oil level HONDA CR-Z 2011 1.G Owners Manual

Quick Reference Guide
14
TachometerSpeedometer
Ambient Meter
IMA Battery Charge Level Indicator CHRG/ASST Indicators
Instant Fuel Economy GaugeMulti-Information Display
Security Alarm System Indicator
Shift Lever Position Indicator
Shift Up/Down Indicator *
7-Speed Manual Shift Mode Indicator
* Fuel Gauge
Instrument Panel
P. 6 7
Gauges P.81 Multi-Information Display
P.83 System Indicators
P.68
Lights On Indicator

High Beam Indicator

Fog Light Indicator *
Malfunction
Indicator Lamp

Low Oil Pressure Indicator

12 Volt Battery Charging System
Indicator

Anti-lock Brake System (ABS)
Indicator

Vehicle Stability Assist (VSA ®
)
System Indicator

VSA ®
OFF Indicator

Turn Signal and Hazard Warning
Indicators

Electric Power Steering (EPS)
Indicator

IMA System Indicator

Auto Idle Stop Indicator
Seat Belt Reminder Indicator

Immobilizer System Indicator
Parking Brake and Brake System
Indicator

Supplemental Restraint System
Indicator
Side Airbag Off Indicator
U.S. models only
Low Tire Pressure/ TPMS Indicator

Door/Hatch Open Indicator

Cruise Main Indicator

Cruise Control Indicator

System Message Indicator
Lights Reminders
System Indicators System Indicators
High Temperature
Indicator

Low Temperature Indicator

Low Fuel Indicator
System Indicators
SPORT Mode Indicator

NORMAL Mode Indicator

ECON Mode Indicator
System Indicators
Main Menu

68
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
U.S.
Canada Parking Brake and Brake System Indicator Comes on briefly when you turn

•
the ignition switch to ON
II, then
goes off (comes on when the parking brake is applied).Comes on when the brake fluid

•
level is low.Comes on if there is a problem

•
with the brake system.The beeper sounds and the

•
indicator comes on if you drive with the parking brake not fully released. Comes on while driving

• - Make sure
the parking brake is released. Check
the brake fluid level.
What to Do When It Comes On While Driving P.302
Comes on along with the ABS

•
indicator - Have the vehicle checked
by a dealer.
If the Brake System Indicator Comes
On P.302
U.S. Canada
Low Oil Pressure Indicator Comes on when you turn the

•
ignition switch to ON
II, and goes
off when the engine starts. Comes on when the engine oil

•
pressure is low. Comes on during driving

• -
Immediately stop in a safe place. If the Low Oil Pressure Indicator Comes On P.299
Main MenuTable of Contents

238
Maintenance
Before Performing Maintenance
Inspection and Maintenance
For your safety, perform all listed inspections and maintenance to keep your vehicle
in good condition. If you become aware of any abnormality (noise, smell, insufficient brake fluid, oil residue on the ground, etc.), have your vehicle inspected by a dealer. (Note, however, that service at a dealer is not mandatory to keep your warranties in effect.) Refer to the separate maintenance booklet for detailed maintenance and inspection information.Types of Inspection and Maintenance

■
Daily Inspections
■
Perform inspections before long distance trips, when washing the vehicle, or when refueling.
Periodic Inspections
■
Check the automatic transmission fluid level monthly.
•
Automatic Transmission Fluid P.254
Check the brake fluid level monthly.
•
Brake/Clutch Fluid P.256
Check the tire pressure monthly. Examine the tread for wear and foreign objects.
•
Checking and Maintaining Tires P.269
Check the operation of the headlights, parking lights, taillights, high-mount
•
brake light, and license plate lights monthly.
Replacing Light Bulbs P.258
Check the condition of the wiper blades at least every six months.
•
Checking and Maintaining Wiper Blades P.266
Inspection and Maintenance
U.S. models only Maintenance, replacement, or repair of emissions control devices and systems may be done by any automotive repair establishment or individual using parts that are "certiied" to EPA standards. According to state and federal regulations, failure to perform maintenance on the items marked with # will not void your emissions warranties. However, all maintenance services should be performed in accordance with the intervals indicated by the multi-information display.
Maintenance Service Items P. 2 4 3
If you want to perform complex maintenance tasks that require more skills and tools, purchase the service manual.
Authorized Manuals P. 3 1 9
If you want to perform maintenance yourself, make sure that you have the necessary tools and skills irst.After performing maintenance, complete the records in the separate maintenance booklet.
Main MenuTable of Contents

243
Maintenance
Maintenance Minder™
Maintenance Service Items
■
System Message Indicator Maintenance Minder Message
Sub Items
Main Item
Maintenance Service Items
Independent of the maintenance minder
•
messages, replace the brake luid every 3 years. Inspect idle speed every 160,000 miles (256,000
•
km).Adjust the valves during services A, B, 1, 2, or 3
•
only if they are noisy.
*1: Change the engine oil according to the maintenance minder messages, or annually, whichever comes irst.
*2: If you drive in dusty conditions, replace the air cleaner element every 15,000 miles (24,000 km).
*3: If you drive primarily in urban areas that have high concentrations of soot in the air from industry and from diesel-powered vehicles, replace the dust and pollen ilter every 15,000 miles (24,000 km).
#: See information on maintenance and emissions warranty.
Code Maintenance Main Items
A Replace engine oil*
• 1
B Replace engine oil*
• 1
and oil filter
Inspect front and rear brakes
•
Check parking brake adjustment
•
Inspect tie rod ends, steering gear
•
box, and boots
Inspect suspension components
•
Inspect driveshaft boots
•
Inspect brake hoses and lines
•
(including ABS/VSA ®
)
Inspect all fluid levels and
•
condition of fluids
Inspect exhaust system
• #
Inspect fuel lines and connections
• #Code Maintenance Sub Items
1 Rotate tires •
2 Replace air cleaner element* • 2
Replace dust and pollen
•
filter* 3
Inspect drive belt
•
3 Replace transmission fluid •
4 Replace spark plugs •
Inspect valve clearance
•
5 Replace engine coolant •
Main MenuTable of Contents

248
Maintenance
Maintenance Under the Hood Oil Check
Oil Check We recommend that you check the engine oil level every time you refuel. Park the vehicle on level ground.Wait approximately 3 minutes after turning the engine off before you check the oil.1. Remove the dipstick (orange handle).Wipe the dipstick with a clean cloth or
2.
paper towel.Insert the dipstick back all the way into its
3.
hole.
4. Remove the dipstick again, and check the level. It should be between the upper and lower marks.
Oil Check
If it is near or below the lower mark, add oil.
Dipstick
Upper Mark Lower Mark
Main MenuTable of Contents

251
Maintenance
Maintenance Under the Hood Changing the Engine Oil and Oil Filter
6. Check that the filter gasket is not stuck to the engine contact surface.
If it is stuck, you must detach it.
Wipe away dirt and dust adhering to the
7.
contact surface of the engine block, and install a new oil filter. Put a new washer on the drain bolt, then
8.
reinstall the drain bolt.
Tightening torque: 29 lbf∙ft (39 N∙m, 4.0 kgf∙m)
Pour the recommended engine oil into the
9.
engine.
Engine oil change capacity (including filter): 3.8 US qt (3.6 L)
Reinstall the engine oil fill cap back and
10.
start the engine. Run the engine for a few minutes, and
11.
then check that there is no leak from the drain bolt or oil filter. Stop the engine, wait for a few minutes,
12.
and then check the oil level on the engine oil dipstick.
If necessary, add more engine oil.
Oil Filter
Changing the Engine Oil and Oil Filter
You will need a special wrench to replace the oil ilter. You can buy this wrench from a dealer. When installing the new oil ilter, follow the instruction supplied with the oil ilter. Reinstall the engine oil ill cap. Start the engine. The low oil pressure indicator should go off within ive seconds. If it does not, turn off the engine, and check your work.
Main MenuTable of Contents

255
Maintenance
Maintenance Under the Hood Transmission Fluid
Manual Transmission Fluid
■
Specified fluid: Honda Manual Transmission Fluid (MTF)
Check the fluid level when the engine is at normal operating temperature.
1. Park the vehicle on level ground. Remove the bolts with a wrench and clips
2.
with a flat-tip screwdriver, then carefully remove the under cover.
3. Remove the transmission filler bolt and washer. Carefully feel inside the bolt hole with your fingers.
Check if the fluid level is up to the edge
of the bolt hole.
If the fluid level is not up to the edge of the
4.
bolt hole, add Honda Manual Transmission Fluid (MTF) until it runs out of the hole. Put a new washer on the filler bolt, then
5.
reinstall the filler bolt.
Tightening torque: 33 lbf∙ft (44 N∙m, 4.5 kgf∙m)
Reinstall the under cover with the bolts
6.
and clips.
Manual Transmission Fluid
If Honda MTF is not available, you may use the API certiicated SAE 10 W-30 or 10 W-40 viscosity motor oil as a temporary measure.Replace with MTF as soon as possible. Motor oil does not contain the proper additives for the transmission and continued use can cause stiffer shifting.
Under CoverBolt
Clip
Main MenuTable of Contents

299
Handling the Unexpected
Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator Comes On
If the Low Oil Pressure Indicator Comes On
NOTICE Running the engine with low oil pressure can cause serious mechanical damage almost immediately.
■
Reasons for the Indicator to Come On
Comes on when the engine oil pressure is low.
What to Do as Soon as the Indicator Comes On
■
Immediately park the vehicle in a safe place.
1.
If necessary, turn the hazard warning lights on.
2.
What to Do After Parking the Vehicle
■
Stop the engine and let it sit for about one minute.
1.
Open the hood and check the oil level.
2.
Add oil as necessary.
Start the engine and check the low oil pressure indicator.
3.
The light goes out: Start driving again.
The light does not go out within 10 seconds: Stop the engine and
contact a dealer for repairs immediately.
Main MenuTable of Contents