key HONDA ACCORD SEDAN 2013 9.G Technology Reference Guide

67
\bNSTRUMENT PANEL \bND\bCAT\fRS
Malfunction \bndicatorsIf an indicator remains on, there may be a problem; see your dealer
\fn/\fff \bndicators
Condition \bndicatorsAction is needed by driver
PASSENGER AIRBAGO\b\b(next to display screen)
VSAO\b\b
\fRUISE \fONTROL on
E\fON Mode on Fog lights
on
Headlights on
Turn signals/hazards on
High beams on
\fharging system
Low brake fluid
ABS
(antilock brake system)
Malfunction lamp(check engine light)
TPMS(tire pressure monitoring system)
VSA®(vehicle stability assist)
Parking brake on\b
Release
Seat belt reminder\b
\basten seat belt(s)
Starter system
Brake system
Smart Entry System
Automatic light control
Low oil pressure
SRS
(supplemental restraint system)
EPS(electric power steering)
F\fW(forward collision warning
system)
LDW(lane departure warning
system)
Door/Trunk open\b
Close door(s) / trunk Low tire pressure\b
Add air
Maintenance Minder
TM\b
Make dealer appointmentLow fuel\b
Refill
LDW(blinks)\b\ftay in your laneF\fW(blinks)\bBrake
\fRUISE MAIN on
Immobilizer(blinks)\bUse correct key
Briefly appear with each engine start. Red and orange indicators are most critical. Blue
and green indicators are used for general information. See your Owner’s Manual for
more information.
13 Accord4D TRG_EXL NAVI\fATG_NEW STYLE 7/1\b/2012 3\f47 PM Page 5

1415
How It Works
O N E T O U C H T U R N S I G N A L
Use this quick and convenient method to signal a lane change.
• Lightly push the turn signallever up or down for a three\b
blink sequence.
• For a continuous signal, push the lever up or down until it
locks into place.
How It Works
A U T O H E A D L I G H T S W I T H W I P E R I N T E G R A T I O N
For your safety and convenience, your vehicle’s headlights automatically turn on when
you activate the windshield wipers.
• Make sure your headlights are in the AUTO position.
• Turn on your windshield wipers. The headlights also turn on.
• When you turn off the windshield wipers, the headlights turn off shortly after.
D R I V I N G P O S I T I O N M E M O R Y S Y S T E M ( D P M S )
Store driver’s seat positions into memory for each corresponding keyless remote
(\f or 2), which are recalled when you unlock the driver’s door with the remote
and enter the vehicle.
How It Works
\f. Turn on the vehicle. Make sure
the shift lever is in Park (P).3. Press SET. You will hear a beep.
2.Adjust your preferred seat
settings. 4.
Press the memory button
corresponding to the remote (\f
or 2) you are using. You will
hear two beeps.
Note\f Stored positions can also be recalled by pressing memory buttons
(\f or 2) on the door.
13 Accord4D TRG_EXL NAVI\fATG_NEW STYLE 7/13/2012 3\f42 PM Page 9