bulb HYUNDAI ELANTRA SEL 2021 User Guide

Maintenance
9-52
OCN7080042
1. Open the hood.
2.
Disconnect the negativ
e battery
cable.
3.
Remo

ve the headlamp bulb cover by
turning it counterclockwise.
4.
Disconnect the headlamp bulb
socke

t-connector.
5.
Unsnap the headlamp bulb re

taining
wire by pressing the end and pushing
it upward.
6.
Remo

ve the bulb from the headlamp
assembly.
7.
Install a ne

w headlamp bulb and snap
the headlamp bulb retaining wire into
position by aligning the wire with the
groove on the bulb.
8.
Connect the headlamp bulb socke

t-
connector.
9.
Install the headlamp bulb co

ver by
turning it clockwise.
Information
The headlamp aiming should be adjusted
after an accident or after the headlamp
assembly is reinstalled at an authorized
HYUNDAI dealer. Headlamp/Daytime running light (DRL) /
Parking lamp (LED type)
If the lamp (LED) does not operate, have
the system checked by an authorized
HYUNDAI dealer.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamps have to be replaced
with the unit.
A skilled technician should check or
repair the LED lamp, for it may damage
related parts of the vehicle.

09
9-53
OCN7080043
Turn signal lamp (Bulb type)
1.
Open the hood.
2.
Disconnect the negativ

e battery
cable.
3.
Remo

ve the socket from
the assembly by turning the
socketcounterclockwise until the
tabs on the socket align with the slots
onthe assembly.
4.
Remo

ve the bulb from the socket
by pressing it in and rotating
itcounterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the socket.
5.
Insert a new bulb b

y inserting it into
the socket and rotating it until it locks
into place.
6.
Install the sock

et in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
7.
Push the socke

t into the assembly and
turn the socket clockwise.
OCN7090017N
Side marker (Bulb type)
1.
Open the hood.
2.
Disconnect the negativ

e battery
cable.
3.
Remo

ve the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
4.
Remo

ve the bulb from the socket by
pulling out the bulb.
5.
Insert a new bulb.
Side marker

(LED type)
If the LED lamp does not operate, have
the vehicle checked by an authorized
HYUNDAI dealer.

Maintenance
9-54
Side repeater lamp replacement
(if equipped)
OCN7080074L
If the LED lamp (1) does not operate,
have the vehicle checked by an
authorized HYUNDAI dealer.
Rear combination lamp bulb
replacement
OCN7A090018
(1) Stop lamp
(2)
Tail lamp (LED or bulb
)
(3)
Turn signal lamp
(4

)
Re
verse lamp
(5)
Rear side mark

er (LED or bulb)

09
9-55
Tail/Stop lamp/Turn signal lamp/
Side marker (Outer lamp) (Bulb type)
1. Open the trunk lid.
OCN7080045
2. Remove the service cover by pulling
out the service cover.
OCN7080046
3. Loosen the assembly retaining nuts.
OCN7080047
4. Remove the rear combination light
assembly from the body of the
vehicle.
OCN7080075L
OCN7090019N
[A] : Tail/Stop lamp, [B] : Turn signal lamp,
[C] : Rear side marker
5. Remove the socket from the
assembly b y turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
6.
Remo

ve the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on the
bulb align with the slots in the socket.
Pull the bulb out of the socket.
7.
Insert a new bulb b

y inserting it into
the socket and rotating it until it locks
into place.
8.
Install the sock

et in the assembly by
aligning the tabs on the socket with
the slots in the assembly. Push the
socket into the assembly and turn the
socket clockwise.

Maintenance
9-56
Tail lamp (Bulb type)
1. Open the trunk.
2.
Loosen the r
etaining screw of the
trunk lid cover and then remove the
cover.
OCN7080040
3. Remove the socket from the
assembly b y turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
4.
Remo

ve the bulb by pulling it out.
5.
Insert a new bulb b

y inserting it into
the socket.
6.
Reins

tall the trunk lid cover by
pushing in the screw.
Reverse lamp (Inner lamp)
(Bulb type)
1. Disconnect the connector and then
r emove the nuts by turning the nuts
counter clockwise.
2.
Tak

e the light assembly out.
OCN7080053
3. Remove the socket from the
assembly b y turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
4.
Remo

ve the bulb by pulling it out.
5.
Insert a new bulb b

y inserting it into
the socket.
6.
Install the ligh

t assembly to the trunk.
7.
Reins

tall the trunk lid cover by
pushing in the screw.
Stop/Tail lamp and rear side marker
(LED type)
If the LED lamp does not operate, we
recommend that you have the vehicle
checked by an authorized HYUNDAI
dealer.

09
9-57
High mounted stop lamp
replacement
OCN7080032
OAD075042[A] : High mounted stop lamp
1. Open the trunk.
2.
Remo
ve the socket by turning it
counterclockwise until the tabs on the
socket align with the slots.
3.
Remo

ve the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on the
bulb align with the slots in the socket.
Pull the bulb out of the socket.
4.
Insert a new bulb b

y inserting it into
the socket and rotating it until it locks
into place.
5.
Install the sock

et in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
Push the socket into the assembly and
turn the socket clockwise.
License Plate Light Bulb
Replacement
OCN7080035
1. Using a flat-blade screwdriver gently
pry the lens co ver from the lamp
housing.
2.
Remo

ve the bulb by pulling it straight
out.
3.
Install a ne

w bulb.
4.
Reins

tall in the reverse order.

Maintenance
9-58
Interior Light Bulb Replacement
„„Sunvisor lamp
OCN7050058
„„Trunk room lamp
OCN7050059
„„Map lamp
OCN7080033
„„Room lamp
OCN7080034
1. Using a flat-blade screwdriver, gently pry the lens from the interior lamp housing.
2.
Remo
ve the bulb by pulling it straight out.
WARNING
Prior to working on the Interior Lights, ensure that the “OFF” button is depressed to
avoid burning your fingers or receiving an electric shock.
3.
Install a ne

w bulb in the socket.
4.
Align the lens tabs with the int

erior lamp housing notches and snap the lens into
place.
NOTICE
Use care not to dirty or damage lens, lens tab, and plastic housings.

I
I-3
B
Battery
........................................................................\
.........................................9-24
Battery capacity label ........................................................................\
...............9-25
Battery Recharging ........................................................................\
................... 9-26
For Best Battery Service ........................................................................\
..........9-25
Reset items ........................................................................\
............................... 9-26
Before Driving
........................................................................\
............................... 6-4
Before Entering the V

ehicle
........................................................................\
....... 6-4
Before Starting ........................................................................\
........................... 6-4
Blind-Spot Collision W

arning (BCW)
................................................................. 7-36
Function malfunction and limitations ..............................................................7-41
Function operation ........................................................................\
.................... 7-39
Function settings ........................................................................\
...................... 7-37
Blind-Spot Collision-A

voidance Assist (BCA)
.................................................. 7-45
Function malfunction and limitations .............................................................. 7-54
Function operation ........................................................................\
.................... 7-49
Function settings ........................................................................\
...................... 7-47
Brake fluid
........................................................................\
................................... 9-18
Checking the brake fluid level ........................................................................\
.9-18
Brake System
........................................................................\
............................... 6-19
Auto Hold ........................................................................\
................................. 6-26
Disc Brakes W

ear Indicator
........................................................................\
...... 6-19
Electronic Parking Brake (EPB) .....................................................................6-22
Parking brake ........................................................................\
............................ 6-20
Power Brakes ........................................................................\
............................6-19
Bulb W

attage
........................................................................\
.................................. 2-8

Index
I-8
J
Jump Starting
........................................................................\
.................................8-4
L
Lane Following

Assist (LFA)
........................................................................\
... 7-105
Function malfunction and limitations ............................................................7-108
Function operation ........................................................................\
.................. 7-106
Function settings ........................................................................\
.................... 7-105
Lane Keeping

Assist (LKA)
........................................................................\
....... 7-30
Function malfunction and limitations ..............................................................7-34
Function operation ........................................................................\
.................... 7-32
Function settings ........................................................................\
..................... 7-30
LCD Display (T

ype A)
........................................................................\
................. 4-25
LCD Display Control ........................................................................\
...............4-25
LCD display modes ........................................................................\
.................. 4-26
Trip Computer ........................................................................\
.......................... 4-36
User settings mode ........................................................................\
...................4-29
LCD display (T

ype B)
........................................................................\
................. 4-40
LCD Display Control ........................................................................\
...............4-40
User settings mode ........................................................................\
................... 4-44
Utility group ........................................................................\
............................. 4-42
View modes ........................................................................\
.............................. 4-41
Light Bulbs
........................................................................\
.................................. 9-50
Headlamp, Parking Lamp, Daytime Running Light, T

urn Signal Lamp and
Side Marker ........................................................................\
............................ 9-51
High mounted stop lamp replacement ..............................................................9-57
Interior Light Bulb Replacement ...................................................................... 9-58
License Plate Light Bulb Replacement ............................................................9-57
Rear combination lamp bulb replacement ........................................................9-54
Side repeater lamp replacement ....................................................................... 9-54
M
Maintenance Services
........................................................................\
.................... 9-4
Owner Maintenance Precautions ........................................................................\
9-4
Owner’

s Responsibility
........................................................................\
.............. 9-4