tailgate HONDA CROSSTOUR 2012 1.G Technology Reference Guide

Malfunction IndicatorsIf an indicator remains on, there may be a problem; see your dealerOn\bOff Indicators
Condition IndicatorsAction is needed by driver
PASSENGER AIRBAGOFF(above Hazard Warning button)
SIDE AIRBAGOFF
VSAOFF
CRUISE CONTROL on
ECOFuel economyon
Fog lights*on
Headlightson
Turn signals/hazards on
CRUISE MAINonHigh beamson
Charging system
Low brake fluid, Brake system
Low oil pressure
ABS(anti\block brake system)
DRL(daytime running lights)
Malfunction indicator lamp(check engine light)
TPMS(tire pressure monitoring system)
VSA®(vehicle stability assist)
SRS(supplemental restraint system)
Parking brake on:
Release
Door/Tailgate open:
Close door(s) / tailgate
Seat belt reminder:
Fasten seat belt(s)
Low fuel:
Refill
Low tire pressure:
Add air
Maintenance MinderTM:
Make dealer appointment
INSTRUMENT PANEL INDICATORS
Immobilizer
Flashes: improperly coded key;
use correct key
Briefly appear with each engine start. Red and amber indicators are most critical.
Blue and green indicators are used for general information.
4\b
*if equipped
12 Crosstour TRG\fATG_NEW STYLE \b/30/2011 9\f43 AM Page 4

Removing the Spare TireStoring the Flat Tire
\f.Open the tailgate. Raisethe
removable tray and flipit over so the
carpeted side faces you.
3. Remove the plastic cover on the cargo
area lining using your key to access the
bolt for the spare tire holder. 4.
Attach the short end of the wheel
nut wrench to the spare tire holder
bolt. Turn the wrench
counterclockwise until the bolt
loosens.
5. Attach the long end of the wrench,
and turn it approximately 70 times.
Stop when you feel resistance and can
see the spare tire under the vehicle.
NOTE\b Turning the wrench any
further may cause damage.
6. Unhook the spare tire holder, and
remove the spare tire. 8.
Turn the wrench clockwise to
retighten the bolt and raise the holder
back into place.
NOTE\b If the holder is not raised, it
will be damaged during driving. \f.
Remove the plastic bag from the
tool kit case, and placethe flat tire
inside. Knotthe top of the bag to
secure the tire.
2. Puncture the bag, and passthe
holding belt through and around
one of the tire spokes.
3. Place the flat tire in the cargo
area. Thread the belt through
the cargo hook. Passthe belt
through the ring, and tightenthe
belt to secure the flat tire in
place.
C O M P A C T S P A R E T I R ETemporary replacement tire located underneath the rear cargo area. Have your regular
tire repaired or replaced by your dealer as soon as possible.
2. Remove the hook, and hook it to the
cargo side panel to hold the tray in
place. Remove the utility box to access
the wheel nut wrench in the tool kit.
7. Place the spare tire holder back on
the hook.
NOTE\b Do not place the flat tire in
the spare tire holder. This can damage
the holder.
2627
12 Crosstour TRG\fATG_NEW STYLE \b/30/2011 9\f4\b AM Page 15