bulb Hyundai Elantra 2006 Owner's Manual
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2006, Model line: Elantra, Model: Hyundai Elantra 2006Pages: 277, PDF Size: 10.18 MB
Page 72 of 277
1FEATURES OF YOUR HYUNDAI
58MULTI-FUNCTION LIGHT SWITCH
B340C03E-AAT Headlight Switch To operate the headlights, turn the barrel on the end of the multi-function switch. The first position turns on the parking lights, sidelights, tail lights andinstrument panel lights. The second position turns on the headlights. NOTE: The ignition must be in the "ON" position to turn on the headlights. Parking Light Auto Off If you do not turn the parking lights "OFF" after driving, the parking light will automatically shut "OFF" when thedriver's door is opened.
B340A01A-AAT COMBINATION TURN SIGNAL, HEADLIGHT AND HIGH-BEAMSWITCHTurn Signal Operation Pulling down on the lever causes the turn signals on the left side of the car to blink. Pushing upwards on the levercauses the turn signals on the right side of the car to blink. As the turn is completed, the lever will automaticallyreturn to the center position and turn off the turn signals at the same time. If either turn signal indicator light blinksmore rapidly than usual, goes on but does not blink, or does not go on at all, there is a malfunction in the system.Check for a burned-out fuse or bulb or see your Hyundai dealer.
B340B01A-AAT Lane Change Signal To indicate a lane change, move the lever up or down to a point where it begins flashing.The lever will automatically return to the center position when released.
HXDFL352
HXDFL360
Page 156 of 277
2
DRIVING YOUR HYUNDAI
3
!
TO START THE ENGINEBEFORE STARTING THE ENGINE
C020A01O-GAT Before you start the engine, you should always:
1. Look around the vehicle to be sure
there are no flat tires, puddles of oil, water or other indications of pos- sible trouble.
2. After entering the car, check to be sure the parking brake is engaged.
3. Check that all windows and lights are clean.
4. Check that the interior and exterior
mirrors are clean and in position.
5. Check your seat, seatback and headrest to be sure they are in theirproper positions.
6. Lock all the doors.
7. Fasten your seat belt and be sure
that all other occupants have fas- tened theirs.
8. Turn off all lights and accessories
that are not needed. C030A01A-GAT COMBINATION IGNITION SWITCH Before starting the engine:
o If your Hyundai is equipped with a
manual transaxle, place the shift lever in neutral and depress the clutch pedal fully.
o If your Hyundai has an automatic transaxle, place the shift lever in "P"(park).
o To start the engine, insert the igni- tion key and turn it to the "START"position. Release it as soon as the engine starts. Do not hold the key inthe "START" position for more than 15 seconds.
NOTE: For safety, the engine will not start if the shift lever is not in "P" or "N" Position (Automatic Transaxle).
WARNING (DIESEL ENGINE):
To ensure that sufficient vacuum exists within the brake system dur- ing cold weather start-up condi-tions, it is necessary to run the engine at idle for several seconds after starting the engine.
9. When you turn the ignition switch to
"ON", check that all appropriatewarning lights are operating and that you have sufficient fuel.
10.Check the operation of warning lights and all bulbs when key is inthe "ON" position.
Page 210 of 277
Engine Compartment ................................................... 6-2
General Checks ........................................................... 6-7
Checking the Engine Oil .............................................. 6-8 Changing the Oil and Filter ......................................... 6-11
Checking and Changing the Engine Coolant ..............6-14
Spark Plugs ................................ ................................. 6-17
Changing the Air Cleaner Filte r ...................................6-19
Checking the Transaxle Oil (Manual) ......................... 6-21
Checking the Transaxle Fluid (Automatic) .................6-22
Checking the Brakes .................................................. 6-24
Checking the Clutch Fluid ........................................... 6-26
Air Conditioning Care .................................................. 6-27
Changing the Air Conditioner Filter
(For Evaporator and Blower Unit) ............................ 6-28
Checking Drive Belts ................................................. 6-30
Checking and Replacing Fuses ................................ 6-31
Checking The Battery ................................................ 6-32
Checking The Eclectric Cooling Fans ........................6-34
Power Steering Fluid Level ......................................... 6-34
Removal of Water From The Fuel F ilter..................... 6-35
Headlight Aiming Adjustment ...................................... 6-36
Replacement of Light Bulbs ........................................6-38
Bulb Wattage ............................................................... 6-45
Fuse Panel D escription ............................................... 6-46
DO-IT-YOURSELF MAINTENANCE
6
6
Page 247 of 277
6 DO-IT-YOURSELF MAINTENANCE
38
4. Using a spanner of the correct
size, remove the headlight assem- bly mounting bolts.
HXDFL1009
5. Disconnect the power cord from the back of the headlight.
REPLACEMENT OF LIGHT BULBS
G260A03A-AAT Before attempting to replace a head- light bulb, be sure the switch is turned to the "OFF" position. The next paragraph shows how to reach the headlight bulbs so they may be changed. Be sure to replacethe burned-out bulb with one of the same number and wattage rating. See page 6-45 for the wattage de- scriptions.
CAUTION:
Keep the lamps out of contact with petroleum products, such as oil, gasoline, etc.
!
Replacement instructions:
1. Allow the bulb to cool. Wear eye protection.
2. Open the engine hood.
3. Always grasp the bulb by its plastic base, avoid touching the glass. G270A01E
G270A01E-GAT
HEADLIGHT AND FRONT TURN SIGNAL LIGHT
High beam Low beam
Turn signal light
HXDFL1022
Page 248 of 277
6
DO-IT-YOURSELF MAINTENANCE
39
HXDFL1011
7. Push the bulb spring to remove the headlight bulb. HXDFL1010
6. Turn the plastic cover counterclock- wise and remove it. 8. Remove the protective cap from
the replacement bulb and install the new bulb by matching the plas- tic base with the headlight hole. Retighten the bulb spring and re-connect the power cord.
9. Use the protective cap and carton to promptly dispose of the old bulb.
10.Check for proper headlight aim.
(1) High beam (2) Low beam (3) Front turn signal light HXDFL1013-1
(1)
(2)(3)
!
G270A03O
WARNING:
This halogen bulb contains gas under pressure and if impacted could shatter, resulting in flyingfragments. Always wear eye pro- tection when servicing the bulb. Protect the bulb against abrasionsor scratches and against liquids when lighted. Turn the bulb on only when installing in a head-light. Replace the headlight if dam- aged or cracked. Keep the bulb out of the reach of children anddispose of the used bulb with care.
Page 249 of 277
6 DO-IT-YOURSELF MAINTENANCE
40
4. To replace the rear combination
light, remove it from the bulb holder and install the new bulb.
(1) Stop/Tail light
(2) Rear turn signal light
(3) Back up light
(4) Rear Fog Light
HXDFL1016
HXDFL1014
G270D01E-GAT
REAR COMBINATION LIGHT (Rear Fog Light, Stop / Tail Light,
Back up light and Rear Turn Sig- nal Light)
4Door
1. Open the trunk lid.
2. Unscrew and remove the cover on the inside of the rear luggage trim. 3. Remove the mounting screws of
the rear combination light with a spanner. HXDFL1015
(1)
(2)
(3) G270D01E
(4)
(2) (3)
(1)
Except European Community European Community Only
Page 250 of 277
6
DO-IT-YOURSELF MAINTENANCE
41
HXDFL334
5Door(Luggage compartment)
1. Open the tail gate.
2. Remove the mounting screws of the rear combination light with a flat blade screwdriver.
HXDFL1017
3. To replace the rear combination light, remove it from the bulb holder and install the new bulb.
(1) Stop/Tail light(2) Rear turn signal light HXDFL335
HXDFL342
5Door (Tail gate)
1. Open the tail gate.
2. Remove the cover with a flat blade screwdriver.
(1) (2)
Page 251 of 277
6 DO-IT-YOURSELF MAINTENANCE
42
G270C01L-GAT
LUGGAGE COMPARTMENT LIGHT
4Door
1. Open the trunk lid.
2. Remove the plastic cover with a flat blade screwdriver.
3. Disconnect the power cord. HXDFL341B
HTB284
4. Replace with a new bulb.
HXDFL341A
HXDFL333 HXDFL332
Back up light
3. To replace the rear combination light, remove it from the bulb holder and install the new bulb.
Rear Fog light
Page 252 of 277
6
DO-IT-YOURSELF MAINTENANCE
43
5Door
1. Open the tail gate.
2. Remove the luggage compartment light cover on the right side pack- age tray panel with pushing it. HXDFL341
HTB284
3. Disconnect the power cord.
4. Replace with a new bulb.
HTB277
G270E01A-GAT
SIDE REPEATER (If installed)
G270E01A
1. Push the cover toward the front of vehicle and remove it.
2. Disconnect the power cord.
HXDFL343
Page 253 of 277
6 DO-IT-YOURSELF MAINTENANCE
44
G270G01E-GAT
INTERIOR LIGHT
Room Light
HXDFL1020
1. Remove the plastic cover with a flat blade screwdriver.
2. Replace with a new bulb. HXDFL1021
Screwdriver G270H01E-GAT
Map Light (If installed)
B460D02E
1. Remove the plastic cover with a flat blade screwdriver.
G270H01E
HTB278
3. Replace with a new bulb.
2. Replace with a new bulb.