ignition HONDA ACCORD 2013 9.G Repair Manual
[x] Cancel search | Manufacturer: HONDA, Model Year: 2013, Model line: ACCORD, Model: HONDA ACCORD 2013 9.GPages: 595, PDF Size: 20.67 MB
Page 565 of 595

564Handling the Unexpected
FusesFuse LocationsIf any electrical devices are not working,
turn the ignition switch to LOCK
(0*1 and
check to see if any applicable fuse is blown.
Located near the brake fluid reservoir. Push
the tabs to open the box.
Fuse locations are shown on the fuse box
cover. Locate the fuse in question by the
fuse number and box cover number.
ā Circuit protected and fuse ratingā Engine Compartment Fuse Box
Circuit Protected
Amps
1
Battery
125 A
2
EPS
70 A
Fuse Box Main 1 (60 A)
Fuse Box Option 1
(40 A)
āā
ā
ā
ABS/VSA FSR 40 A
ABS/VSA Motor 30 A
3
ā
ā
ā
ā
ā
ā
ā
ā
4 Front Fog Light
*
(15 A)
5
Horn
10 A
6 Stop Light 10 A
7
FI Sub
15 A
8 DRL (7.5 A)
9
IG Coil
15 A
10 Injector
*2
20 A
11
Hazard
15 A
12 Fuse Box Main 2 60 A
Fuse Box Option 2 (40 A)
IG Main 1 50 A
30 A
*4
IG Main 2
*4
30 A
Sub Fan Motor 20 A
*2
30 A
*3
Headlight Low Beam Main 30 A
Fuse Box 30 A
Wiper Motor 30 A
Main Fan Motor 30 A Starter Motor
*4
30 A
13
Rear Defogger
40 A
14 Heater Motor 40 A
15
FI Main
15 A
Circuit Protected
Amps
*1:
Models with the smart entry system have an
ENGINE START/STOP button instead of an
ignition switch.
*2:4-cylinder models
*3:6-cylinder models
*4:Models with smart entry system
*5:Models with LED low beam headlights 16 Heated Door Mirror
*
(10 A)
17
MG Clutch
7.5 A
18 DBW 15 A
19
Small Light
20 A
20 Interior Light 7.5 A
21
Back Up
10 A
22 Audio 10 A
23
Fan Timer
7.5 A
24 Right Headlight Low Beam 10 A
15 A
*5
25
Left Headlight Low Beam
10 A
15 A
*5
26 ā ā
Circuit Protected
Amps
* Not available on all models
Page 567 of 595

566
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK
(0*1. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of
an ignition switch.
1 Inspecting and Changing FusesNOTICEReplacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 564 to 565.
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse Blown FuseFuse Puller
Page 578 of 595

577
Continued
Information
Emissions TestingTesting of Readiness CodesYour vehicle uses āreadiness codes,ā as part of its onboard self diagnostic system.
Some states refer to these codes during testing to see if your vehicle's emissions
components are working properly.
The codes may not be read if you go through the testing just after the battery has
gone dead or been disconnected.
To check if they are set, turn the ignition switch to ON
(w*1, without starting the
engine. The malfunction indicator lamp will come on for several seconds. If it then
goes off, the readiness codes are set. If it blinks five times, the readiness codes are
not set.
If you are required to have your vehicle tested before the readiness codes are ready,
prepare the vehicle for retesting by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engine off for 6 hours or more.
3. Make sure the ambient temperature is between 40°F and 95°F (4°C and 35°C).
4. Start the engine without touching the accelerator pedal, and let it idle for 20
seconds.
5. Keep the vehicle in
(P (automatic transmission/CVT) or
(N (manual
transmission). Increase the engine speed to 2,000 rpm, and hold it there for about 3 minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Testing of Readiness Codes
The readiness codes are erased when the battery is
disconnected, and set again only after several days of
driving under a variety of conditions.
If a testing facility determines that the readiness
codes are not set, you may be requested to return at
a later date to complete the test.
If the testing facility determines the readiness codes
are still not set, see a dealer.
Page 590 of 595

589Index
Fog Light Indicator.................................... 77
Folding Down the Rear Seat ................... 154
Foot Brake ................................................ 474
Forward Collision Warning (FCW) .......... 458
Front Airbags (SRS) .................................... 42
Front Seats ................................................ 148
Adjusting ................................................ 148
Fuel ..................................................... 19, 480
Economy................................................. 482
Gauge ...................................................... 89
Instant Fuel Economy .......................... 91, 96
Low Fuel Indicator..................................... 72
Range ................................................. 92, 95
Recommendation.................................... 480
Refueling ................................................ 480
Fuel Economy ........................................... 482
Fuel Fill Cap ........................................ 19, 481
Message ................................................. 561
Fuel Fill Door ...................................... 19, 481
Fuses ......................................................... 564
Inspecting and Changing ........................ 566
Locations ........................................ 564, 565GGasoline (Fuel) Economy................................................. 482
Gauge ...................................................... 89
Information............................................. 480
Instant Fuel Economy .......................... 91, 96
Low Fuel Indicator..................................... 72 Refueling ................................................. 480
Gauges ........................................................ 89
Gear Shift Lever Positions Automatic Transmission........................... 441
Automatic Transmission (CVT) ......... 435, 437
Manual Transmission ............................... 444
Glass (care) ................................................ 541
Glove Box .................................................. 158
HHalogen Bulbs ................................... 513, 515
Handling the Unexpected ........................ 543
HandsFreeLinkĀ® (HFL)....................... 339, 376
Auto Answer ................................... 355, 391
Automatic Import of Cellular Phonebook
and Call History ............................. 357, 393
Automatic Transferring .................... 355, 391
Displaying Messages ........................ 371, 410
Editing User Name ................................... 390
HFL Buttons ..................................... 339, 376
HFL Menus ...................................... 342, 378
HFL Status Display ........................... 341, 377
Limitations for Manual Operation .... 341, 377
Making a Call .................................. 361, 402
Options During a Call ...................... 368, 407
Phone Setup .................................... 347, 382
Phonebook Phonetic Modification ........... 397
Receiving a Call ............................... 367, 406
Receiving a Text Message/E-mail ...... 369, 408
Ring Tone ........................................ 356, 392 Selecting a Mail Account ................. 370, 409
Speed Dial ....................................... 358, 394
To Create a Security PIN .................. 354, 389
To Set Up a Text Message/E-mail
Options ......................................... 352, 387
Hard Disc Drive (HDD) Audio ................... 263
Hazard Warning Button .............................. 2
Head Restraints ........................................ 151
Headlights ................................................. 136
Aiming .................................................... 513
Automatic Operation............................... 137
Dimming ......................................... 136, 139
Operating................................................ 136
Heaters (Seat) ................................... 164, 165
Heating and Cooling System ................... 166
Cooling ................................................... 168
Defrosting the Windshield
and Windows ........................................ 168
Dust and Pollen Filter............................... 537
Heating ................................................... 167
HFL (HandsFreeLinkĀ® )....................... 339, 376
High Beam Indicator .................................. 76
Hill Start Assist System ..................... 428, 432
HomeLink Ā® Universal Transceiver ............ 337
IIdentification Numbers
Engine and Transmission ......................... 574
Vehicle Identification ............................... 574
Ignition Switch ......................................... 131