Hyundai Matrix 2007 Owners Manual

1
FEATURES OF YOUR HYUNDAI
79CD AUTO CHANGER
B800A02FC-GAT (If Installed) The CD Auto Changer is located under the front passenger seat. This system can store up to 8 CDs. You may select music without chang-ing discs. First, open the CD Auto Changer door, remore the CD "maga- zine" and insert up to 8 CDs. Then,push the magazine into the CD Auto Changer. The CD may be operated with the passenger compartment au-dio system controls. HFC2105
B540A01FC-GAT
B540A02FC
TAIL GATE
LOCK UNLOCK
!WARNING:
The tail gate should always be kept completely closed while the vehicle is in motion. If it is left open or ajar,poisonous exhaust gases may en- ter the car resulting in serious ill- ness or death to the occupants. Seeadditional warnings concerning exhaust gases on page 2-2. o The tail gate can be locked or un-
locked with a key.
o The tail gate is opened by pulling the outside handle up, raising the tail gate manually.
o To close, lower the tail gate, then press down on it until it is closed. Tobe sure the tail gate is fully closed,always try to pull it up again without using the outside handle.

1FEATURES OF YOUR HYUNDAI
80
!
CAUTION:
To prevent damage to the goods or the vehicle, care should be taken when carrying fragile or bulky ob- jects in the luggage compartment.
WARNING:
Avoid eye injury. DO NOT overstretch the luggage net. ALWAYS keep your face and body out of its recoil path.DO NOT use when the strap has visible signs of wear or damage.!
LUGGAGE NET
B540D03FC-GAT (If Installed) Some objects can be kept in the net in the luggage compartment. Use the luggage net on the floor or atthe back of the luggage compartment to prevent objects from sliding. B540D01HP
WARNING:
Never attempt to change CDs the already inserted in the CD changer magazine while the vehicle is mov-ing. This could result in loss of control or an accident that may cause death, serious insury, orproperty damage.!

1
FEATURES OF YOUR HYUNDAI
81ROOF RACK
B630A03FC-GAT (If installed) If your Hyundai has a roof rack, you can load things on top of your vehicle. Crossrails and fixing components to adapt the roof rack on your vehiclemay be obtained from an authorized Hyundai dealer.
CAUTION:
o The following specifications are recommended when loadingcargo or luggage. o Loading cargo or luggage above
34 kg (75 lb) on the roof rack may damage your vehicle. When you carry large objects, never let them hang over the rearor the sides of your vehicle.
o To prevent damage or loss of
cargo as you are driving, checkfrequently to make sure the lug- gage carrier and cargo are still securely fastened.
o Always drive your vehicle at a moderate speed.
o To use the roof rails as a roof
rack, you must fit the roof rails with two or more crossrails or equivalent before carrying cargoor lugguage on the roof.
o When crossrail is adapted, you
can load things on the roof rack.
o Loading cargo or luggage over specification on the roof rack maydamage stability of your vehicle.
o In case the sunroof is equipped, do not position roof rack loadsthat could interfere with openingof the sunroof.
HFC2106
!
34 kg (75 lb)
EVENLY DISTRIBUTED
ROOF RACK
CARGO AREA COVER
B650A01FC-GAT (If installed) Nothing should be carried on top of the luggage cover. Loose materials couldresult in injury to vehicle occupants during sudden braking. B640A02FC

1FEATURES OF YOUR HYUNDAI
82HORN
!
STEERING WHEEL TILT LEVER
B600A01A-AAT (If Installed) To Adjust the Steering Wheel:
1. Push the lever downward to unlock.
2. Raise or lower the steering wheel to
the desired position.
3. After adjustment, securely tighten the lever by pulling it upward. HFC2041
WARNING:
Do not attempt to adjust the steer-ing wheel while driving as this may result in loss of control of the ve-hicle which may cause serious in- jury or death. B610B01A-GAT
Press the center hub of the steering wheel to sound the horn. B610B01FCAUTO FUEL CUT SWITCH
!
B560B01O-GAT (Gasoline Engine) The auto fuel cut switch is located on the driver's side of the engine compart- ment. In the event of a collision or suddenimpact, the auto fuel cut device cuts off the fuel supply. If this device is acti- vated, it must be reset by pressing inon the top of the switch before the engine can be restarted.
WARNING:
Before resetting the auto fuel cutswitch, the fuel line should be checked for fuel leaks. HFC4001
HFC2099
With Airbag
Without Airbag

1
FEATURES OF YOUR HYUNDAI
83
1
FEATURES OF YOUR HYUNDAI
83HEATING AND COOLING CONTROL
B710A01Y-GAT (If installed)
HFC002B710B01A-AATCENTER VENTILATOR The center ventilators are located in the middle of the dashboard.To change the direction of the air flow, turn the control knob on the middle of the ventilator as desired.
1. Side Defrost Nozzle
2. Side Ventilator
3. Windshield Defrost Nozzle
4. Center Ventilator B710C01FC-AAT SIDE VENTILATOR The side ventilators are located on each side of the dashboard. To changethe direction of the air flow, move the knob in the center of the vent. The vents are opened when the vent knob is
moved to " " position. The vents are
closed when the vent knob is moved to
" ". Keep these vents clear of anyobstructions.

1FEATURES OF YOUR HYUNDAI
84
B670A01FC-GAT Rotary type (If installed) This model has four controls for the heating and cooling system. They are:
1. Temperature control
2. Fan speed control
3. Air flow control
4. Air intake control HFC2064
HEATING AND VENTILATION
1
2
3
4 B670B01FC-AAT Fan Speed Control (Blower Control) This is used to turn the blower fan on or off and to select the fan speed. This blower fan speed, and therefore the volume of air delivered from thesystem, may be controlled manually by setting the blower control between the "1" and "4" positions."1" is lowest and "4" is the highest fan speed.
HFC2065
B670E01A-AAT Temperature Control This control is used to adjust the degree of heating or cooling desired.
HFC2066
Cool
Warm

1
FEATURES OF YOUR HYUNDAI
85
1
FEATURES OF YOUR HYUNDAI
85
HFC2068
B670D05A-AAT Air Flow Control
This is used to direct the flow of air. Air can be directed to the floor, dashboard outlets, or windshield. Five symbols are used to represent Face, Bi-Level,Floor, Floor-Defrost and Defrost air po- sition.Face-Level
Selecting the "Face" mode will cause air to be discharged through the face level vents. HFC2046
HFC2047
Bi-Level
Air is discharged through the face vents and the floor vents. This makes it pos- sible to have cooler air from the dash- board vents and warmer air from thefloor outlets at the same time.

1FEATURES OF YOUR HYUNDAI
86
HFC2050HFC2048
HFC2049
Floor-Level
Air is discharged through the floor vents. Floor-Defrost Level
Air is discharged through the side de- frost nozzle windshield defrost vents and the floor vents. If the "Floor-Defrost" mode is selected,the A/C will be turn automatically and it will be changed to "Fresh" mode will be activated. Defrost-Level
Air is discharged through the sidedefrost nozzle, windshield defrost vents. If the "Defrost" mode is selected, theA/C will turn on automatically and "Fresh" mode will be activated to im- prove windshield defrosting.

1
FEATURES OF YOUR HYUNDAI
87
1
FEATURES OF YOUR HYUNDAI
87HEATING CONTROLS
B690A02S-AAT
B670C03FC-GAT Air Intake Control With the "Fresh" mode selected, air enters the vehicle from the outside andis heated or cooled according to the function selected. With the "Recirculation" mode selected, air from within the passenger compart- ment will be drawn through the heatingsystem and heated or cooled according to the function selected. NOTE: It should be noted that prolonged operation of the heating in "Recircu- lation" mode will increase to fog- ging of the windshield and side win-dows and the air within the passen- ger compartment will become stale. In addition, prolonged use of the airconditioning with the "Recirculation" mode selected may result in the air within the passenger compartmentbecoming excessively dry.
This is used to select fresh outside airor recirculating inside air. To change the air intake control mode, (Fresh mode, Recirculation mode) pushthe control button. FRESH MODE
( ) :
The indicator light on the button goes off when the air intake control is in fresh mode. RECIRCULATION MODE ( ):
The indicator light on the button is illuminated when the air intake control is in recirculation mode. HFC2067
For normal heating operation, set the air intake control to the "Fresh" position and the air flow control to "Floor". For faster heating, the air intake control should be in the "Recirculation" posi-tion. If the windows fog up, move the air flow control to the "Def" (defroster) position. (The A/C will turn on automatically and "Fresh" mode will be activated.) For maximum heat, rotate the tempera- ture control to "Warm".
B690A02FC

1FEATURES OF YOUR HYUNDAI
88VENTILATIONDEFROSTING/DEFOGGINGBI-LEVEL HEATING
B700A01S-AAT Your Hyundai is equipped with bi-level heating controls. This makes it pos- sible to have cooler air from the dash-board vents and warmer air from the floor outlets at the same time. To use this feature:
o Set the air intake control to the "Fresh" mode ( ).
o Set the air flow control at the "Bi- Level" position.
o Adjust the fan speed control to the desired speed.
o Set the temperature control between
"Cool" and "Warm". B720A02FC-GAT Use the heating/ventilation system to defrost or defog the windshield: To remove interior fog on the wind- shield:
o Set the air flow control to the defrost
( ) position. (The A/C will turn on automatically and "Fresh" mode willbe activated.)
o Set the temperature control to the
desired position.
o Set the fan speed control between "1" and "4" position.
HFC2107
HFC2111
B710A01S-AAT
To operate the ventilation system:
o Set the air intake control to "Fresh"
mode ( ).
o To direct all intake air to the dash-
board vents, set the air flow control to "Face".
o Adjust the fan speed control to the
desired speed.
o Set the temperature control between "Cool" and "Warm". B710A01FC