light HONDA PASSPORT 2000 2.G Owner's Manual

Do not use engine antifreeze or
a vinegar/water solution in the

windshield washer reservoir.

Antifreeze can damage your vehicle's paint, while a
vinegar/water solution can
damage the windshield washer
pump. Use only commercially available windshield washer fluid.

In cold weather, warm the

windshield with the defrosters

before using the washers. This

will help prevent icing of the

windshield that may block your

vision.
Headlight
s

The rotating switch on the left lever controls the lights. Rotating this switch to the position
turns on the instrument panel
lights and all exterior lights
except the headlights. Rotating the switch to the position turns
on the headlights.
To change between low beamsand high beams, pull back on the lever until you hear a click, then
let go. The high beam indicator will light (see page 60) when the
high beams are selected.
To flash the high beams, pull the
lever back about half way and
then let it go. The high beams will stay on for as long as you hold the
lever back, no matter what
position the headlight switch is in.
Instrument s an d Control s
NOTIC
E

Headlights-On Reminder

You will hear a continuous tone
when the key is out of the ignitionswitch and the driver's door is
opened with the headlight switch in the "ON" position. This will
remind you to turn the headlights off. Never leave the headlights onwhen the engine is not running.
They can rapidly discharge the

battery.
Fo
g Light s

EX model only
When fog or heavy mist reducesyour forward vision, push thisswitch to turn the fog lights on.
The indicator light in the switch
turns on. Push the switch again to turn off the fog lights.
The fog lights operate only when the headlight low beams are in

use.
Illuminatio
n Contro l

The instrument panel lights turn on when the light switch is on.
Brightness of the instrument panel
lights is controlled by turning the illumination control knob
clockwise for brighter or counterclockwise for dimmer.
Instrument s an d Control s
DIMMER BRIGHTE
R

Rea
r Windo w an d Mirro r

Defogger s

With the ignition "ON," push the
defogger switch to use the rear
window and mirror defoggers.
The indicator light in the switch lights to show the defogger is on.
The defogger will shut itself off after 10 minutes. If the rear
window or mirrors are not
completely clear, press the switch again to turn on the defogger for
another 10 minutes. It also shuts
off when you turn off the ignition.
You have to turn it on again when
you restart the vehicle.
Make sure the rear window is
clear and you have good visibility
before starting to drive.
The defogger wires on the inside of the rear window can be easily
damaged. When cleaning the
glass, always wipe side to side.
Do not use any abrasive cleaners.

Rea r Windo w Wiper/Washe r

To operate the rear window wiper,
press the wiper button. The wiper
runs in intermittent mode until you press the button again. To wash the rear window, push
and hold the rear window washer
button. The washer and wiper will
run until you release the button.
The rear window wiper cannot be operated when the rear window is

unlocked.

Instrument s an d Control s
REAR WIPE R
BUTTO N
REA R WASHE R
BUTTO N

Tur
n Signa l Leve r

Push the lever fully up to signal a
right turn. Push it fully down to signal a left turn. Lights on the
front and rear of the vehicle will

flash.
The turn signal will cancel itself as
the turn is completed. In some
driving maneuvers, such as
changing lanes on an expressway, the steering wheel is not turned
back sufficiently after completing the turn to automatically cancel the
turn signal. In such maneuvers the
driver should manually return the
lever to the neutral or canceled
position when the turn is
completed.

Lane Change Signal In some turns, such as changing
lanes, the steering wheel is not
turned far enough to cancel the
turn signal. For convenience, you
can flash the turn signal by
moving the lever part way (to the
first stop) and holding it there.
The lever will return to the
horizontal position when you
release it. A green light on the instrument
panel flashes to indicate proper operation of the front and rear
turn signal lights. If the green
light remains on, but does not
flash, check for defective bulbs If the green light does not lightwhen the lever is moved, check
the fuse and indicator bulb.
Instrument s an d Control s

Hazar
d Warnin g Flashe r
Push the button to turn on the
hazard warning lights (four-way
flashers). All four outside turn signal lights and both indicators in
the instrument panel will flash.
Push the button again to turn them
off.
The turn signals do not work when the hazard warning lights
are on. Use the hazard warning lights to
warn other drivers that your
vehicle is a potential road hazard.
Avoid stopping on the roadway if

possible.

Cruis e Contro l
Refer to page 143 for operation of this system. Automati
c Transmissio n
The shift lever position indicator is in the instrument panel. The
appropriate letter or number
illuminates to show what position
the shift lever is in.
The 4-speed automatic transmission shift lever is
arranged with "P" (Park) position
at one end, followed in sequence
by "R" (Reverse), "N" (Neutral)Instrument s an d Control s

Transfe
r Contro l

4WD Models

The "4WD" indicator light illuminates when 4WD is engaged
with the 4WD-2WD switch.
"2H" (High Range, 2-Wheel

Drive)

Use this for normal driving on dry

pavement. This position gives

greater economy, quieter ride and

the least drivetrain wear.
"4H" (High Range, 4-Wheel

Drive)

Use this for normal driving on

gravel, wet, icy or snow-covered

roads. This position provides

greater traction than two-wheel

drive. Top speed is limited to 65

mph(105km/h).
"4L" (Low Range, 4-Wheel

Drive)

Use this for maximum power andtraction. Top speed is limited to
65 mph (105 km/h). Use "4L" for
climbing or descending steep hills, off-road driving, and hard
pulling in sand, mud or deep
snow.

Operating the 4WD-2WD Switch
2H 4H:To shift between
ranges, push the switch
with the vehicle goingin a straight line at any
speed below 65 mph
(105 km/h). The 4WD indicator will blink for
a short time as the
system completes the
shift.

Instrument s an d Control s

Shifting the Transfer Control

Lever
4H 4L: Stop the vehicle. Place
the transmission leverin "N" (Neutral)
position. Then move the transfer controllever from 4H to 4L,
or 4L to 4H.
Move the transfer control lever
quickly and securely between
positions. Do not stop midway.
The transfer gear box can be
damaged if the control lever is not
firmly in gear. Some noise is
normal when shifting.
Always stop the vehicle before shifting between low and high range (4H 4L or 4L 4H).
If the 4WD indicator continues to
blink rapidly, it indicates that the system was shifted out of
sequence. Stop the vehicle, select 4WD with the 4WD-2WD switch,
shift the lever from 4L to 4H, then
select 2WD. Drive in a straight
line to reset the system. If the indicator continues to blink, see
your Honda dealer.
Do not use 4-wheel drive for
driving on dry pavement. This
causes noise and wear, and taking
tight turns can damage thetransfer case and driveshafts. It
also reduces fuel economy.
Be careful that you do not exceed
the following maximum allowable speeds when accelerating.
Drivin
g Patter n Selecto r

You can select a driving pattern suitable for existing driving
conditions.
When neither "POWER" nor
"WINTER" lights are illuminated, the normal driving program for
general driving conditions is
operative.

Instrument s an d Control s

When more powerful acceleration
is needed, select the "POWER"
driving program. The "POWER
DRIVE" indicator light comes on when the driving pattern selector is set in the "POWER" position.
Push the button again to turn it
off.
Under inclement weather
conditions that cause slippery
roads, activating the "WINTER" mode will improve driving
operation. The "WINTER" mode may be activated while driving atspeeds of 6 mph (10 km/h) or less.
With the transmission lever in the
"P," "R," "N," or "D" position,
push the "WINTER" button on the

console.

The "WINTER DRIVE" indicator
light will illuminate whenever the
"WINTER" mode system is
activated, and the vehicle will
start off in third gear.
The "WINTER" mode is deactivated when the vehicle
reaches approximately 19 mph (30 km/h), when the transmission
is shifted into "3," "2," or "L," by
pushing the "WINTER" button again, or by turning the ignition
key to the "OFF" position. Operation of the "WINTER"
mode should be limited to
slippery road conditions only.
Operation of the "WINTER"
mode during normal driving
conditions will cause decreased
performance and sluggish
acceleration.
Instrument s an d Control s

5-Spee
d Manua l Transmissio n
The transmission has five fully synchronized forward speeds. The
gear shift pattern is provided on the transmission lever knob. The
backup lights turn on whenshifted into the reverse gear. Drivin
g Tip s
Always depress and release the
clutch pedal fully when shifting.
Do not rest your foot on the clutch
pedal while driving; this can cause the clutch to slip, resultingin damage to the clutch.
When you are stopped on an upgrade, do not hold the vehicle
in place by letting the clutch pedal
up part-way. Use the foot brake or
the parking brake.
Never shift into reverse gear until
the vehicle is completely stopped. Do not "over-speed" the engine
when shifting down to a lower gear.
The shift lever cannot be shifted directly from fifth gear into
Reverse. When shifting into
Reverse gear from fifth gear,
depress the clutch pedal and shift
completely into Neutral position,then shift into Reverse gear.Instrument s an d Control s

Shif
t Spee d Char t

The lower gears of the transmission are used for normal
acceleration of the vehicle to the
desired cruising speed. The
highest gear of the transmission is used to maintain the desiredspeed. The fifth gear is
recommended for use in
maintaining highway cruising speeds. Use of the fifth gear in
city traffic is not recommended.
The shift speed chart shows the speeds at which each upshift of
the transmission should be made
to get the best vehicle
performance and fuel economy. For cruising, choose the highest
gear for that speed (cruising speed
is defined as a relatively constant
speed operation).
The upshift indicator (U/S) lights to show recommended upshift
points. (Refer to "Indicator Lights.")
If the engine is "lugging" (the speed you are traveling at is too
slow for the gear the transmissionis in), downshift to the next lower
gear. You may need to downshift
two or more gear positions to
keep the engine from "lugging" or
to keep the performance at a satisfactory level.
Transfe
r Contro l

4WD Models
The "4WD" indicator lightilluminates when 4WD is engaged
with the 4WD-2WD switch.

"2H" (High Range, 2-Wheel

Drive)

Use this for normal driving on drypavement. This position gives
greater economy, quieter ride and
least drivetrain wear.
Instrument s an d Control s