GMC CANYON 2004 Owner's Manual

GMC CANYON 2004 Owner's Manual CANYON 2004 GMC GMC https://www.carmanualsonline.info/img/44/35572/w960_35572-0.png GMC CANYON 2004 Owner's Manual
Trending: cooling, spark plugs replace, air condition, air filter, fuel pressure, brake, belt

Page 311 of 420

GMC CANYON 2004  Owners Manual To disconnect the jumper cables from both vehicles,
do the following:
1. Disconnect the black negative (-) cable from the
vehicle that had the dead battery.
2. Disconnect the black negative (-) cable

Page 312 of 420

GMC CANYON 2004  Owners Manual Four-Wheel Drive
Lubricant checks in this section also apply to these
vehicles. However, there are two additional systems
that need lubrication.
Transfer Case
When to Check Lubricant
Refer to the Main

Page 313 of 420

GMC CANYON 2004  Owners Manual Front Axle
When to Check and Change Lubricant
It is not necessary to regularly check front axle �uid
unless you suspect there is a leak or you hear an
unusual noise. A �uid loss could indicate a probl

Page 314 of 420

GMC CANYON 2004  Owners Manual Bulb Replacement
SeeReplacement Bulbs on page 5-54for the proper
types of bulbs to use. For any bulb changing procedure
not listed in this section, contact your dealer’s service
department.
Halogen

Page 315 of 420

GMC CANYON 2004  Owners Manual 3. Turn the bulb socket counterclockwise and pull it
straight out of the headlamp housing.
4. Unplug the electrical connector from the old bulb.
5. Plug in the electrical connector to the new bulb.
Us

Page 316 of 420

GMC CANYON 2004  Owners Manual Front Turn Signal, Sidemarker and
Daytime Running Lamps
1. Remove the turn signal/parking lamp/daytime
running lamp (DRL) assembly by pressing on the
release clip on the outboard side of the housing a

Page 317 of 420

GMC CANYON 2004  Owners Manual Center High-Mounted Stoplamp
(CHMSL)
1. Remove the screws and lift off the lamp assembly.
2. Turn the bulb socket counterclockwise and
remove it from the housing.
3. Pull the bulb straight out of the

Page 318 of 420

GMC CANYON 2004  Owners Manual A. Stoplamp/Taillamp
B. Turn Signal
C. Back-up Lamp
3. Turn the bulb socket counterclockwise to remove it
from the taillamp housing.
4. Pull the old bulb straight out from the socket.
5. Press a new b

Page 319 of 420

GMC CANYON 2004  Owners Manual Windshield Wiper Blade
Replacement
Windshield wiper blades should be inspected at least
twice a year for wear and cracking. See “Wiper
Blade Check” underCleaning the Outside of Your
Vehicle on pag

Page 320 of 420

GMC CANYON 2004  Owners Manual 3. Remove the insert from the blade assembly. The
insert has two notches at one end that are locked by
bottom claws of the blade assembly. At the notched
end, pull the insert from the blade assembly.
Trending: oil capacity, ground clearance, washer fluid, air suspension, check engine light, air condition, audio