light HONDA CR-Z 2011 1.G Service Manual

172
Features
General Information on the Audio System Recommended USB Flash Memory Devices
Recommended USB Flash Memory Devices Use a recommended USB flash memory device of 256 MB or higher. Recommended PC Card Based on PCMCIA 2.1/JEIDA 4.2:CompactFlashFlash ATASD memory card Always use the recommended memory card with the appropriate adapter (if an adapter is needed). Some memory cards will not work in this unit.Protecting PC Cards
■
Do not leave the PC card in the vehicle. Direct sunlight and high temperatures

•
may damage it.Make sure to put a PC card straight into the slot.

•
Do not insert anything other than a PC card into the slot.

•
Do not close the screen (move it to the upright position) until the PC card is

•
inserted all the way into its slot or is removed.We recommend backing up your data before using the device in your vehicle.

•
Never insert foreign objects into the PC card slot.

•
Main MenuTable of Contents

192
Driving
Before Driving
Driving Preparation
Check the following items before you start driving.Check Items Before Getting In the Vehicle

■
Make sure there is no obstruction on the windows, door mirrors, exterior lights,

•
or other parts of the vehicle.
Remove any frost, snow, or ice.
Remove any snow on the roof, as this can slip down and obstruct your field of
vision while driving. When frozen hard, remove ice once it has softened.
When removing ice from around the wheels, be sure not to damage the wheel or wheel components.
Make sure the hood is securely closed.

•
If the hood opens while driving, your front view will be blocked.
Make sure the tires are in good condition.

•
Check air pressures, and check for damage and excessive wear.
Checking and Maintaining Tires P.269
Make sure there is no person or object behind or around the vehicle.

•
There are blind spots from the inside.
Check Items in the Compartment

■
Store or secure all items on board properly.

•
Carrying too much cargo, or improperly storing it, can affect your vehicle’s
handling, stability, stopping distance, and tires, and make it unsafe.
Maximum Load Limit P.194
Do not pile items higher than the seat height.

•
They can block your view and may be thrown forward in the event of sudden
braking.
Check Items Before Getting On the Vehicle
NOTICE If the doors are frozen shut, use warm water around the door edges to melt any ice. Do not try to force them open, as this can damage the rubber trim around the doors. When done, wipe dry to avoid further freezing. Do not pour warm water into the key cylinder. You will be unable to insert key if the hole freezes.
Check Items in the Compartment
The headlight aim is set by the factory, and typically does not need to be adjusted. However, if you regularly carry heavy items in the cargo area, have the aiming readjusted at your dealer or by a qualiied technician.
Main MenuTable of Contents

197
Driving
When Driving
Starting the Engine
1. Make sure the parking brake is applied.
Automatic transmission (CVT) model
Check that the shift lever is in
2. P, then
depress the brake pedal.
Although it is possible to start the vehicle in
N, it is safer to start it in P.
Manual transmission model
Check that the shift lever is in
2. N. Then
depress the brake pedal with your right foot, and the clutch pedal with your left foot.
The clutch pedal must be fully depressed to start the engine.
Starting the Engine
Keep your foot irmly on the brake pedal when starting the engine. The engine is harder to start in cold weather and in thinner air found at altitudes above 8,000 feet (2,400 meters). When starting the engine in cold weather, turn off all electrical accessories such as the lights, climate control system, and rear defogger in order to reduce battery drain. If the exhaust sounds abnormal or if you can smell exhaust gas inside the vehicle, have your vehicle checked by a dealer. There may be a problem with the engine or exhaust system.
Brake Pedal
Brake Pedal
Clutch Pedal
continued
Main MenuTable of Contents

202
Driving
When Driving Shifting
Shifting
Automatic transmission (CVT) model
Change the shift position in accordance with your driving need.Names and Functions of Shift Lever Positions
■
Shifting
You cannot turn the ignition switch to LOCK

and remove the key unless the shift lever is in .
The vehicle may move forward very slightly even in
while the engine is cold.
Depress the brake pedal irmly and, when necessary, apply the parking brake. The engine may cut in and out in
R or depending
on the road condition, even when the engine
speed is lower than the tachometer’s red zone. This is the engine’s computer working to protect the transmission.
Park Used when parking or starting the engine. Reverse Used when backing up. Neutral Used when idling Drive Used for:
~
Normal driving
~
Temporarily driving in the 7-speed manual shift mode (when driving in ECON or NORMAL mode)
~
Driving in the 7-speed manual shift mode (when driving in SPORT mode)
~
Driving in L mode
Main MenuTable of Contents

203
Driving
When Driving Shifting
Shift Lever Operation
■ Shift Lever Operation
NOTICE
Before you move the shift lever from to and
vice versa, come to a complete stop and keep the brake pedal depressed.Operating the shift lever before the vehicle has come to a complete standstill can damage the transmission. Use the shift lever position indicator to check the lever position before pulling away. Whichever position the shift lever is in when driving, a blinking
indicator indicates a
transmission problem. Avoid sudden acceleration and have the transmission checked by a dealer as soon as possible. The fuel supply may be cut off if you drive at engine speeds in or over the tachometer red zone (engine speed limit). If this happens, you may experience a slight jolt. It may not be possible to operate the shift lever if the brake pedal is applied while the shift lever release button is held down.Depress the brake pedal irst.
Shift Lever Position Indicator
Tachometer's Red Zone
M (7-Speed Manual Shift Mode) Indicator/Shift Indicator
Depress the brake pedal and press the shift lever release button to shift.
Shift without pressing the shift lever release button.
Press the shift lever release button and shift. P
R
N D
Main MenuTable of Contents

205
Driving
When Driving Shifting
7-Speed Manual Shift Mode Operation
■
Paddle Shifter
(Shift down)
Downshifting when pulling the (–) paddle shifter (Changes to a lower speed number)Upshifting when pulling the + paddle shifter (Changes to a higher speed number)
Paddle Shifter
(Shift up)
7-Speed Manual Shift Mode Operation
Each paddle shift operation makes a single speed change.To change continuously, release the paddle shifter before pulling it again for the next speed. Recommended Shift Points Use this table as a guideline for eficient fuel economy and effective emission control.
Shift Up Normal Acceleration 1 to 2 15 mph (24 km/h)
2 to 3 25 mph (40 km/h)
3 to 4 40 mph (64 km/h)
4 to 5 47 mph (76 km/h)
5 to 6 52 mph (84 km/h)
6 to 7 57 mph (92 km/h)
If the position indicator blinks when you try to shift up or down, this means your vehicle speed is not in its allowable shifting range.Slightly accelerate to shift up and decelerate to shift down while the indicator is blinking.
Main MenuTable of Contents

207
Driving
When Driving Shifting
Shifting
Manual transmission model
Shift Lever Operation
■
Fully depress the clutch pedal to operate the shift lever and change gears, then slowly release the pedal. Depress the clutch pedal, and pause for a few seconds before shifting into
R, or
shift into one of the forward gears for a moment. This stops the gears so they won’t “grind.”
When you are not shifting, do not rest your foot on the clutch pedal. This can cause your clutch to wear out faster.
Shifting
NOTICE
Do not shift to before the vehicle comes to a
complete stop. Shifting to
before stopping can damage the
transmission. Recommended Shift Points Driving in the highest gear that allows the engine to run and accelerate smoothly helps to optimize fuel economy and emissions control. The following shift points are recommended:
Shift Up Normal Acceleration
1st to 2nd 15 mph (24 km/h)
2nd to 3rd 25 mph (40 km/h) 3rd to 4th 40 mph (64 km/h)
4th to 5th 47 mph (76 km/h)
5th to 6th 52 mph (84 km/h)
If you exceed the maximum speed for the gear you are in, the engine speed will enter into the tachometer's red zone. When this happens, you may experience a slight jolt.
NOTICE Before downshifting, make sure the engine will not go into the tachometer's red zone.Should this occur, it can severely damage your engine. There is a metallic part on the shift lever. If you leave the vehicle parked outside for a long time on a hot day, be careful before moving the shift lever. Because of heat, the shift lever may be extremely hot. If the outside temperature is low, the shift lever feels cold.
Main MenuTable of Contents

219
Driving
Braking
Brake System
Parking Brake
■
Use the parking brake to keep the vehicle stationary when parking.
To apply: Pull the lever fully up without pressing the release button. To release:
Pull the lever slightly, and press and hold
1.
the release button. Lower the lever down all the way, then
2.
release the button.
Parking Brake
NOTICE Release the parking brake fully before driving. The rear brakes and axle can be damaged if you drive with the parking brake applied. If you start driving without fully releasing the parking brake, a buzzer sounds as a warning, and "RELEASE PARKING BRAKE" appears on the multi-information display. Always apply the parking brake when parking.When the outside temperature is extremely cold, do not apply the parking brake to prevent it from freezing, and do the following:
Automatic transmission model Put the shift lever in , then place a block or other
wheel chock to stop the wheels from turning.
Manual transmission model Put the shift lever in or , then place a block
or other wheel chock to stop the wheels from turning.
Main MenuTable of Contents

220
Driving
Braking Brake System
Foot Brake
■
Your vehicle is equipped with disc brakes at all four wheels. A power assist helps reduce the effort needed on the brake pedal. The brake assist system increases the stopping force when you depress the brake pedal hard in an emergency situation. The anti-lock brake system (ABS) helps you retain steering control when braking very hard.
Brake Assist System P.222
ABS (Anti-lock Brake System) P.221
Foot Brake
Check the brakes after driving through deep water, or if there is a buildup of road surface water. If necessary, dry the brakes by lightly depressing the pedal several times. If you hear a continuous metallic friction sound when applying the brakes, the brake pads need to be replaced. Have the vehicle checked by a dealer.
Constantly using the brake pedal while going down a long hill builds up heat, which reduces the brake effectiveness. Apply engine braking by taking your foot off the accelerator pedal and downshifting to a lower gear. With manual transmission use a lower gear for greater engine braking. Do not rest your foot on the brake pedal while driving, as it will lightly apply the brakes and cause them to lose effectiveness over time and reduce pad life. It will also confuse drivers behind you.
Main MenuTable of Contents

221
Driving
Braking ABS (Anti-lock Brake System)
ABS (Anti-lock Brake System)
ABS
■
Helps prevent the wheels from locking up, and helps you retain steering control by pumping the brakes rapidly, much faster than you can do. The electronic brake distribution (EBD) system, which is part of the ABS, also balances the front-to-rear braking distribution according to vehicle loading. You should never pump the brake pedal. Let the ABS work for you by always keeping firm, steady pressure on the brake pedal. This is sometimes referred to as “stomp and steer.”
ABS Operation
■
The brake pedal may pulsate slightly when the ABS is working. Keep holding the pedal firmly down. On dry pavement, you will need to press on the brake pedal very hard before the ABS activates. However, you may feel the ABS activate immediately if you are trying to stop on snow or ice. When the vehicle speed goes under 6 mph (10 km/h), the ABS stops.
ABS (Anti-lock Brake System)
NOTICE The ABS may not function correctly if you use an incorrect tire type and size. When the ABS indicator comes on while driving, there may be a problem with the system.While normal braking is not affected, there is a possibility of the ABS not operating. Have the vehicle checked by a dealer immediately. The ABS does not reduce the time or distance it takes to stop the vehicle. It only helps with steering control during hard braking. In the following cases, your vehicle may need more stopping distance than a vehicle without ABS: When driving on rough road surfaces, including

•
when driving on uneven surfaces, such as gravel or snow.When tire chains are installed.

•
You may hear a motor sound coming from the
engine compartment while system checks are being performed immediately after starting the engine or while driving. This is normal.
Main MenuTable of Contents