HONDA FIT 2008 1.G Owners Manual

The head restraints in the rear outer
seating positions do not adjust f or
height. To remove one f or cleaning
or repair, push the release button,
and lif t the restraint up.
The f ront head restraints adjust f or
height. You need both hands to
adjust a restraint. Do not attempt to
adjust it while driving. To raise it,
pull upward. To lower the restraint,
push the release button sideways,
and push the restraint down.
Theyaremosteffectivewhenyou
adjust them so the center of the back
of the occupant’s head rests against
the center of the restraint.
Seats
88
RELEASE
BUTTON
FRONT
Failure to reinstall the head
restraints can result in severe
injury during a crash.
Always replace the head
restraints before driving.
\f—\f—y\fy
(
\fy\f\fy
2008 Fit

Remove the f ront head restraints
(see page ), and store them
securely.
You can recline the seat-backs on the
f ront seats so they are level with the
rear seat cushions, making a large
cushioned area. To do this:
Recline the rear seat-backs as far
backward as possible (see page ).
When a passenger is seated in the
rear center seating position, make
sure the center head restraint is
properly positioned.
Make sure the head restraint locks
in position when you reinstall it.
1.2.
87 88
CONT INUED
Reclining the Front Seats
Seats
Inst rument s and Cont rols
89
SLIDE LEVER
SEAT-BACK ANGLE
ADJUSTMENT LEVER
REAR CENTER
RELEASE BUTTON
\f—\f—y\f\fy
(
\fy\f\fy
2008 Fit

Pull up the rear seat cushion, and
f old the seat leg down. Push the seat
cushion f irmly against the seat-back
to lock it.
The lef t and right rear seat cushions
can be lifted up separately to make
room f or cargo.
Remove any items from the seat
beforeyoufolduptheseatcushion.
Pull up the seat-back angle
adjustment lever, and pivot the
seat-back backward until it is level
with the rear seat cushion.
Using the slide lever, move the
frontseatcushionsasfarforward
as possible.
Reverse this procedure to return the
f ront seats to the upright position.
When you return the seat-back to its
upright position, hold the seat-back
to keep it f rom going up too quickly.
Make sure you install the head
restraints and securely lock the seats
bef ore driving.
3.
4.
Seats
Folding the Rear Seat Up
90
\f—\f—y\f

y
(
\fy\f\fy
2008 Fit

Whenyoufolddownthedriver’sside
rear seat, use the latch plate to
release the center seat belt from the
detachable anchor (see page ).
Allow the seat belt to retract into the
holder on the ceiling, and store the
buckles in it.Move the front seat cushions as
f ar f orward as possible.
The rear seat-backs can be f olded
down f or more cargo room.
Each side f olds down separately, so
you can still carry a passenger in the
rear outer seating position.
Remove any items from the seat
before folding down the seat-back.
Make sure there are no items on the
floor before folding down the seats.
To return the seat cushion to its
original position, f irst make sure
there are no items on the f loor, then
pull up the seat leg f ully, and push
down the seat cushion slowly while
holding it with your hands. Set the
seat leg in the f loor guide. A latch
comes out when the leg is set
properly. 1. 93
CONT INUED
Folding the Rear Seat Down
Seats
Inst rument s and Cont rols
91
LATCH PLATE
FLOOR GUIDE LATCH LEG
\f—\f—y\f\fy
(
\fy\f\fy
2008 Fit

Make sure all items in the cargo area
are secured. Loose items can f ly
f orward and cause injury if you have
to brake hard (See
on page ).
To return the seat-back to its upright
position, move the front seat forward
again, then lift up the seat-back.
While lifting the seat-back, the seat
cushion may come up with it. To
secure the seat cushion, see page .
Make sure the seat-back and seat
cushion are locked securely and all
rear shoulder belts are positioned in
front of the rear seat-backs. In the
center seating position of the rear
seat, be sure the detachable anchor
is latched securely bef ore using the
seat belt (see page ).
Move the f ront seat backward to
the desired position. Make sure
theseatislockedinplace.
Do not put any heavy items on the
seat-back when it is folded down.
Make sure that the f olded down rear
seat does not interf ere with the f ront
passenger’s seat-back. This will
cause the f ront passenger’s weight
sensors and the f ront passenger’s
seat belt reminder indicator to work
improperly (see pages and ).
Also check the passenger airbag of f
indicator to assure proper operation
of the passenger’s front airbag.
Make sure the rear outer head
restraint is locked in place. If you
f old down the driver’s side seat-
back, also adjust the rear center
head restraint to its lowest
position.
Pull up the release lever on the
outside of the seat-back.
Fold the seat-back forward. 5.
31
18
14693 91
2.
3.
4.
Seats
Carrying Cargo
92
RELEASE LEVER
\f—\f—y\fy
(
\fy\f\fy
2008 Fit

Tug on the seat belt to verify that
the detachable anchor is securely
latched. Make sure the seat belt is
not twisted.
The seat belt in the rear center seat
is equipped with a detachable anchor.
This allows the center seat belt to be
unlatched when the driver’s side rear
seat is f olded.
Pull out the small latch plate and the
latch plate f rom each holding slot in
the ceiling, and pull out the seat belt
to extend it.Line up the triangle marks on the
small latch plate and anchor buckle
when reattaching the belt and buckle.
CONT INUED
Detachable Anchor
Seats
Inst rument s and Cont rols
93
SMALL LATCH
PLATE
LATCH PLATE
SMALL LATCH PLATE TRIANGLE
MARKS
ANCHOR BUCKLE
Using a seat belt with the
detachable anchor unlatched
increases the chance of serious
injury or death in a crash.
Before using the seat belt,
make sure the detachable
anchor is correctly latched.
\f—\f—y\fy
(
\fy\f\fy
2008 Fit

µTo open the driver’s
window f ully, push the window
switch f irmly down to the second
detent, and release it. The window
will automatically go down all the
way. To stop the window, pull back
on the window switch briefly.
Turn the ignition switch to the ON
(II) position to raise or lower any
window. To open the window, push
the switch down and hold it. Release
the switch when you want to stop the
window. To close the window, pull
back on the switch and hold it.
To unlatch the detachable anchor,
insert the latch plate into the slot on
the side of the anchor buckle. Store
the detachable anchor and seat belt
latch plates in the retractor housing.
To close the window, pull back on
the switch and hold it.
AUTO
Power Windows
Seats, Power Windows
94
DRIVER’S WINDOW SWITCH
MAIN SWITCH
ANCHOR BUCKLE
LATCH PLATEClosing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.
\f—\f—y\fy
(
\fy\f\fy
2008 Fit

Turn the ignition switch to the ON
(II) position.
Move the selector switch to L
(driver’s side) or R (passenger’s
side).
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.
When you push the MAIN switch in,
the switch is off, and the passenger
windows cannot be raised or lowered.
To cancel this f eature, push on the
switch again to get it to pop out.
Keep the MAIN switch of f when you
have children in the vehicle so they
do not injure themselves by
operating the windows
unintentionally.
2.
1.
CONT INUED
All models except Canadian DX
Adjusting the Power Mirrors
Mirrors
Power Windows, Mirrors
Inst rument s and Cont rols
95
SELECTOR SWITCH
ADJUSTMENT SWITCH
TAB
\f—\f—y\fy
(
\fy\f
\f\fy
2008 Fit

To apply the parking brake, pull the
lever up f ully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake
indicator on the instrument panel
should go out when the parking
brake is f ully released (see page ).
Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns the
adjustment switch of f to keep your
settings.
60
3.
4.
Parking Brake
Mirrors, Parking Brake
96
PARKING BRAKE LEVER
Driving the vehicle with the parking
brake applied can damage the rear
brakes and axles. A beeper will sound
if the vehicle is driven with the parking
brake on.
\f—\f—y\f\f\fy
(
\fy\f
\f
y
2008 Fit

Interior Convenience Items
Inst rument s and Cont rols
97
ACCESSORY
POWER SOCKET
VANITY MIRROR
SEAT-BACK POCKET SUN VISOR
PASSENGER’S
TRAY
BEVERAGE HOLDERS
REAR SIDE POCKET
(RIGHT SIDE) COAT HOOK
GLOVE BOXCOIN TRAY
CENTER POCKET
FRONT DOOR POCKET
\f—\f—y\f\fy
(
\fy\f
\fy
2008 Fit