ECO mode GMC CANYON 2008 Get To Know Guide

Getting to Know Your Canyon4
Driver Information Center
Your vehicle’s Driver Information Center
(DIC) is located on the instrument panel
cluster. It features a message center
that can display information such as the
trip odometer, vehicle personalizationfeatures and a number of messages orwarnings.
The odometer is automatically displayed
when the engine is started, and showsthe total distance the vehicle has beendriven in either miles or kilometers.
Scroll through the various DIC modes
•Press and release the control stem
located on the DIC.
Display trip odometer information
•Press and hold the control stem for
four seconds.
The display shows the distance traveled
since you last set the trip odometer tozero.
Select the DIC language
1.With the engine off, turn the key to On.
2. Close all doors.
3. Press and release the reset stem
until LANGUAGE is displayed.
4. To view each available language,
press and hold the reset stem for
two seconds.
5. Once the desired language is dis
played, briefly press the reset stem to set your choice.
Warnings and Messages
The following are examples of some of
the warnings or messages that mayappear in the DIC. Have your vehicleserviced as soon as possible:
• BRAKE FLUID
(Brake fluid may be low)
• BRAKE SYSTEM
(Service the brake system)
• ABS (Brake system operates
normally without the antilock brakesystem benefit)
•SERVICE TRACTION (Service
the Traction Control System)
• ENG HOT (Check your engine
coolant temperature gauge)
• SERVICE VEH (Service vehicle)
Acknowledge and clear a warning or
message
• Press and hold the control stem for
one second.
Note:To ensure your own safety and to
protect your vehicle warranty, it’s impor
tant not to ignore the preceding warn
ings. Acknowledge each one and attendto them at your earliest convenience.
Canyon 2008 A 4/3/07 12:36 PM Page 4

Getting to Know Your Canyon10
AM/FM Stereo with CD/MP3 and
Radio Data System (if equipped)
Set the clock on RDSequipped radios
• Press and hold HR and MN simul
taneously for two seconds until
UPDATED and the clock symbol
appear on the display.
If the time is not available from the
station, NO UPDAT will appear.
Using the RDS
Radios equipped with RDS mode allow
you to:
• Seek only stations with your
preferred programming type.
• Seek stations with traffic
announcements.
• Receive announcements of local
and/or national emergencies.
•Receive and display messages from
radio stations.
RDS features are available only on FM
stations that broadcast RDS information.When tuned to an RDS station, the radiodisplays the station name instead of the
frequency. Most RDS stations broadcasttheir station name, time of day and a
Program Type (PTY).
Access the traffic announcement
feature
• Press the TRAF button.
Access radio station messages
• Press the INFO button when INFO
appears on your radio display.
Access Program Type selections
1. To turn Program Type on, press the
SEEK TYPE button once.
2. Turn the PTYPE knob to select the
Program Type you want.
3. Press the SEEK or SEEK TYPE but
ton and the radio seeks to the firstavailable RDS broadcast of the
selected Program Type.
4. To turn Program Type off (while
seeking), press the SEEK or SEEKTYPE button, or wait for the seek tocomplete. All stations will now be
available when you press the SEEK
button.
Activate the Alternate Frequency
feature
• Press and hold the BAND button for
two seconds to turn it on; repeat to
turn it off.
When turned on, AF ON appears on the
radio display and the radio may switch
to stronger stations of the same PTY.
ALERT!
This message appears on the display
when a local or national emergency
announcementis available. If a CD is
playing, the announcement will override
it. ALERT! announcements cannot beturned off, and are not affected by tests
of the Emergency Broadcast System.
Canyon 2008 A 4/3/07 12:36 PM Page 10

Getting to Know Your Canyon14
Rear Seat Folding Operation
(if equipped)
Fold down the forwardfacing rear
seat on Extended Cab models
• Pull down on the bottom of the seat
until it is in place.
Store the seat
• Push the entire seat up until it is flush
with the trim panel.
Note:To ensure that the hinges or
latches do not damage the safety belt orcause the belt buckle to rattle, fold andstore the belt between the seat cushion
and seatback using the Velcro attachments provided on the lower portion ofthe seat.
Fold the Crew Cab’s rear seatbacks
forward
1. Insert a smalltipped tool into the slot
to unlatch the center safety belt buckle and move the belt to the side,
out of the way.
2. Grasp the loop located on the side of
the seatback (A) and pull it until youhear a click.
A
Flexible, Locking Tailgate
The tailgate features a flexible design
that allows it to be positioned fully up,fully down, partially lowered, or to be
removed entirely.
Partially lower the tailgate
1. From its fully down position, raise the
tailgate high enough to slide theretaining cable bracket forward and off
the bottom bolt.
2.While still holding the tailgate, raise it
slightly in order to place the cable
bracket’s
lowerhole onto the topbolt.
Note: The rear seat storage compart
ments must be in the rearward positionbefore folding the seat down.
3. Fold the seatback down.
Repeat the process to fold the other
seatback.
Return the Crew Cab’s rear seatbacks
to the upright position
1.Lift the seatback up and push it into
place.
2. Reconnect the center safety belt latch
plate with the buckle.
3. Push and pull on the seatback to
ensure that it is secured.
Repeat these steps for the other seat
back as necessary.
See Section 1 of your Owner Manual.
Canyon 2008 A 4/3/07 12:36 PM Page 14

Getting to Know Your Canyon16
With fourwheel drive, you can send
power to all four wheels for extra trac
tion. The controls are located on theinstrument panel, to the right of thesteering wheel.
FourWheel Drive Modes
2
(2HI): This setting is used for most
street and highway driving conditions.The front axle is not engaged in thismode.
FourWheel Drive System
(if equipped)
PERFORMANCE & MAINTENANCE
Starting Your Engine
With your foot off the accelerator pedal,
turn the ignition key to Start. When the
engine starts, let go of the key. Avoid
holding your key in the Start position
for longer than 15 seconds at a time.Excessive starter operation can drainyour battery much sooner and excessive
heat can damage your starter motor. Ifmore than one try to start the engine is
necessary, wait about 15 secondsbetween the first and second attempts.
See Section 2 of your Owner Manual.
Automatic Locking Differential
(if equipped)
Your axle may be equipped with an
automatic locking differential feature thathelps increase traction when traveling atspeeds less than 20 mph.
Once engaged, both rear wheels will
“lock” and rotate at the same speed,improving vehicle traction. If one wheelhas poor traction, such as when on ice,snow or mud, power will be transferredto the wheel with better traction.
Resetting the Oil Life System
The Oil Life System calculates engine
oil life based on vehicle use and dis
plays CHANGE OIL on the Driver
Information Center when it’s necessaryto change the engine oil and filter. The
Oil Life System should be reset onlyfollowing an oil change.
To reset the Oil Life System:
1. Turn on the ignition, with the
engineoff.
2. Press and release the control stem
on the instrument cluster until OILLIFE is displayed.
3. Once the alternating OIL LIFE and
RESETmessages appear, press and
hold the control stem until several
beeps sound. This confirms that theOil Life System has been reset.
4.Turn off the ignition.
See Sections 3 and 5 of your Owner Manual.
Note: The Oil Life System does not
replace the need to follow the maintenance schedule in the Owner Manual.
It also does not measure how much oilis in the engine.
Canyon 2008 A 4/3/07 12:36 PM Page 16

19
Traction Control System
(2WD models)
If the Traction Control System (TCS)
detects wheelspin at one or both rearwheels, the system will reduce enginepower and/or upshift the transmission
to help limit wheelspin. When the TCS is working, during which the Driver
Information Center displays LO TRAC,you may notice reduced engine performance.
The TCS is auto
matically turned on
each time the vehicle is started.
Under most driving
conditions, youshould leave the TCS turned on. But
if your vehicle ever gets stuck in sand,
mud or snow and rocking the vehicle is
required, you may want to turn off theTCS. See Section 4 of your OwnerManual for important details.
To turn off the TCS:
•Press the TCS button located on the
instrument panel just above the radio.
The indicator light will illuminate when
the TCS is turned off.
• Press the button again to turn the
TCS back on. The indicator light will
turn off.
See Section 4 of your Owner Manual.
Tire Pressure Monitor
The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle’s
tires by illuminating the (Low Tire
Pressure) warning light on the instru
ment panel cluster. The low tire pres
sure warning light will remain on until
you correct the tire pressure. A LOWTIRE message may also appear on
the DIC.
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must fill the tire to theproper tire inflation pressure (just as youmust refuel the vehicle when the low fuel
warning light illuminates). The Tire andLoading Information label shows thecorrect inflation pressure for the tireswhen they’re cold. “Cold” means yourvehicle has been sitting for at least three
hours or driven no more than one mile.
You can temporarily clear the DIC
message by acknowledging it with yourDIC controls. However, at the next
vehicle startup, the DIC message will
reappear if the tire pressure has notbeen corrected.
During cooler conditions, the low tire
pressure warning light may appear whenthe vehicle is first started and then turn
off as you start to drive the vehicle. Thiscould be an early indicator that your tirepressures are getting low and need to
be inflated to the proper pressure.
See Section 5 of your Owner Manual.
Note:The Tire Pressure Monitor can
alert you about low tire pressure, but itdoesn’t replace normal monthly tiremaintenance.
Canyon 2008 A 4/3/07 12:36 PM Page 19