GMC C-SERIES 1999 Owners Manual

yellowblue
6-13
Engine Oil (Gasoline Engine)
It's a good idea to check your engine oil every time you
get fuel. In order to get an accurate reading, the oil must
be warm and the vehicle must be on level ground.
The engine oil dipstick is located on the passenger's side
of the engine compartment.
Turn off the engine and give the oil several minutes to
drain back into the oil pan. If you don't, the oil dipstick
might not show the actual level.
Checking Engine Oil
Pull out the dipstick and clean it with a paper towel or
cloth, then push it back in all the way. Remove it again,
keeping the tip down, and check the level.
ProCarManuals.com

yellowblue
6-14 When to Add Engine Oil
If the oil is at or below the cross-hatched area, then
you'll need to add at least one quart of oil. But you must
use the right kind. This part explains what kind of oil to
use. For crankcase capacity, see ªCapacities and
Specificationsº in the Index.
NOTICE:
Don't add too much oil. If your engine has so
much oil that the oil level gets above the
cross
-hatched area that shows the proper
operating range, your engine could be damaged.
Be sure to fill it enough to put the level somewhere in
the proper operating range. Push the dipstick all the way
back in when you're through.
What Kind of Engine Oil to Use
Oils recommended for your vehicle can be identified by
looking for the ªStarburstº symbol. This symbol
indicates that the oil has been certified by the American
Petroleum Institute (API). Do not use any oil which
does not carry this Starburst symbol.
If you change your own oil,
be sure you use oil that has
the Starburst symbol on the
front of the oil container. If
you have your oil changed
for you, be sure the oil put
into your engine is
American Petroleum
Institute certified for
gasoline engines.
You should also use the proper viscosity oil for your
vehicle, as shown in the following chart:
ProCarManuals.com

yellowblue
6-15
As shown in the chart, SAE 5W-30 is best for your
vehicle. However, you can use SAE 10W
-30 if it's going
to be 0F (
-18C) or above. These numbers on an oil
container show its viscosity, or thickness. Do not use
other viscosity oils, such as SAE 20W
-50.
NOTICE:
Use only engine oil with the American Petroleum
Institute Certified For Gasoline Engines
ªStarburstº symbol. Failure to use the
recommended oil can result in engine damage
not covered by your warranty.
GM Goodwrench
oil meets all the requirements for
your vehicle.
If you are in an area where the temperature falls below
-20F (-29C), consider using either an SAE 5W-30
synthetic oil or an SAE 0W
-30 oil. Both will provide
easier cold starting and better protection for your engine
at extremely low temperatures.
ProCarManuals.com

yellowblue
6-16 Engine Oil Additives
Don't add anything to your oil. Your dealer is ready to
advise if you think something should be added.
When to Change Engine Oil
Your vehicle has a computer that lets you know when to
change your engine oil. This is not based on mileage,
but on engine revolutions and engine operating
temperature. When the computer has calculated that the
oil needs changing, the Oil Life Monitor will indicate
that a change is necessary. The mileage between oil
changes will vary depending on how you drive your
vehicle
-- usually between 3,000 miles (5 000 km) and
7,500 miles (12 500 km) since your last oil change.
Under severe conditions, the indicator may come on
before 3,000 miles (5 000 km). Never drive your vehicle
more than 7,500 miles (12 500 km) or 12 months
(whichever occurs first) without an oil change.
The system won't detect dust in the oil. So, if you
drive in a dusty area, be sure to change your oil every
3,000 miles (5 000 km) or sooner. Remember to reset
the CHANGE OIL light whenever the oil is changed.How to Reset the Oil Life Monitor
To reset the CHANGE OIL message, turn the ignition
key to RUN with the engine off. Fully press and release
the accelerator pedal three times within 10 seconds. If
the CHANGE OIL message flashes for five seconds, the
system is reset. If the message does not display for five
seconds, you will need to reset the system again.
What to Do with Used Oil
Did you know that used engine oil contains certain
elements that may be unhealthy for your skin and could
even cause cancer? Don't let used oil stay on your skin
for very long. Clean your skin and nails with soap and
water, or a good hand cleaner. Wash or properly throw
away clothing or rags containing used engine oil. (See
the manufacturer's warnings about the use and disposal
of oil products.)
Used oil can be a real threat to the environment. If you
change your own oil, be sure to drain all free
-flowing oil
from the filter before disposal. Don't ever dispose of oil
by putting it in the trash, pouring it on the ground, into
sewers, or into streams or bodies of water. Instead,
recycle it by taking it to a place that collects used oil. If
you have a problem properly disposing of your used oil,
ask your dealer, a service station or a local recycling
center for help.
ProCarManuals.com

yellowblue
6-17
Engine Oil
(Caterpillar
Diesel Engines)
See your Caterpillar
Operation & Maintenance Manual
for information on oil quality and viscosities as well as
the temperature range chart.
Air Filter Restriction Indicator
Your engine has an indicator that lets you know when
the air filter is dirty and needs to be serviced. It is in the
air intake tube below the air cleaner on the passenger's
side of the engine.
When the yellow indicator
reaches the red ring in the
sight glass, it's time to
service the air filter.After the air filter is properly serviced, the indicator can
be reset by pushing the button on top of the indicator.
Engine Air Cleaner/Filter
Your GM Maintenance Schedule says when to replace
the air filter.
Gasoline Engine Caterpillar
Diesel
Engine
ProCarManuals.com

yellowblue
6-18
CAUTION:
Gasoline Engines Only: Operating the engine
with the air cleaner/filter off can cause you or
others to be burned. The air cleaner not only
cleans the air, it stops flame if the engine
backfires. If it isn't there, and the engine
backfires, you could be burned. Don't drive with
it off, and be careful working on the engine with
the air cleaner/filter off.
NOTICE:
Gasoline Engines Only: If the air cleaner/filter is
off, a backfire can cause a damaging engine fire.
And, dirt can easily get into your engine, which
will damage it. Always have the air cleaner/filter
in place when you're driving.
Your vehicle may also be equipped with an optional
Filterminder gage. See ªWarning Lights, Gages and
Indicatorsº in the Index.
Automatic Transmission Fluid
When to Check
A good time to have it checked is when the engine oil is
checked. See your Allison Automatic Transmission
Operator's Manual to find out when to change your
transmission fluid and filters.
How to Check and What to Use
The Allison Automatic Transmission Operator's Manual
that came with the vehicle shows how to check the
automatic transmission fluid and what fluid to use.
NOTICE:
Too much or too little fluid can damage your
transmission. Too much can mean that some of
the fluid could come out and fall on hot engine
parts or exhaust system parts, starting a fire. Be
sure to get an accurate reading if you check your
transmission fluid.
ProCarManuals.com

yellowblue
6-19 Automatic Transmission External Filter
Your automatic transmission spin-on type filter requires
periodic replacement. It is mounted just behind the
radiator on the outside of the passenger's side frame rail.
Consult the Allison Automatic Transmission Operator's
Manual that came with the vehicle for proper
change intervals.
Automatic Transmission External Filter
With Service Trans Filter Indicator Light
(Option)
This automatic transmission spin-on type filter is
mounted to the left of the transmission. It requires
replacement when the SERVICE TRANS FILTER
indicator light on the instrument panel comes on or
every three years, whichever occurs first.
Manual Transmission Fluid
When to Check
A good time to have it checked is when the engine oil is
checked. See your Maintenance Schedule to find out
when to change your transmission fluid and filters.
How to Check and What to Use
The Eaton Fuller Transmission Operator's Manual that
came with the vehicle shows how to check the manual
tranmsmission fluid and what fluid to use.
NOTICE:
Too much or too little fluid can damage your
transmission. Too much can mean that some of
the fluid could come out and fall on hot engine
parts or exhaust system parts, starting a fire. Be
sure to get an accurate reading if you check your
transmission fluid.
ProCarManuals.com

yellowblue
6-20
Rear Axle
When to Check and Change Lubricant
Refer to the Maintenance Schedule to determine how
often to check the lubricant and when to change it.
See ªScheduled Maintenance Servicesº in the
Maintenance Schedule.
How to Check Lubricant
If the level is below the bottom of the filler plug hole,
you'll need to add some lubricant. Add enough lubricant
to raise the level to the bottom of the filler plug hole.
What to Use
Refer to the Maintenance Schedule to determine what
kind of lubricant to use. See ªRecommended Fluids and
Lubricantsº in the Maintenance Schedule.
Rear Axle Shift Motor (Option)
When to Check and Change Fluid
If you have an optional air-shift two-speed, controlled
traction, or locking differential type rear axle, a good
time to check the fluid level in the axle shift motor is
when the rear axle lubricant is checked. Use refrigerant
oil (shift motor only).
How to Check Fluid
Remove the plug on the front plate of the axle shift
motor, add enough fluid to raise the level to the bottom
of the filler plug hole, then replace the plug.
What to Use
Refer to your Maintenance Schedule to determine what
kind of lubricant to use.
ProCarManuals.com

yellowblue
6-21
Radiator Pressure Cap
(Gasoline Engines)
The radiator pressure cap
must be tightly installed
with the arrows on the cap
lined up with the top of the
overflow tube. This will
prevent coolant loss and
possible engine damage
from overheating.
When you replace your radiator pressure cap, an
ACDelco

cap is recommended.
NOTICE:
Your radiator pressure cap is a 9 psi (62kPa)
pressure
-type cap for use with medium duty
cooling systems only. It must be tightly installed
to prevent coolant loss and possible engine
damage from overheating. Be sure the arrows on
the cap line up with the top of the overflow tube.
ProCarManuals.com

yellowblue
6-22
Surge Tank Pressure Cap
(Diesel Engines)
The surge tank pressure cap
must be tightly installed
with the arrows on the cap
lined up with the top tube of
the coolant surge tank.
When you replace your surge tank pressure cap, an
ACDelco

cap is recommended.
NOTICE:
Your surge tank pressure cap is a 9 psi (62kPa)
pressure
-type cap for use with medium duty
cooling systems only. It must be tightly installed
to prevent coolant loss and possible engine
damage from overheating. Be sure the arrows on
the cap line up with the top tube of the coolant
surge tank.
Thermostat
Engine coolant temperature is controlled by one or more
thermostats in the engine cooling system. The
thermostat stops the flow of coolant through the radiator
until the coolant reaches a preset temperature.
When you replace your thermostat, an ACDelco


thermostat is recommended for gasoline engines.
Caterpillar
parts are recommended for diesel engines.
ProCarManuals.com