warning lights HONDA ACCORD HYBRID 2019 Owners Manual

78
Instrument Panel Indicators
M (sequential mode *
/
7-speed manual shift
mode *
) Indicator *
/
Gear Selection
Indicator *
 P. 84Parking Brake and
Brake System
Indicator (Red)
Parking Brake and
Brake System
Indicator (Amber)U.S.
Canada
U.S.
Canada
Automatic Brake
Hold System Indicator
Automatic Brake Hold
IndicatorU.S.
Canada
*1 : When you set the power mode to ON, these indicators come on to indicate that system checks are being perf ormed. They go off a few seconds later or after the engine
has started. If an indicator does not come on or turn off, th ere may be a malfunction in the co rresponding system. To resolve t he issue, follow the instructions in the
owner's manual.  P. 79*1
Malfunction Indicator
Lamp
Charging System
Indicator Anti-lock Brake System
( ABS ) IndicatorSeat Belt Reminder
Indicator
Low Fuel Indicator
Vehicle Stability Assist
® (VSA
® ) System Indicator
Vehicle Stability Assist
® (VSA
® ) OFF IndicatorSupplemental Restraint
System Indicator
Auto High-Beam
Indicator
Low Tire Pressure/TPMS
IndicatorElectric Power Steering
(EPS) System Indicator
Turn Signal and Hazard
Warning Indicators
Lights On IndicatorHigh Beam Indicator
Fog Light Indicator *ECON Mode Indicator System Message Indicator
SPORT Mode Indicator *
Adaptive Cruise Control
( ACC ) with Low Speed
Follow (LSF) Indicator
(Amber) *
/Adaptive Cruise
Control ( ACC ) Indicator
(Amber) *
Lane Keeping Assist
System ( LKAS ) Indicator
(Amber)
Safety Support Indicator
(Amber)
Safety Support Indicator
(Green/Gray) P. 80
 P. 82
 P. 82
 P. 83
 P. 84*1
*1
*1 *1
 P. 93*1
*1
Gear Position Indicator *
 P. 84
Transmission System
Indicator *
 P. 85 , 87
Shift Up Indicator *
 P. 88
Shift Down Indicator *
 P. 88  P. 89
 P. 89
 P. 90
 P. 90
 P. 90
 P. 91*1
*1
*1
*1
 P. 92*1
 P. 92
 P. 94  P. 99
*1
 P. 94
 P. 94  P. 97
 P. 94
Immobilizer System
Indicator
 P. 95 Security System Alarm
Indicator
 P. 96
 P. 96
 P. 98
 P. 100
 P. 101
 P. 104 *1
Adaptive Cruise Control
( ACC ) with Low Speed
Follow (LSF) Indicator
(Green) *
/Adaptive Cruise
Control ( ACC ) Indicator
(Green) *
 P. 100 *1
Lane Keeping Assist
System ( LKAS ) Indicator
(Green)
 P. 100 *1
* Not available on all models

94 uu Indicators u
Instrument Panel Indicator Name On/Blinking Explanation Message
Turn Signal and
Hazard
Warning
Indicators • Blinks when you operate the turn
signal lever.
• Blink along with al l turn signals if
you press the hazard warning
button. • Does not blink or blinks rapidly - A
turn signal light bulb has blown. Change
the bulb immediately. 2 Replacing Light Bulbs P. 633, 634
—
High Beam
Indicator • Comes on when the high beam
headlights are on. — —
Lights On
Indicator • Comes on whenever the light
switch is on, or in AUTO when the
exterior lights are on. • If you set the power mode to VEHICLE OFF
while the lights are on, a chime sounds
when the driver’s door is opened. —
Fog Light
Indicator *
• Comes on when the fog lights are
on. — —
* Not available on all models

158 uu Gauges and Displays u Head-Up Display *
Instrument Panel The display also s hows the following
warnings.
• Lane Departure Warning: When your
vehicle is too close to the traffic lane lines,
the lane departure warning appears. 2 Lane Keeping Assist System (LKAS)
P. 550
• Head-up Warning Lights:
Flash when the BRAKE message appears
on the driver information interface. 2 Collision Mitigation Braking System TM

(CMBS TM
) P. 510
2 Adaptive Cruise Control (ACC) with
Low Speed Follow (LSF) *
P. 519Lane Departure Warning
* Not available on all models

223uu Interior Lights/Interior Convenience Items u Interior Convenience Items
Continued
Controls
Interior Convenience Items Pull the handle to op en the glove box.
You can lock the glove box with the built-in
key.
Push the cover to open the pocket.■ Glove Box 1 Glove Box
3
WARNING An open glove box can cause serious injury
to your passenger in a crash, even if the
passenger is wearing the seat belt.
Always keep the glove box closed while
driving.Glove Box
Handle
To Lock Models with trunk main switch
■ Center Pocket

uu Interior Lights/Interior Convenience Items u Interior Convenience Items
236
Controls The power mode must be in ON to use the
seat heaters.
Press the seat heater button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF se tting (no indicators on)
When the power mode is turned on after it is
turned off, the previous setting of front seat
heaters is maintained.■ Front Seat Heaters * 1 Front Seat Heaters *
Do not use the seat heaters even in LO when the
engine is off. Under such conditions, the battery may
be weakened, making the engine difficult to start.
After a certain period of time, the strength setting for
the front seat heaters will automatically be reduced
by one level at a time unt il the front seat heaters
shuts off. The elapsed time varies according to the
interior environment.3
WARNING Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
* Not available on all models

Continued
237uu Interior Lights/Interior Convenience Items u Interior Convenience Items
Controls
The power mode must be in ON to use the
seat heaters or ventilation.
Press the seat heater or the seat ventilation
button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF setting (no indicators on)
When the power mode is turned on after it is
turned off, the previous setting of front seat
heaters and ventilation is maintained.■ Front Seat Heaters and Seat Ventilation * 1 Front Seat Heaters and Seat Ventilation *
Do not use the seat heater s and the seat ventilation
even in LO when the engine is off. Under such
conditions, the battery ma y be weakened, making
the engine difficult to start.
After a certain period of time, the strength setting for
the front seat heaters will automatically be reduced
by one level at a time unt il the front seat heaters
shuts off. The elapsed time varies according to the
interior environment.3
WARNING Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
* Not available on all models

uu Interior Lights/Interior Convenience Items u Interior Convenience Items
238
Controls The power mode must be in ON to use the
seat heaters.
There is no heater in the rear center seating
position.
Press the seat heater button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF se tting (no indicators on)■ Rear Seat Heaters * 1 Rear Seat Heaters *
Do not use the seat heaters even in LO when the
engine is off. Under such conditions, the battery may
be weakened, making the engine difficult to start.
After a certain period of time, the strength setting for
the rear seat heaters will automatically be reduced by
one level at a time until the rear seat heaters shuts
off. The elapsed time varies according to the interior
environment.3
WARNING Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
* Not available on all models

Continued
469uu When Driving u Starting the Engine
Driving
You can remotely start the engine using the button on the remote.
■ To start the engine
When started remotely, the engine automati cally shuts off after 10 minutes of idling
and/or the brake pedal and ENGINE START/STOP button have not been pressed
simultaneously.
To extend the run time for another 10 mi nutes during the first run, press the
button, then press an d hold the button.
u Some exterior lights flash six times if a 10-minute extension request was
transmitted successfully.■ Remote Engine Start with Vehicle Feedback * 1 Remote Engine Start with Vehicle Feedback *
The remote engine start may violate local laws.
Before using the remote e ngine start, check your
local laws.
If there are buildings an d obstacles between your
vehicle and the remote, th e range will be reduced.
The range may be less when the vehicle is running.
This distance may vary by external electrical
interference.
The engine may not start by the remote engine start
if:
• You have disabled a remo te engine start setting
using the audio/information screen.
• The power mode is not in VEHICLE OFF.
• The transmission is in a position other than ( P
.
• The hood is open, or any door or the trunk is
unlocked.3
WARNING Engine exhaust contains toxic carbon
monoxide.
Breathing carbon monoxide can kill you or
cause unconsciousness.
Never use the remote engine starter when
the vehicle is parked in a garage or other
area with limited ventilation.Press the button, th en press and hold
the button.
Some exterior lights flash once. Go within the range,
and try again.
LED: Blinks when any button is pressed.
Some exterior lights flash six
times if the engine runs
successfully. Some exterior lights will not
flash if the engine runs
unsuccessfully.
* Not available on all models

Continued
511uu Honda Sensing ® u Collision Mitigation Braking System TM
(CMBS TM
)
Driving
■ When the system activates
At system’s earliest collision alert st age, you can change the distance ( Long /
Normal / Short ) between vehicles at which alerts will come on through audio/
information screen setting options. 2 Customized Features P. 370, 381 1 Collision Mitigation Braking System TM
(CMBS TM
)
The camera in the CMBS TM
is also designed to detect
pedestrians.
However, this pedestrian detection feature may not
activate or may not detect a pedestrian in front of
your vehicle under certain conditions.
Refer to the ones indicating the pedestrian detection
limitations from the list.
2 CMBS TM
Conditions and Limitations P. 514
The head-up warning uses a lens located at the front
end of the dashboard.
Do not cover the lens or spill any liquid on it.Models with head-up display
LensThe system provides visual and audible alerts of a possible collisi on, and stops if the
collision is avoided.
u Take appropriate action to prevent a collision (apply the brakes, change
lanes, etc.).
Beep Head-up
Warning
Lights *
Visual Alerts
Audible Alert
* Not available on all models

uu Honda Sensing ® u Collision Mitigation Braking System TM
(CMBS TM
)
514
Driving The system may automatically shut off and the safety support indicator (amber) will
come on under certain conditions. Some ex amples of these conditions are listed
below. Other conditions may reduce some of the CMBS TM
functions.2 Front Sensor Camera P. 568
■ Environmental conditions
• Driving in bad weather (rain, fog, snow, etc.).
• Sudden changes between light and dark, su ch as an entrance or exit of a tunnel.
• There is little contrast between objects and the background.
• Driving into low sunlight (e.g., at dawn or dusk).
• Strong light is reflected onto the roadway.
• Driving in the shadows of trees, buildings, etc.
• Roadway objects or structures are misint erpreted as vehicles and pedestrians.
• Reflections on the interi or of the windshield.
• Driving at night or in a dark condition such as a tunnel.
■ Roadway conditions
• Driving on a snowy or wet roadway (obscured lane marking, vehicle tracks,
reflected lights, road spray, high contrast).
• Driving on curvy, winding, or undulating roads.
• The road is hilly or the vehicle is approaching the crest of a hill.■ CMBS TM
Conditions and Limitations 1 Collision Mitigation Braking System TM
(CMBS TM
)
Have your vehicle checked by a dealer if you find any
unusual behavior of the sy stem (e.g., the warning
message appears too frequently).