GMC SIERRA 1993 Manual Online

2. Don’t push the accelerator pedal before starting your engine.\
In some
other vehicles you might need to do this, but because of your vehicle’s
computer systems, you don’t.
key. The idle speed will go down as your engine gets warm.
3. Turn your ignition key to Start. When the engine starts, let go of the
Holding your key in
Start for longer than 15 seconds at a time will caus
your battery to be drained much sooner. And the :essive heal
m
damage your starter motor.
4.
5.
If it doesn’t start right away, hold your key in Start. If it doesn’t start in
three seconds, push the accelerator pedal about one-quarter of the way
down for
12 more seconds, or until it starts.
If your engine still won’t start (or starts but then stops), \
it could be
flooded with too much gasoline. Try this:
Wait
15 seconds to let the starter motor cool down. Then push your
accelerator pedal all the way to the floor. Hold it there. Then, hold the
key in
Start for no more than ten seconds. This clears the extra
gasoline from the engine.
If the engine still doesn’t start, wait another 15 seconds and do it all again.
When the engine starts, let go of the key and accelerator ped\
al.
Your engine is designed to work with the electronics in your vehicle.
If you
add electrical parts or accessories, you could change the way \
the fuel
injection system operates. Before adding electrical equipment, ch\
eck with
-w dealer. If you don’t, your engine might not perform properly
If you ever have to have your vehicle towed, see the part of th\
is Manua
that tells how to do
it wit‘--.Jt damaging your ?hide. See “Tc ‘ng Yo
Vehicle’’ in the lnde
To Start Your 5.7 Liter (Code K) engine
or 7.4 Liter (Code N) engine:
1. Automatic Transmission
Move your shift lever to P (Park) or N (Neutral). Your engine won’t start
in any other position-that’s a safety feature.
To restart when you’re
already moving,
use N (Neutral) only.
2-1 3
ProCarManuals.com

Features &
Don’t try to shift to P (Park) if your vehicle is moving. If you do, you
could damage the transmission. Shift to
P (Park) only when your vehicle is
stopped.
m
Manual Transmission
Shift your gear selector to neutral and hold the clutch pedal to the floor
while starting the engine. Your vehicle won’t start
if the clutch pedal is
not all the way down-that’s a safety feature.
2. Don’t push the accelerator pedal before starting your engine.\
In some
other vehicles you might need
to do this, but because of your vehicle’s
computer systems, you don’t.
3. Turn your ignition key to Start. When the engine starts, let go of the
key. The idle speed will
go down as your engine gets warm.
7.4L Engine Cold Start: In cold weather, below 60” F (16” C), start the
engine the same way but push the accelerator pedal one-quarter \
of the
way down and hold it there for about
2 seconds after the engine starts.
Holding your key
in Start for longer than 15 seconds at a time will cause
vwr battery
to be drained much sooner. And the excessive heat can
,clmage your starter motor.
4. If it doesn’t start right away, hold your key in Start. If it doesn’t start in
three seconds, push the accelerator pedal about one-quarter of \
the way down for 12 more seconds, or until it starts.
flooded with
too much gasoline. Try this:
5. If your engine still won’t start (or starts but then stops), it could be
Wait 15 seconds to let the starter motor cool down. Then push your
accelerator pedal all the way
to the floor. Hold it there. Then, hold the
key in
Start for no more than ten seconds. This clears the extra
gasoline from the engine.
If the engine still doesn’t start, wait another 15
seconds and do Step 5 again.
Hot Engine Restart, 5.7L and 7.4L Engines (Vehicles Over 8500 GVWR): If
your engine is already hot and then stalls, turn your ignition\
key to Off. Then,
turn your key
to Run, and wait about 20 seconds before you restart your
engine.
2-1
4
ProCarManuals.com

When the engine starts, let go of the key and accelerator ped\
al. Your engine is designed to work with the electronics in your vehicle.
If you 1
add electrical parts or accessories, you could change the way the fuel
injection system operates. Before adding electrical equipment, ch\
eck with
your dealer. If you don’t, your engine might not perform properly.
If you ever have to have your vehicle towed, see the part of this Manu; .
that tells how to do it without damaging your vehicle. See “Towing Your
Vehicle” in the Index.
NOTICE I
If you -drive too quickly through deep puddles or standing water, water can
come
in through your engine’s air intake and badly damage your engin\
e. 1%-
you can’t avoid deep puddles or standing water, drive through very slowlv. I
--
Never drive through standing water more than 8 inches deep if yo~
vehicle has a diesel engine.
Also, don’t drive through any standing water
faster than
5 mph (8 kmh). If you do, water can be drawn in through the
air intake, and this can severely damage your engine.
-
Driving In Snow (Diesel Engines)
When driving in a heavy snowstorm or in swirling snow with a diesel engine,
snow can get into the air intake system.
If you keep driving in these
conditions, the air cleaner may get plugged, causing black smok\
e and
loss of
power. In an emergency,
if the air cleaner is plugged with snow, you can
remove the air cleaner. Then, drive to a place
of safety as soon as possible
and put the air cleaner back on.
Starting Your Diesel Engine
Your diesel .engine starts differently than a gasoline engine.
1. Automatic Transmission:
Move your shift lever to P (Park) or N (Neutral). Your engine won’t start
in any other position-that’s a safety feature.
To restart when you’re
already moving, use
N (Neutral) only.
2-1 5
ProCarManuals.com

Featums & Controls
Manual Transmission:
Move your shift lever to neutral and hold the clutch pedal to the floor
while starting the engine. Your vehicle won't start
if the clutch pedal is
not all -the way down-that's a safety feature.
2. Turn your ignition key to Run. Don't turn it to Start.
- LUUk
I
3. Press the accelerator pedal all the way down and then release \
it.
With the ignition in Run, the GLOW PLUGS light will come on. This
means that part
of your engine is being warmed up for better starting.
When the light goes
off, your engine is ready to start.
If the engine ls already warm, this light may not come.'on. That's normal.
4. If this light does not come on, or the instant the light goes off, turn your
ignition key to
Start. When the engine starts, let go of the key. I
2-1 6
f ProCarManuals.com

When your engine is cold, let it run for a few minutes before you move your
vehicle. This lets oil pressure build up. Your engine will sound louder when
it's cold.
NOTIP
-
If you're not in an idling vehicle and the engine overheats, you wouldn't
there to see the coolant temperature gage. This could damage your
hicle. Don't let vour enaine run when you're not
in vour vehicle.
Cold Weather Starting (Diesel Engine)
The following tips will help you get good starting in cold weather.
Use
SAE IOW-30 oil when the outside temperature drops below freezing.
When the outside temperature drops below
0°F (-18"C), use your engine
block heater.
If you park your vehicle in a garage, you shouldn't need to use \
the block
heater until the garage temperature goes below
0°F (-18"C), no matter how
cold it is outside.
To use the engine block heater, first turn
off the engine. Then open the hood,
unwrap the electrical cord and plug it in. It uses normal house voltage
(110
volts), but:
2-1 7
ProCarManuals.com

CAUTION
Plugging the cord into an ungrounded outlet could cause an ele\
ctrical
shock.
Also, the wrong kind of extension cord could overheat and
cause a fire. You could be seriously injured. Plug the cord into a
properly grounded three-prong
11 0-volt outlet. If the cord won’t reach,
use a heavy-duty three-prong extension cord rated for at least \
15
amps.
1 NOTICE
1 After you’ve used the block heater, be sure to store the cord in th~~~~
manner it was, to help keep it away from moving engine parts.\

If YOU
don’t, it could be torn and damaged.
~p@&%?yl~
How long should you keep tne MOCK neater plugged in? The answer depends
on the weather, the kind
of oil ,you have, and some other things. Follow this-
chart.
,.
ENGINE BLOCK HEATER USAGE”
Viscosity . 32’ $0 0°F ’ 0’ to -10°F ‘Belaw -1 0°F
Grade Oil (0” to &I S‘C) ’ ’ (-18’ to. -23°C) (B&w -23°C)
SAE Not Two Eight Hours
I OW-30 Required Hours or Overnight
SAE . Nit ’ . Two Eight Hours
15W-40 f3equired Hours or Overnight
..
* The times listed are minimum. times. It will not harm &her
the block heater
TO1 57
or the vehicle to leave it plugged in longer than the times stated. 3
For best results in cold weather, use Number I-D diesel fuel or a “winterized”
Number
2-D fuel.
If Your Diesel Engine Won’t- Start
If you’ve run out of fuel, look -at “Running Out Of Fuel” (see ‘‘Diesel Fuel
Requirements and Fuel System”
m the Index).
If you’re not out of fuel, and your engine won’t start, do this:
Turn y6ur ignition key
to Run. .Make sure that the GLOW PLUGS light is out.
Then turn
the ignition key to Stkrt while you ‘push the accelerator pedal
down.
2-1 8
ProCarManuals.com

. If the light. doesn’t go off, wait a few seconds, then try staiting your engine
again. And, see your dealer
as soon as you- can for a starting system check.
If the light comes on and then goes out and you know your batte\
ries are
charged, but your engine still won’t start, your vehicle nee\
ds service.
If your batteries don’t have enough .charge to start ,your engine, see “Battery”
in the Index.
Be sure you have the right oil for your engine, and that you’ve changed the
oil
at the proper times. If you use the wrong oil, your engine may be harder
to start.
If the engine starts, runs a short time, then stops, your vehicle needs service.
NOTICE
Don’t use starting “aids” such as ether or gasoline, in the m~v intakc They
could damage your engine.
..- - .- * K2214
In very cold weather, 0°F (-18°C) or colder, if you have an engine block
heater, it can help. You’ll get easier starting and better fuel economy during
engine warm-up.
2-1 9
ProCarManuals.com

Features & Controls
To use the block heater:
1.
Turn off the engine.
2. Open the hood and unwrap the electrical cord.
3. Plug it into a normal, grounded 110-volt outlet.
Plugging the cord into an ungrounded outlet could cause an electrical
- shock. Also, the wrong extension cord could overheat and cause a
fire. You could be seriously injured. Plug the cord into a properly
grounded three-prong 110-volt outlet.
If the cord won’t reach, use a
! heavy-duty three-prong extension cord rated for at least 15 amps.
After you’ve used the block heater, be sure
to store the cord in the
manner it was, to help keep it away from moving engine parts. If
you
don’t, it could be torn and damaged.
How long should you keep the block heater plugged in? The ans\
wer depends
on the weather, the kind of oil you have, and some other thi\
ngs. Instead of
trying to list everything here, we ask that you contact a Gen\
eral Motors
dealer in the area where you’ll be parking your vehicle. Th\
e dealer can give
you the best advice for that particular area.
2-20
ProCarManuals.com

Automatic lLansmission
K2362
There are several different positions for your gear lever.
P (Park)
This locks your rear wheels. It’s the best position to use when you start your
engine because your vehicle can’t move easily.
* It is dangerous to get out of your vehicle if the shift lever is not fully
in
P (Park) with the parking brake firmly set. Your vehicle can roll.
Don’t leave your vehicle when the engine is running unless \
you have
to. If you have left the engine running, the vehicle can move
suddenly. You or others could be injured.
To be sure your vehicle
won’t move, when you’re on fairly level ground, always se\
t your parking brake and move the shift lever to
P (Park).
If you have four-wheel drive, your vehicle will be free to roll-even
if
your shift lever is in P (ParkLif your transfer case is in N (Neutral).
So, be sure the transfer cas s in a drive gear-not N {“eutral).
See “Shifting Into
P- I;’’ in tne 3ex. If you are parking on a hill, or
if you’re pulling a traller, also see “Parking on Hills” \
or “Towing a
Trailer’’ in the Index.
2-2 1
ProCarManuals.com

Featums & Contmls
R (Reverse)
Use this gear to back up.
Shifting
to R (Reverse) while your vehicle is moving forward could damage
your transmission. Shift
to R (Reverse) only after your vehicle is stopped. I
b
1
damaging your transmission, see “If Yo$re Stuck: In Sand, Mud, Ice or
Snow” in the Index.
N (Neutral)
In this position, your engine doesn’t connect with the wheels.
To restart when
you’re already moving, use
N (Neutral) only. Also, use N (Neutral) when your
vehicle is being towed.
CAUTION I
Shifting out of P (Park) or N (Neutral) while your engine is “racing”
(running at high speed) is dangerous. Unless your foot is fi\
rmly on
the brake pedal, your vehicle could move very rapidly. You cou\
ld lose
control and hit people
or objects. Don’t shift out of P (Park) or N
wI ! your enaine is racing.
I
NOTICE
I
1
Damage to your transmission caused by shifting out of P (Park) or N
(Neutral) with the engine racing isn’t covered by your war\
ranty.
OD (Automatic Overdrive)
This position is
for normal driving. If you need more power for passing, and
you’re:
- Going less than about 35 mph (56 km/h), push your accelerator
- Going about 35 mph (56 kmlh) or more, push the accelerator all the
pedal about halfway down
way down
You’ll shift down
to the next gear and have more power.
OD should not be used when towing a trailer, carrying a heavy load, driving
on steep hills,
or for off-road driving. Select D (third gear) when operating the
vehicle under any of these conditions.
2-22
ProCarManuals.com