bracket;
3Remove the attaching screw, Remove adjuster hinge cover from the front seat;
4Remove the 4 snap ring under the rear side of the seat back. Remove the set bolt and nut at the both sideof the seat back;
5Remove seat coupling plastic gasket;
6Remove the seat cushion, track assembly and adjuster assembly;
7Press the headrest support and push it upwards by hand in the direction as the Figure shows and removethe headrest support;
8Open the seat backcover. Remove the inner coversnap ring. Remove the seat backcover;

3329Remove the snap ring under the seat cushion. Open the front seat cushion cover. Remove the inner
coversnap ring. Remove the seat cushion cover.2. Installation1Install snap ring at the front and rear seat. Be careful not to foul the cover or get it wrinkled;
2Install the snap ring at the front of the seat back. Install the front seat headrest support;
3Install the adjuster and track assembly with bolts;
4Install the coupling plastic gasket. Install the seat back assembly to the seat cushion with bolts and nuts.
Install the snap ring to the rear seat back;
5Install the adjuster hinge cover with 2 screws;Remove the Headrest and BracketRemove the Front Seat Adjuster Hinge CoverRemove the Seatback Snap Ring and Set BoltTrack AssemblyAdjuster AssemblyRemove the Track and Adjuster Assembly Remove the Headrest Support
Remove the Seatback CoverRemove boltsNon-LOCK

3336Install the headrest;
7Install the front seat with 4 tightening bolts. Torque: 14.72~23.52N.m.3.Adjust1The seat can adjust tilt angle forward in torque 2° x 5=10°;
Adjust backwards 2° x 27=54°;
2The seat assembly slides forwards 15mm x 4=60mm in torque 15N.m;
Slide backwards 15mm x 10=150mm;
3The headrest can be adjusted in 3 positions in height.Rear Seat1.Rear seat back
1Removal
a. Lift the rear seat back lock handle upwards. Turn seat back down forwards. Remove 4 set bolts.
Remove seat backassembly from the vehicle;
b. Remove seat back lock handle and handle seat;Install Front and Rear Seat Snap RingInstall Headrest SupportTrack Assembly Adjuster AssemblyInstall Adjuster and Track AssemblyAssemble the Seatback and Cushion