maintenance schedule Hyundai Accent 2006 Owner's Guide

6OWNER MAINTENANCE
10
NOTE: It is imperative that vehicles fitted with an air conditioning system have a coolant concentration of the rec-ommended strength at all times. The use of the air conditioning system when the cooling system is filledwith water only will result in the heater matrix freezing and subse- quently bursting. SG050C1-E Coolant Level The engine coolant level may be ob- served through the side of the plasticcoolant reservoir (expansion tank) when the engine is cold. If the level is below the "L" mark, add coolant of the correctconcentration until the level is between the "L" and "F" marks. If the level falls below the "L" mark on a regular basisdespite being topped up, consult a Hyundai dealer.
SG050B1-E Coolant recommendations Only ethylene glycol based coolant with a corrosion inhibitor suited to aluminiumalloy engine components should be used in the cooling system. No further additives or inhibitors should be used.The coolant specific gravity should be checked as prescribed in the mainte- nance schedule to ensure adequatefrost and corrosion protection. In addi- tion, the engine coolant must be re- placed at the specified interval sincethe corrosion inhibitor properties dete- riorate with time. It is important to note that whilst anincrease in the concentration of anti freeze gives an increase in the level of frost protection, a solution which is inexcess of 65% anti freeze will result in reduced frost protection and engine overheating. Therefore the recom-mended concentration of 50% should not be exceeded for general use. The use of methanol based anti freezecompounds may result in engine over- heating and will invalidate the vehicle warranty.
HLC5005

6
OWNER MAINTENANCE
11
SG050D1-E To Change the Coolant The coolant should be changed at those intervals specified in the vehicle main-tenance schedule in Section 5. NOTE: Care should be taken to ensure that coolant is not allowed to spill onto the paintwork since the finish may become damaged. If coolant spill-age occurs, the affected area should be rinsed thoroughly with water.
1. Park the vehicle on level ground and
ensure that the parking brake is firmly applied, and the engine allowed tocool. Do not attempt this operation whilst the engine is hot since burning orscalding may result.
2. Prepare a suitable receptacle to col-
lect the displaced coolant and posi-tion this under the radiator drain tap.
3. With the heater temperature control
set to the "HOT" position, removethe radiator cap and open the radiator drain tap.
!
6. Start the engine with the radiator capstill removed and continue to add coolant as the level decreases as air is expelled from the system. When the level remains constant, replacethe radiator cap and replenish the coolant reservoir.
7. When the engine is hot, check to ensure that no coolant leaks arepresent.
4. When the engine coolant has drained completely, close the drain tap en-suring that this is not over tightened.
5. Prepare a suitable quantity of new
engine coolant (refer to section 9)and pour this into the radiator. WARNING:
The cooling fan is controlled by en- gine coolant temperature and maysometimes operate even when the engine is not running. Use extreme caution when working near theblades of the cooling fan so that you are not injured by a rotating fan blade. As the engine coolant tem-perature decreases, the fan will auto- matically shut off. This is a normal condition.
G050D01A
G050D02A

6OWNER MAINTENANCE
16
G110D02A-EAT Transaxle Fluid Level Checking The vehicle must be parked on level ground with the parking brake firmlyapplied and the engine at normal oper- ating temperature. (Normal operating temperature will only be achieved whenthe vehicle has been driven for 6 miles or more). With the engine idling and the footbrake applied, the transaxle selector shouldbe moved from the "P" position through to the "L" position and back to the "N" or "P" position.
SG110A2-E AUTOMATIC TRANSAXLE FLUID The automatic transaxle fluid level should be checked and changed atthose intervals prescribed in the main- tenance schedule. It is of paramount importance that only the specified fluidis used when replenishing or changing the fluid. The use of other fluids may irreparably damage the transaxle andinvalidate the manufacturers warranty. In addition the ingress of dirt or lint may prevent correct functioning of thetransaxle and care must be exercised to prevent the ingress of such matter.
CAUTION:
The transaxle on fluid level must be checked with the engine running and at normal operating temperature and therefore care must be exercised toprevent injury occurring through contact with rotating or hot parts of the engine.
! G110B03A-AAT Recommended Fluid Your Hyundai automatic transaxle is specially designed to operate with DIA- MOND ATF SP-III or SK ATF SP-III.Damage caused by a nonspecified fluid is not covered by your new vehicle limited warranty.
NOTE: Basically automatic transaxle fluid is red color. As driving distance in- creases, the fluid color turns darkishred gradually. It is normal condition and you should not use fluid color as a criterion for replacing the transaxlefluid. You must replace the automatic transaxle fluid in accordance withintervals specified in the vehicle maintenances schedule in section 5.
C090A01A-D

6OWNER MAINTENANCE
24
!
FUSIBLE LINKS
WARNING:
Under no circumstances should a fusible link be replaced with any- thing other than a new link of thesame rating. The use of higher rated links or other means of connecting the circuit will create a potential firehazard.
G190B01TB-GAT (Diesel Engine)
At the scheduled maintenance inspec- tion, belts should be examined forcracks, wear, fraying or other evidence of deterioration and replaced if neces- sary.Belt routing should also be checked to be sure there is no interference be- tween the belts and other parts of theengine. SG200A1-E The fusible link prevents damage to the wiring harness in the event of an elec-trical system malfunction. Failure of a fusiblelink is indicative of a serious overload condition having occurred andtherefore the electrical system should be checked by a Hyundai dealer before a replacement link is fitted.
A/C comp.
Auto tensioner Pulley
G190B01A
AlternatorPower steeringpump
G200A01A
Melted
Good

7EMISSION CONTROL SYSTEMS
2EMISSION CONTROL SYSTEMS
SH010A1-E (Not all models) Depending upon the market for which the vehicle is destined, the emission control system will comprise one or more of the following emission con-trol devices.
1) Crankcase emission control sys-
tem
2) Evaporative emission control sys-
tem
3) Exhaust emission control system In order that the proper functioning of the emission control systems may be ensured, it is recommended that thevehicle is inspected and maintained by an authorized Hyundai dealer in accordance with the maintenanceschedule in this manual. SH010B1-E
1. Crankcase Emission
Control System
The positive crankcase ventilation
system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase byintroducing fresh air to the crankcase through the air cleaner where this mixes with blow-by gases and thenpasses through the PCV valve into the intake manifold from where it sub- sequently enters the combustionchamber and is burned.
SH010C1-E
2. Evaporative Emission
Control System
The Evaporative Emission Control
System is designed to prevent fuel vapours from escaping into the atmo- sphere through the fuel tank ventila-tion system. Canister
Fuel vapours generated inside the
fuel tank are absorbed and stored ina charcoal canister. When the engineis started, the vapours stored in the canister are drawn into the induction system through the purge control so-lenoid valve and are subsequently burned. Purge Control Solenoid Valve
The purge control solenoid valve is
controlled by the ECU; when the en- gine coolant temperature is low or the engine is idling, the purge control valve is closed and fuel vapours re- main stored in the canister. Undernormal running conditions when the engine is warm, the valve opens and the vapours are drawn into the inlettract and subsequently burned in the combustion chamber.

10INDEX
4
I Ignition Sw itch ............................................................. 2-3
Immobilizer S ystem ..................................................... 1-5
Instrument Cluster and Indicator ..............................1-38
Interior Light
Interior light ............................................................ 1-63
Map light ................................................................ 1-62
JJump Starting .............................................................. 3-3
K
Key .............................................................................. 1-5 If you lose your keys ............................................. 3-14
Positions ................................................................... 2-4
Keyless Entry System ............................................... 1-10
LLubrication Chart ......................................................... 9-4
M Maintenance Intervals Explanation of scheduled maintenance items ......... 5-7
Maintenance and servicing requirements ................ 5-2
Maintenance under severe usage conditions .......... 5-6
Scheduled maintenance ............. .............................. 5-3
Mirrors
Interior rearview mirror ........................................... 1-66
Outside rearview mirror ...................... ...................1-64
Outside rearview mirror heater .............................. 1-65OOdometer / Trip
Odometer ....................................... 1-48
P Parking Brake ........................................................... 1-66
Pollen Filter ...................................................... 1-80, 6-21
Power Steering Fluid Level .......................................6-27
Power Windows ........................................................ 1-11
RRear S eat .................................................................. 1-15
Folding rear seatbacks ..................... ..................... 1-16
Head restraint adjustm ent ...................................... 1-14
Running In Your New Hyundai ................................... 1-4
SSeat Front seat ............................................................... 1-13
Rear seat ............................................................... 1-15
Rear seat entry (3-door model) ............................. 1-15
Seat Belts
3-Point type ............................................................ 1-20
Adjustable height .................................................... 1-19
Adjusting your seat belt ............. ............................ 1-20
Care of seat belts .................................................. 1-19
Precautions ............................................................ 1-18
Pre-tensioner seat bel t ........................................... 1-29
Sparking Plugs Replacement ....................................6-12
Speedometer ............................................................. 1-47
Starting ........................................................................ 2-5