light INFINITI G37 2012 Workshop Manual

Black plate (113,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]It is generally desirable not to turn off
the headlights for short intervals (for
example, when the vehicle stops at a
traffic signal). Even when the daytime
running lights are active (Canada only),
the xenon headlights do not turn on.
This way the life of the xenon head-
lights is not reduced.
. If the xenon headlight bulb is close to
burning out, the brightness will dras-
tically decrease, the light will start
blinking, or the color of the light will
become reddish. If one or more of the
above signs appear, contact an INFINITI
retailer. SIC3267
HEADLIGHT SWITCH GUID-33AE3B12-CA6A-4F4B-937B-B94D10FCE3CF
Lighting GUID-7A3ED0E6-B819-4CBD-BBCC-8D6AAA3D091F
* 1
Turn the switch to the position:
The front parking, side marker, tail,
license plate and instrument lights
will come on.
* 2
Turn the switch to the position:
Headlights will come on and all the
other lights remain on. SIC3268
Autolight system (if so equipped) GUID-B0C5ED39-4191-407B-8F10-92C5231D8B53
The autolight system allows the headlights
to be set so they turn on and off
automatically.
To set the autolight system:
1. Make sure the headlight switch is in the
AUTO position
* 1
.
2. Push the ignition switch to the ON
position.
3. The autolight system automatically
turns the headlights on and off.
To turn the autolight system off, turn the
switch to the OFF,
or position.
Instruments and controls
2-35

Black plate (114,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]2-36 Instruments and controlsThe autolight system can turn on the
headlights automatically when it is dark
and turn off the headlights when it is light.
If the ignition switch is pushed to the OFF
position and one of the doors is opened
and this condition is continued, the head-
lights remain on for 5 minutes.
Automatic headlights off delay: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407
You can keep the headlights on for up to
180 seconds after you push the ignition
switch to OFF and open any door then close
all the doors.
You can adjust the period of the automatic
headlights off delay from 0 seconds (OFF)
to 180 seconds. The factory default setting
is 45 seconds.
For automatic headlights off delay setting,
see “ Light Off Delay ” (P.4-19). SAA0642A
Be sure not to put anything on top of the
photo sensor
* A
located on the top of the
instrument panel. The photo sensor con-
trols the autolight; if it is covered, the
photo sensor reacts as if it is dark and the
headlights will illuminate. SIC3269
Headlight beam select GUID-1105ED2E-9741-4EAA-A5D8-36C19A0F048D
* 1
To select the low beam, put the lever
in the neutral position as shown.
* 2
To select the high beam, push the
lever forward while the switch is in the
position. Pull it back to select the
low beam.
* 3
Pulling the lever toward you will flash
the headlight high beam even when
the headlight switch is in the OFF
position.

Black plate (115,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]Battery saver system GUID-015F3DAF-8A59-4727-BB76-C11FB41B2B60
A chime will sound when the driver side
door is opened with the light switch in the
or position and the ignition switch
in the ACC, OFF or LOCK position.
When the headlight switch is in the
or
position while the ignition switch is in
the ON position, the lights will automati-
cally turn off 5 minutes after the ignition
switch has been pushed to the OFF
position.
When the headlight switch remains in the
or position after the lights
automatically turn off, the lights will turn
on when the ignition switch is pushed to
the ON position.
CAUTION. When you turn on the headlight switch
again after the lights automatically turn
off, the lights will not turn off auto-
matically. Be sure to turn the light
switch to the OFF position when you
leave the vehicle for extended periods of
time, otherwise the battery will be
discharged. . Never leave the light switch on when the
engine is not running for extended
periods of time even if the headlights
turn off automatically.
Daytime running light system (Ca-
nada only) GUID-84A2F990-744E-4ADE-B431-E99613FFC97F
The daytime running lights automatically
illuminate when the engine is started with
the parking brake released. The daytime
running lights operate with the headlight
switch in the OFF position or in the
position. Turn the headlight switch to the
position when driving at night.
If the parking brake is applied before the
engine is started, the daytime running
lights do not illuminate. The daytime
running lights illuminate once the parking
brake is released. The daytime running
lights will remain on until the ignition
switch is pushed to the OFF position. SIC3257
Instruments and controls
2-37

Black plate (116,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]2-38 Instruments and controls SIC3270Instrument brightness control GUID-CB95F8CC-B487-4989-8E61-0C52D48B3633
The instrument brightness control switch
can be operated when the ignition switch
is in the ON position. When the switch is
operated, the dot matrix liquid crystal
display switches to the brightness adjust-
ment mode.
Push the upper switch
* A
to brighten the
instrument panel lights. The bar
* 1
moves
to the + side. When reaching the maximum
brightness, “ MAX ” appears on the display
* 2
.
Push the lower switch
* B
to dim the
instrument panel lights. The bar
* 1
moves
to the − side. When reaching the minimum
brightness, “ MIN ” appears on the display
* 3
. However, “ MIN ” does not appear
during the nighttime.
The dot matrix liquid crystal display
returns to the normal display under the
following conditions:
. when the instrument brightness control
switch is not operated for more than 5
seconds.
. when the side or front of the
switch
or
switch on the right side of the
combination meter panel is pushed. SIC3271
TURN SIGNAL SWITCH GUID-8B2C7C5B-C4F7-454D-AF37-BDA58A9D5766
* 1
Turn signal GUID-130C353A-4100-44B3-BC20-735826AC072D
Move the lever up or down to signal the
turning direction. When the turn is com-
pleted, the turn signals cancel automati-
cally.
* 2
Lane change signal GUID-4CB70D1F-17E6-4D5C-8884-15EA840D0327
To indicate a lane change, move the lever
up or down to the point where lights begin
flashing.

Black plate (117,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]SIC3272
FOG LIGHT SWITCH GUID-782C350F-DF92-4D39-BD90-4155E2E5F990
To turn the fog lights on, turn the headlight
switch to the
position, then turn the
switch to the
position. To turn them
off, turn the switch to the OFF position.
The headlights must be on for the fog
lights to operate. GUID-6A8C64A7-6F2F-477B-8944-B7474460FBD5
SIC2574
Push the switch on to warn other drivers
when you must stop or park under
emergency conditions. All turn signal lights
will flash.
WARNING . If stopping for an emergency, be sure to
move the vehicle well off the road.
. Do not use the hazard warning flashers
while moving on the highway unless
unusual circumstances force you to drive
so slowly that your vehicle might be-
come a hazard to other traffic. . Turn signals do not work when the
hazard warning flasher lights are on.
The flasher can be actuated with the
ignition switch in any position.
Some state laws may prohibit the use of
the hazard warning flasher switch while
driving.
Instruments and controls
2-39HAZARD WARNING FLASHER SWITCH

Black plate (119,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]SSS0911
The front seats are warmed by built-in
heaters. The switches located on the center
console can be operated independently of
each other.
1. Start the engine.
2. Turn the control knob
* A
to the right
* 1
and select the desired heat range. .
For high heat, turn the knob to the
right
* 1
..
For low heat, turn the knob to the left
* 2
. .
The indicator light
* B
will illuminate
when the heater is on.
3. To turn off the heater, return the knob to the OFF position
* 3
. Make sure that
the indicator light turns off.
The heater is controlled by a thermis-
tor, automatically turning the heater on
and off. The indicator light will remain
on as long as the switch is on.
When the vehicle ’ s interior is warmed,
or before you leave the vehicle, be sure
to turn off the switch. GUID-EF41F86E-C62C-4AF4-8DCA-50E40AEADC52
SIC3602
For driving or starting the vehicle on snowy
roads or slippery areas, turn on the SNOW
mode switch. The indicator light
* 1
on the
switch will illuminate. When the SNOW
mode is activated, engine output is con-
trolled to avoid wheel spin.
Instruments and controls
2-41SNOW MODE SWITCH (if so equipped)

Black plate (121,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]GUID-B26334D9-D8B8-436D-BBEA-461C2F9C02D3
JVI0329X
Automatic transmission models
SIC4684
Manual transmission models SIC4316
Automatic transmission models
The power outlet is located in the center
console and storage box (if so equipped).
CAUTION . The outlet and plug may be hot during or
immediately after use.
. Do not use with accessories that exceed
a 12 volt, 120W (10A) power draw. Do
not use double adapters or more than
one electrical accessory.
. Use power outlet with the engine run-
ning to avoid discharging the vehicle
battery. . Avoid using power outlet when the air
conditioner, headlights or rear window
defroster is on.
. This power outlet is not designed for use
with a cigarette lighter unit.
. Push the plug in as far as it will go. If
good contact is not made, the plug may
overheat or the internal temperature
fuse may blow.
. Before inserting or disconnecting a plug,
be sure the electrical accessory being
used is turned OFF.
. When not in use, be sure to close the
cap. Do not allow water to contact the
outlet.
Instruments and controls
2-43POWER OUTLET

Black plate (122,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]2-44 Instruments and controls GUID-DE8DDBA2-893D-409D-9154-63B79271B874
SIC3219
FRONT GUID-1791CA11-E504-4F56-A33F-1E5AD0535DB5
To open the ashtray lid, push the lid down
and release it
* 1
.
To empty the ashtray, pull out
* 2
.
The cigarette lighter operates when the
ignition switch is in the ON position.
Push the lighter in all the way
* 3
, then
release it. When the lighter is heated, it will
spring out. Return the lighter to its original
position after use. CAUTION . The cigarette lighter socket is a power
source for the cigarette lighter element
only. The use of the cigarette lighter
socket as a power source for any other
accessory is not recommended.
. Do not use any other power outlet for an
accessory lighter. SIC2570
Manual transmission models
REAR GUID-74AD3966-EF58-4E69-95A0-EB5B5A1AE1ED
To open the ashtray, pull the lid down
* 1
.
To empty the ashtray, push down
* 2
, and
pull out.CIGARETTE LIGHTER AND ASHTRAYS (if so
equipped)

Black plate (125,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]SIC3246
SUNGLASSES HOLDER GUID-0DE963FA-CB20-4597-A160-D7A44C1C2021
WARNINGKeep the sunglasses holder closed while
driving to prevent an accident.
To open the sunglasses holder, push
* 1
.
CAUTION. Do not use for anything other than
glasses. . Do not leave glasses in the sunglasses
holder while parking in direct sunlight.
The heat may damage the glasses.
SIC3469
GLOVE BOX GUID-B206543D-B260-4DF3-8E5F-F80BDAA8D4C5
WARNING Keep glove box lid closed while driving to
help prevent injury in an accident or a
sudden stop.
To open the glove box, pull the handle
* 1
.
To close, push the lid in until the lock
latches.
To lock
* 2
/unlock
* 3
the glove box, use
the mechanical key. For the mechanical key
usage, see “ Keys ” (P.3-2).
Instruments and controls
2-47

Black plate (128,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]2-50 Instruments and controls SIC4308
STORAGE BOX (if so equipped) GUID-CFA98C55-37DD-4612-A252-9BB5CFC5B9F1
To open, push the storage box lid
* 1
as
illustrated.
Do not place valuable items in the storage
box.
Do not use the storage box as an ashtray. SIC3248
Sedan
COAT HOOKS GUID-B805A19F-9712-424B-857B-8FED14115CE3
Sedan GUID-96817661-72E6-4213-9894-244280FDE3C2
The coat hooks are equipped beside the
rear personal lights.
CAUTION Do not place items which are more than 2 lb
(1 kg) on the hook. SIC3544
Coupe
Coupe GUID-CDE6DCDD-9D25-4089-9D89-9ACDDE762882
To use the coat hook, push the hook
* A
to
release.
CAUTION Avoid hanging heavy goods on the hook.