HONDA ACCORD SEDAN 2020 Owner's Manual (in English)
Manufacturer: HONDA, Model Year: 2020, Model line: ACCORD SEDAN, Model: HONDA ACCORD SEDAN 2020Pages: 728, PDF Size: 34.06 MB
Page 481 of 728

Continued479
uuWhen Driving uShifting
Driving
■When opening the driver’s door
If you open the driver’s door under the following conditions, the transmission 
automatically puts into 
(P;
• The vehicle is stationary with the engine  running, or moving at 1 mph (2 km/h) or 
slower.
• The transmission is in other than 
(P.
• You have unfastened the driver side seat belt.
u If you manually put the transmission from 
(P with the brake pedal depressed, 
the transmission will au tomatically return to 
(P once you release the brake 
pedal.
■When turning off the power mode
If you turn the engine off wh ile the vehicle is stationary, and the transmission is in 
other than 
(P, the transmission automatically puts into (P.
1 When opening the driver’s door
You should always put  the transmission into 
(P 
before opening the driver’s door.
Make sure to park the vehicle in a safe place. 2 When Stopped  P. 587
If you want to drive the ve hicle after the transmission 
has automatically put into 
( P under the described 
conditions, close the door,  fasten the seat belt, 
depress the brake pedal,  then change the gear 
position.
If you leave the vehicle, tu rn off the engine and lock 
the doors. 
Page 482 of 728
![HONDA ACCORD SEDAN 2020  Owners Manual (in English) uuWhen Driving uShifting
480
Driving
■If you want to keep the transmission in (N position [car wash mode]
With the engine running:
1. Press and hold the brake pedal.
2. Press and release the 
(N but HONDA ACCORD SEDAN 2020  Owners Manual (in English) uuWhen Driving uShifting
480
Driving
■If you want to keep the transmission in (N position [car wash mode]
With the engine running:
1. Press and hold the brake pedal.
2. Press and release the 
(N but](/img/13/34454/w960_34454-481.png)
uuWhen Driving uShifting
480
Driving
■If you want to keep the transmission in (N position [car wash mode]
With the engine running:
1. Press and hold the brake pedal.
2. Press and release the 
(N button. 
u
(N (Neutral) hold mode will appear on  the driver information interface.
3. Press the 
(N button again and hold it for two seconds.
u The vehicle will enter car wash mode, wh ich must be used when your vehicle 
is pulled through a conveyor type automatic car wash where you or an 
attendant do not remain in the vehicle.
If the ENGINE STOP/START  button is pressed 
after car wash mode has been activated, the 
power mode will change to ACCESSORY and 
a message will be displayed on the driver 
information interface. u For 15 minutes the transmission remains 
in 
(N with the power mode will remain 
in ACCESSORY. After that, the 
transmission automatically changes to 
(P and the power mode changes to OFF.
u Manually changing to 
(P cancels 
ACCESSORY mode. The 
(P indicator 
comes on and the power mode changes 
to OFF. You must always put the 
transmission into 
(P when car wash 
mode is no longer needed.
1 If you want to keep the transmission in (N position [car wash 
mode]
NOTICE
When transmission is too hot, carwash mode may 
not be available. Let the engine idle and cool down 
transmission.
To keep the vehicle in 
(N position, you can also 
follow this procedure: 
While the power mode  is on, select 
(N, and then 
within five seconds, press the  ENGINE STOP/START 
button.
Note that the transmiss ion may not stay in 
(N 
position while any of the  following indicators is on:
•Transmission system indicator.
•Malfunction indicator lamp.•Charging system indicator. 
Page 483 of 728

481
uuWhen Driving uShifting
Continued
Driving
■Restriction on selecting a gear position
You cannot select a transmission under certain  circumstances that may lead to a crash.
When the transmission 
is in:1. Under the 
circumstances of that:2. You cannot select:3. The transmission 
remains in/changes to:How to change 
the transmission
(P
The brake pedal is not 
depressed.
Other transmission
(P
Release the 
accelerator pedal 
and depress the 
brake pedal.
The accelerator pedal is 
depressed.
(N
The vehicle is moving at 
low speed without the 
brake pedal depressed.
(N
The vehicle is moving at 
low speed with the 
accelerator pedal 
depressed.
(N or (DThe vehicle is moving 
forward.(RStop your vehicle in 
a safe place, depress 
the brake pedal, and 
select the 
appropriate 
transmission.
(R or (NThe vehicle is moving 
backward.(D
(R, (N or (DThe vehicle is moving.(P 
Page 484 of 728

482
uuWhen Driving uShifting
Driving
Use the paddle shifters to change between  1st and 10th gears without removing 
your hands from the steering wheel. The tr ansmission will switch to the sequential 
mode.
■When the transmi ssion is in (D:
The vehicle will go into  the sequential mode moment arily, and the gear selection 
indicator will come on.
When the vehicle goes into the sequential mode by 
(- paddle shifter and the lower 
gear is available, the trans mission properly selects single or double gear change.
Once you start traveling at a constant sp eed, the sequential mode will automatically 
switch off, and the gear sele ction indicator will go off.
Hold the 
(+ paddle shifter for two seconds  to return to normal drive.
■When the transmission is in (D with SPORT mode:
The vehicle will go into the sequential mode, and the  M (sequential mode) indicator 
and gear selection indicator will come on.
If the vehicle speed increases and the engi ne speed reaches near the tachometer’s 
red zone, the transmission automatica lly shifts up to the next gear.
You can cancel this mode by holding the 
(+ paddle shifter for two seconds. When 
the sequential mode is canceled, the sequen tial mode indicator and gear selection 
indicator go off.
■Sequential Mode 
Page 485 of 728

483
uuWhen Driving uShifting
Driving
■Sequential Mode Operation1Sequential Mode Operation
Each paddle shift operation makes a single gear 
change.
To change gears continuously, release the paddle 
shifter before pulling it again for the next gear.
If the gear select ion indicator blinks  when you try to 
shift up or down, this means your vehicle speed is not 
in its allowable gear ra nge or the protection of 
transmission system is necessary.
Slightly accelerate to shift up and decelerate to shift 
down while the indi cator is blinking.
Gear Selection 
Indicator
(- Paddle Shifter 
(Shift down)( + Paddle Shifter 
(Shift up)
Downshifting when pulling 
the ( - paddle shifter.
(Changes to a lower gear) Upshifting when pulling 
the (
+ paddle shifter.
(Changes to a higher gear) 
Page 486 of 728

484
uuWhen Driving uShifting
Driving
Shifting
Change the shift positi on in accordance with your driving needs.
■Shift lever positions
Continuously variable transmission models without paddle shifters
1Shifting
You cannot change the power mode from ON to 
VEHICLE OFF unless the shift lever is in 
(P.
The vehicle may move ve ry slightly even in 
(N while 
the engine is cold.
Depress the brake pe dal firmly and, when necessary, 
apply the parking brake.
Reverse
Used when reversing
Drive
Used for normal driving
Park
Used when parking or starting the engine
Neutral
Transmission is not locked.
Release Button
Drive (S)
Used:
●For better acceleration●To increase engine braking●When going up or down hills
Low
Used:
●To further increase engine braking●When going up or down hills 
Page 487 of 728

485
uuWhen Driving uShifting
Driving
■Shift Lever Operation1Shift Lever Operation
NOTICE
When you change the shift lever from (D to ( R and 
vice versa, come to a complete stop and keep the 
brake pedal depressed.
Operating the shift lever be fore the vehicle has come 
to a complete standstill  can damage the transmission.
Use the gear position indi cator to check the lever 
position before pulling away.
If the transmission system indicator blinks when 
driving, in any shift positi on, there is a problem with 
the transmission.
Avoid sudden acceleration  and have the transmission 
checked by a dealer as soon as possible.
The fuel supply may be cut of f if you drive at engine 
speeds in or over the tac hometer’s red zone (engine 
speed limit). If this happe ns, you may experience a 
slight jolt.
It may not be possible to operate the shift lever if the 
brake pedal is applied while the shift lever release 
button is held down.
Depress the brake pedal first.
When shifting positions in extremely low 
temperatures (-22°F/-30°C), there may be a short 
delay before the shift posit ion is displayed. Always 
confirm you are in the corr ect shift position before 
driving.
Depress the brake pedal and press the shift lever release 
button to shift.
Shift without pres sing the shift lever release button.
Press the shift lever release button and shift.
Gear Position Indicator 
(Transmission System Indicator) Tachometer’s red zone 
Page 488 of 728

486
uuWhen Driving uShifting
Driving
Shifting
Change the shift positi on in accordance with your driving needs.
■Shift lever positions
Continuously variable transmission models with paddle shifters
1Shifting
You cannot change the power mode from ON to 
VEHICLE OFF unless the shift lever is in 
(P.
The vehicle may move ve ry slightly even in 
(N while 
the engine is cold.
Depress the brake pe dal firmly and, when necessary, 
apply the parking brake.
Reverse
Used when reversing
Drive
Used:
●For normal driving●When temporarily driving in the 7-speed 
manual shift mode
●When driving in the 7-speed manual 
shift mode (when driving in SPORT 
mode)
Neutral
Transmission is not locked.
Release Button
Park
Used when parking or starting the engine 
Page 489 of 728

Continued487
uuWhen Driving uShifting
Driving
■Shift Lever Operation1Shift Lever Operation
NOTICE
When you change the shift lever from (D to ( R and 
vice versa, come to a complete stop and keep the 
brake pedal depressed.
Operating the shift lever be fore the vehicle has come 
to a complete standstill  can damage the transmission.
Use the gear position indi cator to check the lever 
position before pulling away.
If the transmission system indicator blinks when 
driving, in any shift positi on, there is a problem with 
the transmission.
Avoid sudden acceleration  and have the transmission 
checked by a dealer as soon as possible.
The fuel supply may be cut of f if you drive at engine 
speeds in or over the tac hometer’s red zone (engine 
speed limit). If this happe ns, you may experience a 
slight jolt.
It may not be possible to operate the shift lever if the 
brake pedal is applied while the shift lever release 
button is held down.
Depress the brake pedal first.
When shifting positions in extremely low 
temperatures (-22°F/-30°C), there may be a short 
delay before the shift posit ion is displayed. Always 
confirm you are in the corr ect shift position before 
driving.
Depress the brake pedal and press the shift lever release 
button to shift.
Shift without pressing the shift lever release button. Press the shift lever re lease button and shift.
Gear Position Indicator 
(Transmission System Indicator)Tachometer’s red zone
M  (7-Speed Manual Shift Mode) 
Indicator
Gear Selection Indicator  
Page 490 of 728

uuWhen Driving uShifting
488
Driving
Use the paddle shifters to change betw een 1st and 7th speeds without releasing 
your hands from the steering wheel. The transmission switches to the 7-speed 
manual shift mode when you pull a paddle shi fter while driving. This mode is useful 
when engine braking is needed.
■When the shift lever is in (D:
The shift mode goes into the 7-speed ma nual shift mode temporarily, and the 
number is displayed in the gear selection indicator.
The 7-speed manual shift mode is canceled  automatically if you drive at constant 
speed or accelerate, and the number in the gear selection indicator goes off.
You can cancel this mode by pulling the 
(+ paddle shifter for a few seconds.
The 7-speed manual shift mode  is especially useful when reducing the vehicle speed 
temporarily before making a turn.
■When the shift lever is in (D with SPORT mode:
The shift mode goes into the 7- speed manual shift mode. The M indicator and the 
speed number are displayed in the gear se lection indicator. As the vehicle speed 
slows down, the transmission automaticall y shifts down accordingly. When the 
vehicle comes to a stop, it auto matically shifts down into 1st.
If the vehicle speed increases and the engi ne speed reaches near the tachometer’s 
red zone, the transmission automatically shifts up.
You can only pull away in 1st speed.
When canceling the 7-speed manu al shift mode, pressing the SPORT button. When 
the 7-speed manual shift  mode is canceled, the M indicator and gear selection 
indicator go off.
■7-Speed Manual Shift Mode1 7-Speed Manual Shift Mode
In the 7-speed manual shif t mode, the transmission 
shifts up or down by opera ting either paddle shifter 
under the following conditions:
Shift Up: The engine sp eed reaches the lowest 
threshold of the higher speed position.
Shift Down: The engine sp eed reaches the highest 
threshold of the lower speed position.
When the engine speed reaches near the 
tachometer’s red zone, the transmission shifts up 
automatically.
When the engine speed reaches the lowest threshold 
of the selected speed positi on, the transmission shifts 
down automatically.
Operating the paddle shifte rs on slippery surfaces 
may cause the tires to lock up. In this case, the 7-
speed manual shift mode is  canceled and goes back 
to the normal D driving mode.