lock GMC JIMMY 1997 Repair Manual

Changing a Flat Tire
If a tire goes flat, avoid further tire and wheel damage
by driving slowly to a level place. Turn on your hazard
warning flashers.
A CAUTION:
Changing a tire can cause an injury. The vehicle
can slip off the jack and roll over you or other
people. You and they could be badly injured.
Find a level place to change your tire.
To help
prevent the vehicle from moving:
1. Set the parking brake firmly.
2. Put an automatic transmission shift
lever in PARK
(P) or shift a manual
transmission to FIRST
(1) or
REVERSE (R).
CAUTIQN: iContinued) .~
3. If you have a four-wheel-drive vehicle
with a manual transfer case shift lever,
be sure the transfer case is in a drive
gear
-- not in NEUTRAL (N).
4. Turn off the engine.
5. Put the wheel blocks at the front and
rear
of the tire farthest away from the
one being changed. That would be the
tire on the other side of the vehicle,
at
the opposite end.
5-23

L
The following steps will tell you how to use thc jack and
change
a tire.
Removing the Spare Tire and Tools
The jacking equipment you'll need is stored r~long the
driver's rex
wall. In some cases, you may ha\:e to
remove the spare tire in order to reach the jack. Your
vehicle is also equipped with work gloves and a plastic
ground mat
lo assist in the changing of a flat tire.
To remove your jack cover,
pull
up on the latch at the
end
of the cover. near the
endgate and the latch
on the
top of the cover. Remove
the whecl blocks, jack
and
wheel wrench.
NOTICE:
Never remove or restow a tire from/to a stowage
position under the vehicle while the vehicle
is
supported by a jack. Always tighten the tire fully
against the underside of the vehicle when
restowing.
5-24

Insert the key and pull
the lock cast” straight oft‘.
It is not necessary to turn
the key.
L
A
Put the spare tire neat- the l’lat tire.
5-26

Removing the Flat Tire and Installing the
Spare Tire 3. Fit the jack into the appropriate hole nearest the
tlat tire.
1. Using the wheel wrench, loosen all the wheel nuts.
Don't
remove them yet.
2. Turn the jack handle clockwise to raise the jack
lift head.
A. Front Frame Hole
B. Rear Frame Hole (?-Door) or Spring Hanger Hole
(+Door)
5-28

10. Use the wrench to tighten the wheel nuts firmly in a
crisscross sequence
as shown.
9. Lower the vehicle by turning the jack handle
counterclockwise. Lower the jack completely.
5-31

Follow this diagram to store the llnderbody-mounted spare.
A. Retainer
B. Valve Stem
(Pointed
Down)
C. Spare 01- Flat Tire
D. Spring
E. Wheel Wrench
F. Lower
G. Raise
H. Hoist
Arm
1. Put the tire on the gro~~nd at the rear of the vehicle,
with the valve stem pointed down and to the rear.
2. Pull the retainer t11ro~1sh the wheel.
3. Put the chisel end of the wheel wrench, on an angle,
through
the hole in the rear bllmper and into the hoist
shaft. Turn the wheel wrench clockwise until the tire
is raised against the underside
of the vehicle.
You will hear two "clicks" when the tire is secure.
but p~111 on the tire to make SLII-e.
5-33

Follow this diagram for the inside-mounted spare.
D f
A. Spare or Flat Tire
B. Retainer (Two-Wheel Drive)
C. Nut
D. Retainer (Four-Wheel DI-~LT)
E. Wheel Can-ier
E Hook
A. Wheel Carrier
C.
Wheel Nut and Locking Nut Cylinder
5-34

Return the jack, wheel wrench and wheel blocks to the
proper location in your vehicle’s rear area. Secure the
items and replace the jack cover.
I /-A
I L
A. Retainer E Wheel Blocks
B. Rubber Band
G. Hub Cap Removal
(Some Models) Tool (Some Models)
C. Work Gloves
H. Wheel Wrench
D. Mat I. Jack
E. Jack Storage Cover J. Jacking Instructions
Make sure the tire and carrier are secure.
Driving with the tire or carrier unlatched could
injure pedestrians or damage the vehicle.
Compact Spare Tire (If Equipped)
Although the compact spare tire was fully inflated when
your vehicle was new, it can lose air after a time. Check
the inflation pressure regularly. It should be
60 psi
(420 Wa).
After installing the compact spare on your vehicle,
you should stop as soon as possible and make sure
your spare tire is correctly inflated. The compact
spare is made to perform well at speeds up to
65 mph
(105 km/h) for distances up to 3,000 miles (5 000 km),
so you can finish your trip and have your full-size tire
repaired or replaced where
you want. Of course, it’s best
to replace your spare with a full-size tire as
soon as you
can. Your spare will last longer and be in good shape in
case you need it again.
5-35

Filling Your Tank
The fuel cap is behind
a hinged door on the
driver’s side
of
your vehicle.
Gasoline vapor is highly flammable. It burns violently, and that can cause very bad injuries.
Don’t smoke if you’re near gasoline or refueling
your vehicle. Keep sparks, flames and smoking
materials away from gasoline.
To take off the cap, turn
it slowly to the left
(counterclockwise). The
cap has a spring in it: if
you let go of the cap
too soon, it will spring
back to the right.
A CAUTION:
I
If you get gasoline on yourself and then
something ignites it, you could be
badly burned.
Gasoline can spray out on you if you open
the
fuel filler cap too quickly. This spray can happen
if your tank
is nearly full, and is more likely in
hot weather. Open the fuel filler cap slowly and
wait for any “hiss” noise to stop. Then unscrew
the cap
all the way.
6-5

Be careful not to spill gasoline. Clean gasoline from
painted surfaces as soon as possible. See “Cleaning the
Outside of Your Vehicle” in the Index.
When you put the cap back on, turn it to the right
(clockwise) until you hear a clicking sound. Make sure
you fully install the cap. The diagnostic system can
determine if the fuel cap has been left off or improperly
installed. This would allow fuel to evaporate into the
atmosphere. See “Malfunction Indicator Lamp’’ in
the Index.
______
NOTICE:
If you need a new cap, be sure to get the right
type. Your dealer can get one for you.
If you get
the wrong type, it may not fit properly. This may
cause your malfunction indicator lamp to light
and your fuel tank and emissions system may be
damaged. See “Malfunction Indicator Lamp” in
the Index.
Checking Things Under the Hood
To open the hood, first pull
the handle inside the vehicle
on the lower driver’s side of
the instrument panel.
Then go to the front of
the vehicle and release the
secondary hood release.
6-6 I I I